Craftsman 103.24521 user manual

Summary of the content on the page No. 1

OPERATING INSTRUCTIONS
AND PARTS LIST FOR
CRAFTSMAN DRILL PRESS
MODEL NUMBER 103.24521 & 103.24531
The model number of your Drill Press will be found on a plate located on the
base near the column. Always mention this number when communicating with
us regarding your Drill Press, or when ordering parts.
HOW TO ORDER REPAIR PARTS
All parts listed herein may be ordered through SEARS, ROEBUCK AND CO.
or SIMPSONS-SEARS LIMITED. When ordering parts by mail from the mail
order house which serves the te

Summary of the content on the page No. 2

OPERATING INSTRUCTIONS AND PARTS LIST FOR DRILL PRESS MODEL NUMBER 103.24521 AND 103.24531 MOTOR MOUNT MOTOR MOUNT LOCK SCREW FEED STOP HEADSTOCK LOCK HANDLE FEED STOP ROD LOCK HANDLE FEED RETURN FEED HANDLE SPRING ADJ. KNOB FEED RETURN SPRING ADJ. CHUCK KEY CHUCK KNOB LOCK SCREW TABLE LOCK HANDLE BENCH MODEL FLOOR MODEL FIGURE 1 7. Items No. 41, 42 and 44, Bumper and Stud This drill press has been planned to give you the Assembly. utmost in precision and efficiency of operation. Quality materia

Summary of the content on the page No. 3

INSTALLATION: For slower speeds use a Multi-Speed Attachment available from your nearest Sears retail store or mail Three 1 3/32 inch diameter holes have been pro- order house. Ask for Catalog No. 9A-2338. vided in the base through which bolts or screws may be inserted to secure the drill press to a well con- LUBRICATION: structed bench or tool stand. The spindle and pulley bearings have been packed To install motor loosen the motor mount lock with lubricant and will require no further attention

Summary of the content on the page No. 4

ADJUSTMENTS: sive commercial operations are to be performed, high speed steel drills although more expensive, will The following adjustments may be necessary to prove to be the better tool as higher operating speeds keep your drill press at its most efficient operation. are possible plus longer cutting edge life. If the automatic feed return fails to return the The solid center wood bit has a single flute turn- chuck to the top of the stroke or if the return action ing around a solid center but

Summary of the content on the page No. 5

For extensive use on woodworking, an auxiliary depth by lowering the drill to a mark on the edge table of 3 4 inch plywood will prove its worth in of the work piece corresponding to the depth of added work area and the protection from shifting hole desired. of your work. Fasten the plywood table to the drill A straight piece clamped to the table, as a guide press table with countersunk screws. This auxiliary or fence, has many uses, as in drilling several holes table also provides a good surface

Summary of the content on the page No. 6

—72 SPINDLE PULLEY ASS'Y. 45 MOTOR MOUNT ASS'Y. COMPLETE INCLUDES ITEMS 41 THRU 49