Human Touch HT-275 user manual

Summary of the content on the page No. 1

April 25, 2012
REPLACING THE SEAT CUSHION
HT-270 / HT-275
®
It is imperative that Human Touch products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair SERVICE LEVEL: 3
instructions. Failure to adhere to these instructions voids the product warra

Summary of the content on the page No. 2

6. Carefully remove the right-hand armrest from the chair. 7. Place a box or other sturdy object underneath the footrest, to hold it in place (Fig.5). 8. Locate the footrest actuator underneath the footrest, then use a flat-head screwdriver to remove the “C” clip and pin that secures the front end of the actuator to the footrest (Fig.6). 9. Repeat steps 3 – 5 to remove the left-hand armrest. 10. Reach underneath the front of the seat cushion, then pull down and forward on the front flap to de

Summary of the content on the page No. 3

INSTALLING THE NEW SEAT CUSHION 1. Place the seat cushion into position on the chair. 2. From the front of the chair, slide the armrest backward into place. The tab on the bottom of the armrest slides into a slot on the chair. 3. Replace the screw on the underside of the armrest. 4. Align the left-hand armrest bolt hole with the corresponding hole in the chair frame, then replace the bolt to secure it. 5. Press the side panel into place. 6. Align the front end of the footrest actuator with