Summary of the content on the page No. 16
HOW TO CONNECT YOUR PORTABLE STEREO HOW TO CONNECT YOUR HOME STEREO Note: If your stereo has an RCA-type AUDIO OUT Note: If your stereo has an unused LINE OUT jack, jack, see instruction A below. If your stereo has a see instruction A below. If the LINE OUT jack is 1/8” LINE OUT jack, see instruction B. If your being used, see instruction B. stereo has only a PHONES jack, see instruction C. A. Plug one end of a 1/8” to RCA stereo audio cable A. Plug one end of a 1/8” to RCA stereo audio cable (a
Summary of the content on the page No. 17
HOW TO CONNECT YOUR COMPUTER HOW TO CONNECT YOUR VCR Note: If your computer has a 1/8” LINE OUT jack, Note: If your VCR has an unused AUDIO OUT jack, see instruction A. If your computer has only a see instruction A below. If the AUDIO OUT jack is PHONES jack, see instruction B. being used, see instruction B. If you have a TV with a built-in VCR, see instruction B. If your VCR A. Plug one end of a 1/8” to 1/8” stereo audio cable is connected to your home stereo, see HOW TO (available at electroni
Summary of the content on the page No. 18
Press the play button on your CD player or HOW TO USE IFIT.COM CD AND VIDEO 4 VCR. PROGRAMS A moment after the play button is pressed, your personal trainer will begin guiding you through To use iFIT.com CD’s or videocassettes, the elliptical your workout. Simply follow your personal trainer’s crosstrainer must be connected to your portable CD instructions. player, portable stereo, home stereo, computer with CD player, or VCR. See HOW TO CONNECT YOUR The program will function in almost the same
Summary of the content on the page No. 19
Start your Web browser, if necessary, and go HOW TO USE PROGRAMS DIRECTLY FROM 4 to our Web site at www.iFIT.com. OUR WEB SITE Follow the desired links on our Web site to 5 select a program. Our Web site at www.iFIT.com allows you to play iFIT.com audio and video programs directly from the Read and follow the on-line instructions for using internet. To use programs from our Web site, the ellip- a program. tical crosstrainer must be connected to your home computer. See HOW TO CONNECT YOU
Summary of the content on the page No. 20
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical crosstrainer Next, remove the four Screws (51) from the right regularly. Replace any worn parts immediately. Pedal Disc (15), and slide the Pedal Disc off. Remove all Screws (52, 64) from the Right Side Shield (4) and To clean the elliptical crosstrainer, use a damp cloth the two Bolts (75) from beneath the Pedal Disc, and and a small amount of mild dish soap. Important: remove the Right Side Shield (4). Remove all
Summary of the content on the page No. 1
Model No. HRE59020 USER’S MANUAL
Serial No.
Serial
Number
Decal
QUESTIONS?
If you have questions, or if there
are missing parts, we will guar-
antee complete satisfaction
through direct assistance from
our factory.
TO AVOID DELAYS, PLEASE
CALL DIRECT TO OUR TOLL-
FREE CUSTOMER HOT LINE.
The trained technicians on our
customer hot line will provide
immediate assistance, free of
charge to you.
CUSTOMER HOT LINE:
1-800-999-3756
Mon.–Fri., 6 a.m.–6 p.m. MST
CAUTION
Visit our website at
Read all p
Summary of the content on the page No. 2
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 HOW TO USE THE ELLIPTICAL
Summary of the content on the page No. 3
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read the following important precau- tions before using the elliptical crosstrainer. 1. Read all instructions in this manual before 8. Always hold the handgrip pulse sensor or the using the elliptical crosstrainer. handlebars when mounting, dismounting, or using the elliptical crosstrainer. 2. It is the responsibility of the owner to ensure that all users of the elliptical crosstrainer 9. The pulse sensor is not a medical devic
Summary of the content on the page No. 4
BEFORE YOU BEGIN ® Congratulations for selecting the new HealthRider questions after reading this manual, call our Customer C840E elliptical crosstrainer. The C840E elliptical Service Department toll-free at 1-800-999-3756, crosstrainer is an incredibly smooth exerciser that Monday through Friday, 6 a.m. until 6 p.m. Mountain moves your feet in a natural elliptical path, minimizing Time (excluding holidays). To help us assist you, the impact on your knees and ankles. And the unique please note t
Summary of the content on the page No. 5
ASSEMBLY Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a phillips screwdriver , an adjustable wrench , and a rubber mallet . As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts us
Summary of the content on the page No. 6
2. While another person lifts the back of the Frame (1), 2 attach the Rear Stabilizer (9) to the Frame with two 33 M10 x 75mm Carriage Bolts (34) and two M10 Nylon 9 Locknuts (33). 33 1 34 3. While another person holds the Upright (2) in the posi- 3 tion shown, connect the Extension Wire Harness (44) Make sure the 44 Wire Harnesses to the Wire Harness (28). Carefully pull the upper 73 (44, 28) do not end of the Extension Wire Harness to remove any get pinched and slack. While holding the upper
Summary of the content on the page No. 7
6. While another person holds the Console (23) in the 6 position shown, connect the wire harness on the Bookrack Console to the Extension Wire Harness (44). Insert the excess wire harness into the Upright Extension (73). 23 Attach the Console (23) to the Upright Extension (73) with three M10 x 27mm Button Screws (67) and three Wire Harness M10 Split Washers (59). Be careful to avoid pinch- 44 67 ing the wire harnesses. 67 59 59 Snap the bookrack onto the Console (23) in the indi- cated location.
Summary of the content on the page No. 8
9. Apply a small amount of grease to the axle on the left 9 Disc Crossbar (16). Slide the Left Pedal Leg (11) onto the axle. Slide an M10 Bracket Washer (35) onto an M10 x 27mm Patch Screw (40), and tighten the Patch Screw into the axle. Grease Attach the Right Pedal Leg (not shown) to the right side of the elliptical crosstrainer in the same way. 16 11 35 40 10.Position a Cushion (70) in one of the adjustment holes 10 in the Left Pedal Leg (11). Set the Left Pedal Arm (12) on the Cushion, with
Summary of the content on the page No. 9
HOW TO USE THE ELLIPTICAL CROSSTRAINER HOW TO ADJUST THE PEDALS AND THE UPRIGHT HOW TO EXERCISE ON THE ELLIPTICAL CROSSTRAINER The motion of the elliptical crosstrainer is determined by the positions of the pedals and the upright. Follow To mount the the instructions below to adjust the motion of the ellip- elliptical cross- tical crosstrainer. trainer, hold the Pulse pulse sensor Sensor To adjust the and step onto pedals, first the pedal that Upright remove the pedal Upright is in the lowest Pe
Summary of the content on the page No. 10
A B C D E F G K H J I FEATURES OF THE CONSOLE cable (available at electronics stores), you can connect the elliptical crosstrainer to your home stereo, portable The advanced console offers a selection of features stereo, or computer and play special iFIT.com CD pro- designed to make your workouts more enjoyable and grams (CD’s are available separately). IFIT.com CD effective. When the manual mode of the console is programs automatically control the resistance of the selected, the resistance of t
Summary of the content on the page No. 11
CONSOLE DESCRIPTION is currently shown. Note: When the distance is shown, the word Miles or the letters Kms will Refer to the drawing on page 10. Note: If there is a appear; when your speed is shown, the letters MPH thin sheet of clear plastic on the face of the con- or Km/H will appear. sole, remove it. F. Pace bar graphs—When the manual mode is A. Exercise feedback display—This display features selected, only the left bar graph will appear. This seven modes that give you instant exercise feed
Summary of the content on the page No. 12
time the resistance level changes, the console HOW TO USE THE MANUAL MODE will show the resistance level for six seconds. In addition, when a Smart program or a Heart Rate program is selected, the display will show the Turn on the console. time remaining in the program instead of the 1 elapsed time. Note: The console requires four “D” batteries (not included). If you have not installed batteries, refer In addition, the left bar graph will appear in the dis- to step 5 on page 5 and install batte
Summary of the content on the page No. 13
The pace set- HOW TO USE A SMART PROGRAM tings for the pro- gram will be shown by the Turn on the console. right bar graph in 1 Increase Arrow the display. (The Refer to step 1 on page 12. left bar graph will show your actual Select one of the six Smart programs. exercise pace.) As the right bar graph changes 2 during the program, simply increase or decrease Each time the your pace so that the same number of bars console is turned appear on both bar graphs. If your pace is slower on, the manual
Summary of the content on the page No. 14
Hold the handgrip pulse sensor . HOW TO USE A HEART RATE PROGRAM 4 When using a Heart Rate program, you must use the handgrip pulse sensor. It is not necessary to Each Heart Rate program helps you to keep your hold the handgrips continuously during the pro- heart rate near a certain percentage of your maximum gram. However, you should hold the handgrips heart rate during your workout. (Your maximum heart frequently for the program to operate properly. rate is estimated by subtracting your age fr
Summary of the content on the page No. 15
bars appear on both bar graphs. If your pace is HOW TO CONNECT YOUR CD PLAYER, VCR, slower than the current pace setting, the OR COMPUTER increase arrow will appear in the display; if your pace is faster than the pace setting, the decrease arrow will appear. Important: The To use iFIT.com CD’s, the elliptical crosstrainer must pace settings for the program are intended be connected to your portable CD player, portable only to provide a goal. Your actual pace may stereo, home stereo, or computer
