Summary of the content on the page No. 1
Model iP23
Dual Alarm Clock
®
for iPhone and iPod
Questions? Visit www.ihomeaudio.com
Summary of the content on the page No. 2
Table of Contents Controls and Indicators ................................................................................................................................................... 1 iP23 Quick Start .............................................................................................................................................................. 2 iP23 display / Install Clock Backup Battery ...................................................................................
Summary of the content on the page No. 3
FCC Information This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area
Summary of the content on the page No. 4
Controls and Indicators Dock Top Panel Lower Volume Button Sleep Button Raise Volume Button Alarm Reset / Power Button Forward Button Alarm 1 Button Alarm 2 Button Reverse Button Play/Pause Button Snooze/Dimmer Button Rear Panel Aux Line-in Jack Time Zone Button DST Switch AC Adaptor Jack Time Sync/Set Button 1
Summary of the content on the page No. 5
iP23 Quick Start 1: power 3: iPhone/iPod 2: inserts 1: AC power RESET TEST Select the dock insert for your iPhone/iPod model from the table Insert playing iPhone/iPod into the dock Attach AC adaptor cable to jack below and place insert in dock. (must not be in a “skin” or case). Your on back of the unit and plug the To remove insert, place audio will play through the unit. Press other end into a wall socket to thumbnail in slot and gently pull volume buttons to adjust volume. play an
Summary of the content on the page No. 6
Display Sleep indicator Buzzer indicator Battery Low Indicator PM Indicator Alarm 1, Alarm 2 Indicators Time Display iPod Indicator Installing/Replacing Clock Backup Batteries The unit uses 2 AA batteries (installed) for backup to provide continuous alarm operation and clock settings in the event of a power failure. If the backup batteries have been installed and a power failure occurs or the AC adaptor is accidentally disconnected, the display backlight will not remain lit, but current time
Summary of the content on the page No. 7
Operating the Unit This unit has a PRESET Clock: the time is already preset to Eastern time at the factory. Simply match the time zone setting to where you live. 1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on the back of the unit to +1 to add an hour or to -1 to subtract an hour to/from the currently displayed time. 2. Press and hold the Time Zone Button located on the back of the unit until the current time zone fla
Summary of the content on the page No. 8
Operating the Unit Reviewing, Arming and Disarming Alarm (Turn Alarm Function On and Off) 1. Once an alarm is set, press the associated alarm button to view the currently set alarm time and to toggle the alarm on (icon) or off (no icon). 2. To arm/disarm the alarm, just press the associated alarm button to toggle it on or off. If the alarm is armed, the related alarm icon will appear on the right side of the display. Resetting the Alarm to Come on the Next Day 1. When the alarm is sounding
Summary of the content on the page No. 9
Operating the Unit Using the Aux line-in Jack If you have an audio device with standard 3.5 mm headphone jack, you can play it through the unit via the Line-in Jack located on the back of the unit. 1. Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your device and the other end of the patch cord into the Aux line-in Jack. 2. Press the Button to turn the unit on. 3. Turn on and play your device. 4. Press the Volume and Vo
Summary of the content on the page No. 10
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should n
Summary of the content on the page No. 11
Trouble Shooting Symptom Possible Problem Solution Unit doesn’t respond AC adaptor isn’t plugged to a wall outlet or Plug the AC adaptor into a wall outlet and plug the connector into (no power) the connector is not plugged into the power the power supply jack on the unit supply jack on the back of the unit Wall outlet is not functioning Plug another device into the same outlet to confirm the outlet is working iPhone/iPod cannot Using wrong insert Make sure the dock insert is the proper fit fo
Summary of the content on the page No. 12
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still
