Summary of the content on the page No. 1
J6982
www.fi sher-price.co.uk
Summary of the content on the page No. 2
Consumer Information Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. Some parts may be packed in the pad. WARNING To prevent serious injury or death from falls and being strangled in the restraint system: Fall Hazard - It is dangerous to use this product on an elevated surface, since Headrest Pad child’s movement may cause the product to slide or tip over. Use only on a floor. Liner/Pad Suffocation Hazard - Never use on a soft surface (b
Summary of the content on the page No. 3
Battery Installation Assembly IMPORTANT! Before assembly and each use, inspect this product Hint: We recommend using alkaline batteries for for damaged hardware, loose joints, missing parts or sharp edges. longer battery life. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. 1,5V x 4 Base Tubes “D” (LR20) Lift Lift Base 1 Lift both base tubes. Hubs Loosen the screws in the battery compartment door a
Summary of the content on the page No. 4
Assembly Seatback Tube Wide Slot Narrow Slot Footrest Tube 5 3 Position the pad onto the frame assembly. The extra, padded portion Position the footrest tube so that it curves down. should be toward the seat back tube. Fit the ends of the footrest tube into the wide slots in the hubs. Position the seat back tube so that it curves down. Fit the ends of the seat back tube into the narrow slots in the hubs. Seat Back Tube Hubs 6 Fit the upper pocket on the pad around the seat
Summary of the content on the page No. 5
Assembly Headrest Pad Footrest Tube Restraint Belts 7 Fit the lower pocket on the pad around the footrest tube. Fasten the straps underneath the footrest tube to secure the lower portion of the pad. 9 Fit the restraint belts through the slots in the headrest pad. PUSH Fit the headrest pad to the liner/pad. PUSH Toy Bar Sockets 8 Push down on the pad to be sure it is assembled properly. If the pad falls through the frame, you have not assembled it properly. Please re-read these
Summary of the content on the page No. 6
Set-up WARNING To prevent serious injury or death from falls and being strangled in the restraint system: Fall Hazard - It is dangerous to use this product on an elevated surface, since child’s movement may cause the product to slide or tip over. Use only on a floor. Suffocation Hazard - Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffoca- tion in soft surfaces. Always use the restraint system. Back View Not recommended for children who
Summary of the content on the page No. 7
Securing Baby Starting Gliding Motion Restraint Belts Restraint Pad Place your child in the product. Position the restraint pad between your child’s legs. Fasten both restraint belts to the buckles on each side of the restraint pad. Make sure you hear a “click” on both sides. Check to be sure the restraint system is securely attached by pulling it away from your child. The restraint system should remain attached. Power/Speed Switch Anchored End Anchored End Free End Free End TIGHTEN L
Summary of the content on the page No. 8
Music Room-to-Room Portability Music Switch Choose the style of music for baby. Slide the music switch to: Soothing Playful Off Slide the volume switch to for low volume; for high volume. Note: Low battery power may cause this product to operate erratically (no movement/no sounds) and the product may not turn off. If this should happen, remove and discard all batteries and replace with four, new “D” (LR20) alkaline batteries. Make sure your child is properly secured in the g
