Summary of the content on the page No. 1
Model iH12
Dual Alarm Cube Clock
Radio For Your iPod
Questions? Visit www.ihomeaudio.com
Summary of the content on the page No. 2
Table of Contents 1 Quick Start 2 Controls and Indicators 3 iH12 Display 3 Install Clock Backup Battery 4 Using The Remote Control Unit Install/Replace the Remote Control Battery To check for iPod compatibility 5 Setting Up the iH12 Setting Time and Calendar 6 Using the Alarm 6 Charging you iPod 7 Listening to iPod 7 Listening to non-docking iPod or other portable audio devices 7 Dimme Operation 8 Listening to Radio 8 Sleep Operation 8 Click Sound Operation 8 3D Sound Operation 9 A Consumer Gu
Summary of the content on the page No. 3
Quick Start 1:power 2:inserts 3:iPod Select the dock insert for your Attach AC adaptor cable to jack on Insert iPod into dock with proper back of the iH12 and plug the other iPod model from the table below insert (iPod must not be in a skin or end into a wall socket. and place insert in dock. case). iPod will charge while docked. Never dock an iPod without Press the Play Button on the iH12 to play an insert in place. iPod. iPod Touch 3rd Gen nano thin iPod with video (30 GB) iPod with vi
Summary of the content on the page No. 4
Controls and Indicators Top panel iPod Dock << Button Alarm-1 Button Preset Button 1-4 iPod Play/Pause Button Alarm-2 Button >> Button Alarm Reset / Power On/Off Button Volume + Button Volume - Button Wake-to Button Radio/Aux Button Sleep Button Snooze/Dimmer Button Back panel Front panel Clock Adj Button AM Loop Time Zone Button Antenna Socket DST Switch Line-in JACK 2
Summary of the content on the page No. 5
iH12 Display Alarm 1 Indicator Alarm 2 Indicator Daylight Saving Time iPod Indicator Indicator Wake-to Indicator Battery Low Indicator Wake-to Radio Indicator PM Indicator Wake-to Buzzer Indicator Line in Indicator Time Display (AM, FM1 & FM2) Radio Frequency Radio band Indicator or Alarm Time Indicator Sleep Indicator (PM) Alarm Time Indicator Install Clock Backup Batteries The iH12 uses 2 alkaline “AA” batteries to provide continuous alarm operation and clock settings in the event of a power
Summary of the content on the page No. 6
Using The Remote Control Unit iPod Play/Pause Button Alarm Reset/ Power On/Off Button >> Button << Button Volume + Button Volume - Button Preset Button Radio/Aux Button 3D Button Snooze/Dimmer Button Install/Replace the Remote Control Battery The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time to replace the battery with a new one. 1. The battery door is located on the back end of the remote c
Summary of the content on the page No. 7
Setting Up the iH12 This unit is a PRESET Clock/Radio: the clock is preset for the correct Eastern Standard Time at the factory. Please follow the steps below to match settings to your location. 1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on the back of the unit to +1 to add 1 hour or to -1 to subtract 1 hour. When set to +1 a DST icon will appear on the display, indicating DST mode. 2. Press and hold the Time Zone Butto
Summary of the content on the page No. 8
Using the Alarms Setting the Alarms 1. Press and hold the Alarm-1 or Alarm-2 Button until the alarm time blinks in the lower part of the display. Press the << or >> Button to set the alarm time. Holding the button for a few seconds will advance or reverse rapidly. Remember to set the correct AM or PM time. 2. Press the Wake-to Button to select iPod, Radio or Buzzer alarm source. You can set different alarm sources for each alarm. 3. Press the Alarm Button again or wait for 10 seconds. Alarm
Summary of the content on the page No. 9
Listening to iPod 1. Dock the already playing iPod. The iH12 will automatically turn on and you will hear the music playing from your iPod. Note: If the playing song/music loudness is too low on the iPod itself, iH12 may not detect iPod is in play mode. Press the Play/Pause Button on main unit or remote control twice to play it. 2. When the iPod is docked and in standby mode, press the Play/Pause Button on the iH12 or on the remote control to play it. The iPod Icon will appear on the display,
Summary of the content on the page No. 10
Listening to Radio Setting up Antenna 1. Plug the AM antenna cable into the AM Loop Antenna Socket on the back of unit. Move antenna 12” away from unit for best reception. 2. Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas. Tuning and Playing the Radio 1. Press the Radio Button to select radio play mode. Press as needed to select AM, FM1 or FM2 radio band. 2. Press << or >> Button to tune radio to a desired station. 3. To memorize the current st
Summary of the content on the page No. 11
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should n
Summary of the content on the page No. 12
Trouble Shooting Symptom Possible Problem Solution Unit doesn’t respond AC adaptor isn’t plugged to a wall outlet or Plug the AC adaptor into a wall outlet and plug the connector into (no power) the connector is not plugged into the power the power supply jack on the unit supply jack on the back of the unit Wall outlet is not functioning Plug another device into the same outlet to confirm the outlet is working iPod cannot dock Using no or wrong iPod insert Make sure the dock insert is the prop
Summary of the content on the page No. 13
Solución De Problemas Síntoma Posible Problema Solución La unidad no El adaptador de AC no está conectado al Conecte el adaptador de AC al tomacorriente y también funciona (no circula tomacorriente o el conector no está conectado conecte el conector a la ficha en la parte posterior de la unidad corriente eléctrica) a la ficha en la parte posterior de la unidad El tomacorriente no funciona Coloque otro aparato en ese mismo tomacorriente para confirmar si el que no funciona es el tomacorriente
Summary of the content on the page No. 14
Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service stil
