Summary of the content on the page No. 1
- :
2 30
1 of 14
Model iP40
FM Alarm Clock Radio
for iPhone or iPod
1:03
Questions? Visit www.ihomeaudio.com
10:09 PM
Keith LuBrant
All I Want To Be
A face in the crowd
Summary of the content on the page No. 2
Table of Contents Table of Contents iP40 Quick Start 1 Controls and Indicators 2 iP40 Display 3 Getting Started 3 Install Clock Backup Battery 4 Setting Up the iP40 4-5 Using the Alarm 5 Charging your iPhone/Pod 6 Listening to iPhone/iPod 6 Listening to Radio 6 Aux Jack 7 Sleep Operation 7 Using the iP40 in Other Countries 7 Dimmer Operation 7 A Consumer Guide to Product Safety 8 Trouble Shooting 9 Warranty Information 10 Maintenance • Place the unit on a level surface away from sources of dire
Summary of the content on the page No. 3
FCC Information This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential are
Summary of the content on the page No. 4
iP40 Quick Start 1:power 2:inserts 3:iPod/iPhone RESET TEST Attach AC adaptor cable to jack on Select the dock insert for your Insert iPhone or iPod into dock with back of the iP40 and plug the other iPhone/iPod model from the table proper insert (iPhone/iPod must not end into a wall socket. below and place insert in dock. be in a skin or case). iPhone/iPod Never dock an iPhone or iPod will charge while docked. Press Play without an insert in place. Button on iP40 to play iPhone/iPod. iPod to
Summary of the content on the page No. 5
Controls and Indicators Top Panel iPod / iPhone Dock Reverse Button Forward Button Play/Pause Button Radio/Aux Button Power On/Off/ Alarm Button Alarm Reset Button radio / aux. alm. reset Volume Up Button snooze / dimmer Snooze/Dimmer Button Volume Down Button Back Panel AUX. in Jack EXB Button Sleep Button Time Sync/Set DST Switch Button DC Jack FM Antenna 2
Summary of the content on the page No. 6
iP40 Display PM Indicator Time Display Buzzer Indicator Wake-to Indicator Radio Indicator Alarm Indicator iPhone/iPod Indicator Aux Indicator Battery Low Indicator Sleep Indicator EXB Indicator Getting Started Thank you for purchasing the iP40. Designed specifically to work with your iPhone and iPod, this system provides high quality audio performance that brings out the best in your music and lets you wake or sleep to it. Please read this instruction carefully before the appliance is operate
Summary of the content on the page No. 7
Installing/Replacing the Clock Backup Battery The iP40 requires a CR2032 lithium battery (included) to provide backup power to the clock in the event of a temporary power interruption. The CR2032 backup battery was packed in the same poly bag with this instruction manual. 1. Place the clock radio face down on a flat surface. 2. Slide the battery door in the direction of the arrow and then lift the door by the opposite edge to remove it from the radio. 3. Install the CR2032 backup b
Summary of the content on the page No. 8
Setting Up the iP40 Setting Time 1. Press and hold the Time Sync/Set Button located at the back of the unit for 2 seconds until the time display flashes. Press the << or >> button to set the current hour (hold to advance rapidly). 2. Remember to set the correct AM or PM. The PM Indicator is located on the upper left hand side of the time display; there is no AM indicator. 3. Press the Time Sync/Set Button again to adjust minutes. Press the << or >> button to correct time. 4. If desired,
Summary of the content on the page No. 9
Charging your iPhone/Pod Note: Please make sure you are using the correct insert for your iPhone/iPod and that it is properly docked into the iP40. Failure to do so may damage your iPhone/iPod. 1. While your iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Note that other non-docking iPods will NOT charge. Listening to iPhone/iPod 1. Dock the already playing iPhone/iPod, the iP40 will automatically turn on and you will hear the music
Summary of the content on the page No. 10
Aux Jack If you are using an iPod without a docking port or other MP3 player or other portable audio device, you can play it through the iP40 via the Aux Line-in Jack. 1. Plug one end of an audio patch cord (not included) into the headphone or line-out jack on your device and the other end of the patch cord into the iP40 Aux Line-in Jack, located on the back of the unit. 2. Press the Radio/Aux until the AUX icon appears on the lower part of the display, indicating AUX mode. 3. Turn on and
Summary of the content on the page No. 11
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to assure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use. Keep these instructions handy for future reference. Take special note, and adhere to all warnings on the unit and in the instruction and service manual. 1. Water and Moisture - The
Summary of the content on the page No. 12
Trouble Shooting Symptom Possible Problem Solution Unit does not AC adaptor isn’t plugged to a wall outlet or the Plug the AC adaptor into a wall outlet and plug the connector respond (no power) connector is not plugged into the power supply into the supply jack on the unit jack on the back of the unit Wall outlet is not functioning Plug another device into the same outlet to confirm the outlet is working. If outlet is controlled by a switch
Summary of the content on the page No. 13
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service stil
Summary of the content on the page No. 14
iP40-122109-A Printed in China
