Summary of the content on the page No. 1
Model T4444
Model M7596
www.fi sher-price.com
Summary of the content on the page No. 2
Consumer Infor Consumer Inform mation ation FCC Statement (United States Only) This equipment has been tested and found to comply with WARNING the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide To avoid serious injury: reasonable protection against harmful interference in a • Adult supervision required. residential installation. This equipment generates, uses and • Never use near cars and other motor can radiate radio freq
Summary of the content on the page No. 3
Assembled Parts Assembled Parts Note: Label sheet not shown. Rear Axle 2 Front Axles Roof 2 Axle Mounts 4 Wheels 4 Hubcaps Sounds and Lights Box Retainer Cup Holder 4 Roof Posts 2 Rear Bushings 4 Wheel Covers 2 Front Bushings 2 Cap Nut Covers Steering Wheel Key 3 /16 16” Washer – 4 .354” Cap Nuts – 5 1 3 #6 x /2” Screw – 3 #8 x /4” Screw – 11 ALL SHOWN ACTUAL SIZE Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. Frame For your convenience, we’ve in
Summary of the content on the page No. 4
Battery Installation Battery Installation B Battery Safety Infor attery Safety Inform mation ation In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: 1,5V x 3 • Do not mix old and new batteries or batteries of different “AAA” (LR03) types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long
Summary of the content on the page No. 5
A Assembly ssembly Sou Sounds and nds Li Lights Box ghts 2 1 2 3 ” /16 16 Front Axle Washer Front Bushing Retainer 3 • Slide a / 16 16” washer onto the front axle labeled 2. Frame • Then, slide a front bushing, flat side first, onto the front axle. BOTTOM VIEW • Turn the frame on its side. • Fit the sounds and lights box onto the dash on the topside of the vehicle. • Then, fit the retainer over the battery compartment door on the 3 underside of the frame. Insert four #8 x / 4” screws into th
Summary of the content on the page No. 6
A Assembly ssembly 5 6 Cap Nut Frame Front End 3 ” /16 16 Washer Front Axle 2 Front Axle • Fit a cap nut onto the end of the front axle, as shown. • Tap the cap nut with a hammer. • Gently pull the front wheel down to be sure the cap nut is FRONT VIEW securely attached to the front axle. • Repeat assembly steps 2-6 to assemble the front axle labeled 1, 3 • First, slide a /1 16 6” washer onto the front axle. 3 a wheel, a front bushing, a /16 16” washer, two cap nuts and a • Then, insert the fron
Summary of the content on the page No. 7
Assembly Assembly Axle Mount Cap Nut Covers 7 8 BOTTOM VIEW • Fit a cap nut cover over each cap nut on the front end of the frame. Push to “snap” in place. • Turn the frame upside down on a flat surface. • Fit an axle mount onto the pegs near the rear of the frame. Hint: Each axle mount only fits on one side of the vehicle. If it does not line up with the pegs on the frame, try fitting it to the other side. • Insert three #8 x ¾” screws into the axle mount and tighten. • Repeat this procedure
Summary of the content on the page No. 8
Assembly Assembly Cap Nut Cover 13 14 Steering Wheel Sounds and Lights Box • Fit a cap nut cover onto each rear wheel and push to “snap” • Turn the frame upright. in place. • Fit the steering wheel onto the sounds and lights box. • Insert three #6 x ½” screws into the steering wheel and tighten. 17 18 Cup Roof Assembly Holder • Fit the cup holder onto the side of the frame. • Insert a #8 x ¾” screw into the cup holder and tighten. • Fit the roof assembly onto the frame. Push near each post to
Summary of the content on the page No. 9
Assembly Assembly Posts 15 16 Key Roof • Fit the key into the hole in the dash. Push to “snap” in place. • Turn the roof upside down on a flat surface. • Fit the four posts into the roof and push to “snap” in place. Hint: Each post is labeled (1, 2, 3 or 4). Match the number on the post to the number on the roof. 9 9
Summary of the content on the page No. 10
Decoration Decoration • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. • Place the labels exactly as shown in the illustrations. For best results, avoid repositioning a label once it has been applied to the vehicle. • After applying a label, rub the label firmly with a clean, dry cloth to make sure the label is adhered to your vehicle. Start at the center of a label, and smooth towards the outer edges to remove air bubbles.
Summary of the content on the page No. 11
U Use se Press the horn on the steering wheel for fun car songs and lights! Real working door! 1 11 1
Summary of the content on the page No. 12
CONSUMER ASSISTANCE 1-800-432-5437 (US & Canada) 1300 135 312 (Australia) Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052. Hearing-impaired consumers: 1-800-382-7470. Outside the United States: Canada: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2; www.service.mattel.com. Great Britain: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303. www.service.mattel.com/uk Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland. Aus
