Human Touch HT-135 user manual

Summary of the content on the page No. 1

July 30, 2013
REPLACING THE BACKREST COVER
HT-135
®
It is imperative that Human Touch products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
SERVICE LEVEL: 2
instructions. Failure to adhere to these instructions voids the product warranty and

Summary of the content on the page No. 2

6. Tip the backrest cover backward then lay it carefully down on the floor behind the chair. 7. Disconnect the connector at the base of the backrest (Fig.4). 8. Using a Phillips-head screwdriver, disconnect the green-and-yellow ground wire from the chair frame (Fig.4). 9. Remove the backrest cover. Disconnect the green-and-yellow ground wire Connector Backrest cover (Fig.4) 2

Summary of the content on the page No. 3

INSTALLING THE NEW BACKREST COVER 1. Place the new backrest cover on the floor behind the chair. 2. Connect the large connector. 3. Align the end of the yellow-and-green ground wire with the corresponding hole in the chair frame, then replace the screw to secure it. 4. Thread the remote control cables from the backrest through the backrest cover, so that they are accessible after the backrest cover is installed. 5. Place the backrest cover into position, aligning the four screw holes. 6. Us