Summary of the content on the page No. 1
883 WEIGHT HORN ATTACHMENT
WARNING:
Read and follow all directions
for each step to insure proper
assembly of this product.
USER’S GUIDE
CLASS H 1 Version: 883107
PART # 7082001 Revision: 03/20/01
REV . A
Summary of the content on the page No. 2
TABLE OF CONTENTS Safety Statement.............2 Parts list..........................4 General Notes..................3 Assembly Instructions.....4-7 Tools Required................3 General Maintenance.......8 Warranty Statement..........9 Product Services..............10 Insert-Registration Card IMPORTANT SAFETY INFORMATION THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OF EQUIPMENT. TO MINIMIZE RISK FOLLOW THESE RULES! 1. Before using, read all the warnings and instructions 6. Neve
Summary of the content on the page No. 3
IMPORTANT NOTES Please note: * Thank you for purchasing the ParaBody 883 Weight Horn Attachment. Please read these instructions thoroughly and keep them for future reference. This product must be assembled on a flat, level surface to assure its proper function. * This product must be assembled on a flat, level surface to assure its proper function. DO NOT securely tighten any frame connections until the entire frame has been assembled, unless otherwise stated. Tools Required for A
Summary of the content on the page No. 4
PARTS LIST KEY PART # DESCRIPTION QTY 1 6799601 PLA TE HOLDER 4 2 3102910 1/2 X 3” BOLT 8 3 3102502 1/2” WASHER 8 4 3102801 1/2” LOCK NUT 8 5 3119302 1-3/4” ROUND END CAP 4 UPRIGHT FRAME 9/16” CAP PLUG FIGURE 1 STEP 1: INSTALLATION SHOWN FOR 888 SMITH MACHINE. 838 SQUAT RACK INSTALLATION SHOWN ON PAGE 6 &7. • Remove and discard the eight 9/16” CAP PLUGS from the UPRIGHT FRAMES as shown in FIGURE 1. 4
Summary of the content on the page No. 5
UPRIGHT FRAME 3 4 1 2 1/2 X 3” 5 FIGURE 2 STEP 2: • Insert four 1-3/4” ROUND END CAPS (5) into the end of the four PLATE HOLDERS (1) as shown in FIGURE 2. • SECURELY assemble the four PLATE HOLDERS (1) to the UPRIGHT FRAMES as shown in FIGURE 2, using eight 1/2 X 3” BOLTS (2), eight 1/2” WASHERS (3), and eight 1/2” LOCK NUTS (4). 1/2 1/2 1/2 1/2 1/2 1/2 0 1 2 34 5 6 5
Summary of the content on the page No. 6
CROSS BRACE 1/2” LOCK NUT 1/2 X 3” BOLT 1/2” WASHER FIGURE 1 STEP 1: INSTALLATION SHOWN FOR 838 SQUAT MACHINE. 888 SMITH MACHINE INSTALLATION SHOWN ON PAGE 4 & 5. • Remove and discard the four 1/2 X 3” BOLTS, four 1/2” WASHERS, and four 1/2” LOCK NUTS from the CROSS BRACE as shown in FIGURE 1. 6
Summary of the content on the page No. 7
UPRIGHT FRAME CROSS BRACE 1 4 3 5 2 1/2 X 3” FIGURE 2 STEP 2: • Insert four 1-3/4” ROUND END CAPS (5) into the end of the four PLATE HOLDERS (1) as shown in FIGURE 2. • SECURELY assemble two PLATE HOLDERS (1) and the CROSS BRACE to the UPRIGHT FRAMES as shown in FIGURE 2, using four 1/2 X 3” BOLTS (2) and four 1/2” LOCK NUTS (4). • SECURELY assemble the two PLATE HOLDERS (1) to the UPRIGHT FRAMES as shown in FIGURE 2, using four 1/2 X 3” BOLTS (2), four 1/2” WASHERS (3), and f
Summary of the content on the page No. 8
MAINTENANCE Please note: * We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy water. Touch-up paint can be purchased from your ParaBody customer service representative at (800) 328-9714. * Inspect equipment daily. Tighten all loose connections are replace worn parts immediately. Failure to do so may result in serious injury * PLEASE RECORD THE INFORMATION REQUESTED BELOW. IN THE EVENT YOU MAY NEED SERVICE YOU WILL BE ASKED FOR THIS INFORMATION
Summary of the content on the page No. 9
LIMITED WARRANTY ParaBody extends the following LIMITED WARRANTY to the original owner of the ParaBody products. The Warranty terms apply to IN HOME USE ONLY. 1. LIMITED WARRANTY ON FRAME AND WELDS. If the frame of the ParaBody product or a weld should crack or break, it will be repaired or replaced by ParaBody. Terms: Lifetime – for so long as the Customer owns the ParaBody product. 2. LIMITED WARRANTY ON PARTS. If the following parts are defective in material or workmanship, ParaBody will
Summary of the content on the page No. 10
LIFE FITNESS 14150 Sunfish Lake Blvd. Ramsey Minnesota, 55303 U.S.A. Tel: 763.323.4500 Fax: 763.323.4797 800.328.9714 (Toll-free within the U.S. and Canada) www.parabody.com INTERNATIONAL OFFICES Life FitnessAtlantic BV Life Fitness (UK) Ltd. Atlantic Headquarters Queen Adelaide Bijdorpplein 25-31 Ely, Cambs CB7 4UB 2992 LB Barendrecht United Kingdom The Netherlands Phone CSS: (01353) 665507 Phone: (180) 646 666 Fax CSS: (01353) 666719 Fax: (180) 646 703 Life Fitness EUROPE GmbH Lif
