Summary of the content on the page No. 1
AJ3231
Clock Radio
Register your product and get support at
www.philips.com/welcome
User manual
Summary of the content on the page No. 2
& ^ % @ # ! 0 4 9 3 7 2 8 $ 1 6 5
Summary of the content on the page No. 3
Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type. 3 Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug
Summary of the content on the page No. 4
English Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS 1 ALARM 1, ALARM 2 – RADIO activates the radio for alarm 1 or alarm 2 – BUZ activates the buzzer for alarm 1 or alarm 2 – OFF switches off the alarm 1 or alarm 2 2 Clock control - SET TIME : sets the clock time - CLOCK: to run on clock time - SET AL 1: sets the alarm time for alarm 1 - SET AL 2: sets the alarm time for
Summary of the content on the page No. 5
INSTALLATION POWER SUPPLY 1 Check if the mains supply, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service centre. 2 Connect the mains lead to the wall socket. 3 To disconnect the set from the mains supply completely, remove the plug from the wall socket. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interrup
Summary of the content on the page No. 6
RADIO You can use this set solely as a radio! 1 Adjust RADIO ON/OFF to ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO ON/OFF to OFF to switch off the radio. To improve reception: FM: extend and position the pigtail for optimum reception. MW: uses a built-in aerial inside the set. Direct the aerial by adjusting the position of your set. SETTING THE
Summary of the content on the page No. 7
SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM RESET during the alarm call. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes
Summary of the content on the page No. 8
IMPORTANT! 1 During SLEEP activation, if you attempt to cancel SLEEP by pressing RADIO ON/OFF, the radio cannot be switched off. 2 To switch off, press RADIO ON/OFF and REPEAT ALARM (SLEEP OFF) alternate- ly and repeatedly. CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ3231’s speakers. 1 Adjust the BAND (MW/FM/AUX) control to select AUX. 2 Connect the AUX-IN cable of the set to an AUDIO OUT or headphone jack on an external device (suc
Summary of the content on the page No. 9
SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio. This will prevent any danger o
Summary of the content on the page No. 10
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjust the volume Occasional crackling sound du
Summary of the content on the page No. 11
ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a special- ized company. Please observe local regulations on the disposal of packing materi- als and old equipment. Disposal of your old product Your product is designed and manufactured with high quality materials and com- ponents, which can be recycled and reused. When this crossed-out wheeled b
Summary of the content on the page No. 12
English Meet Philips at the Internet http://www.philips.com © 2010 Koninklijke Philips Electronics N.V. All rights reserved. AJ3231_05_UM_V5.0
