Havis-Shields Interior Window Guards F4 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS WGI-F1, F2, F3, F4
INTERIOR WINDOW GUARDS
FOR 1994 – 2008 FORD WINDOW VANS


TOOLS REQUIRED:
Power Drill Ratcheting Wrench
1/8” Drill Bit T-50 Torx Bit (for seat belts)
Phillips Screw Driver Plastic Cutting Tool (utility knife or tin snips)
Metric Socket set


HARDWARE:
QTY DESCRIPTION PART#
115 #10 x ½” Sheet metal screws GSM34185
30 #10 X 1 ¼” Sheet metal screws GSM33197
24 #10 Flat Washer GSM31003
15 M4 x 7mm Hex nuts GSM30200
24 ½” Nylon spacers G

Summary of the content on the page No. 2

SIDE SLIDING DOOR WINDOW GUARD (F2-10): 1. A 14” long aluminum angle bracket is provided to attach to the rear vertical section of the window frame. 2. This is necessary in order to screw on the rear vertical section of window guard. 3. Using four (4) #10 x ½” Sheet metal screws, attach angle bracket to frame through existing bracket holes. • The side of the bracket without holes should be flush with the inside of the window frame. • The window guard can now be installed as stated

Summary of the content on the page No. 3

3. Notching Plastic: • The window trim for the first drivers’ side window (F1-1) must be cut where the pop out window latches are located. • Mark the “V” shaped foot print of latch and cut plastic trim. The latches will bolt back against metal at the original location. 4. Final Touches: • The trim sections at the top and at the rear doors may stick out a little at the top where it meets the headliner. • Use a #10 x 1 ¼” Sheet metal screw to secure it down at the top of the trim. •

Summary of the content on the page No. 4

FORD VANS FULL SIZE VAN WINDOW GUARDS POSITIONS MODELS WGI-F1, F2, F3 AND F4 POSITION PO SITION POSITION #1 #9 #10 SIDE DRIVER SWING PASS. SIDE OUT SIDE FIRST DOOR F1-9 SLIDE WINDOW DOOR POSITION F1-1 #8 F2-10 SIDE SWING OUT DOOR F1-8 POSITION POSITION #2 #7 DRIVER PASS. SIDE SIDE SECOND SECOND WINDOW WINDOW F1-2 F1-7 POSITION POSITION #6 #3 PASS. DRIVER SIDE SIDE THIRD

Summary of the content on the page No. 5

WGI-F1-F2-F3-F4_INST_7-08