Summary of the content on the page No. 1
CONTENTS
INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
mOUNTINg RECOmmEND a TIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
aN f INST aLLa TION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
CONTROL fEa TURES:
4 SpEED. . .
Summary of the content on the page No. 2
MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mounting recommendations as you decide where to install your Casablanca fan. • For safety reasons, the fan blades must be a minimum of 7’ above the floor. • Do not locat
Summary of the content on the page No. 3
® Paanam Halo INSTALLATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed. GETTING STARTED Carton Contents The fan carton contains the fan body, warranty card, owner’s manual, and all the parts neccessary ( except blades) to assemble and install your Casablanca ceiling fan
Summary of the content on the page No. 4
crossbar mounting bracket installation JOIST note: After removing the old fixture, check the outlet box to insure that it is supported by a joist or beam across its upper surface. If not, a 2” x 4” stud must be installed. Step 1. Remove the knockout plug in the center of the 1 outlet box or drill a /2 ” h o l e f o r t h e l a g s c r e w t o p a s s 1 through. Then drill a / 4 ” guide hole into the joist or beam CEILING to a depth of 3”. CEILING FAN WIRING AppROVED S
Summary of the content on the page No. 5
® Panama Halo hANGING ThE FAN Step 4. To hang the fan body in the canopy, hold the fan body fir mly and insert the ball into the canopy opening. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening. BALL noTE : Independent control of the light fixture using a W-81 re- quires an additional power wire SLOT run from the wall switch to the pIN fan. See Page 10 for wiring. Fan Weighs 27 lbs CA
Summary of the content on the page No. 6
BLADE hOLDER & BLADE Step 8. BLADE HOLDER SCREW BLADE SCREW Attach the blades to the blade holders (2 pER BLADE HOLDER) (3 pER BLADE) with the three blade screws and felt washers provided for each blade. Hand tighten securely. FELT WASHER (3 pER BLADE) Install the assembled blade and blade holder to the flywheel (round holes) or direct drive motor. Hand tighten securely. BLADE Repeat for each assembly. wARnIng: To reduce the risk of personal injury, do not bend blade holders when insta
Summary of the content on the page No. 7
4-SPEED 4 - SPEED OPERATION Pull-chain switches on the fan control the fan and lights. Using the fan control pull-chain switch: Fan off FAN & SpEED CONTROL OpTIONAL LIGHT pULL at start. pULL CHAIN SWITCH CHAIN SWITCH First pull: fan ON, High speed Second pull: Medium speed Third pull: Medium Low speed Fourth pull: Low speed Fifth pull: Fan OFF The sequence of Light pull chain as follows: Light off at Start First pull: Up Light Second pull: Down Light (Optional Light Kit If Installed) Third
Summary of the content on the page No. 8
R 4 - SPEED OPTIONAL WALL CONTROL W-81 The W-81 wall control provides separate control of fan and light with two separate knobs from a convenient wall location. The W-81 is designed to replace a standard wall switch and wall boxes with a depth of 2” or greater. Requires two hot leads from wall box to ceiling wiring box. MED MED LO To install a W-81 wall control in place of an existing HI OFF HI wall switch, follow the instructions on the W-81 package. Operation of the fan from the wall switc
Summary of the content on the page No. 9
® Panama Hoal TROUBLEShOOTING BeFOre reqUeSTING ServICe: Please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes : For cleaning, a soft brush or lint-free Never Lubricate this Fan! c l o t h s h o u l d b e u s e d t o p r e v e n t s c r a t c h i n g t h e fi n i s h . A v a c u u m The precision motor at the heart of your Airflow fan features cleaner brush nozzle can remove heavier dust. Surface smud
Summary of the content on the page No. 10
Product SPtionS ecifica ® Model Name: Panama® Halo Motor: XTR200 x 20mm Model Number: 66HXXF Blade Span: 42" or 50" Blade Iron Pitch: 20° No. of Blades: 5 Dimensions: A = 10.75" Technology: 4-Speed B = 12.46" NOTE: Dimension B C = 3" Airflow*: 6,480 cfm includes light fixture D =13.43" and glass. Electricity Use*: 84 watts E = 5.6" Airflow Efficiency*: 73 cfm/watt Weight: 27 lbs. * Performance data is for fan only. No lighting wattage is included. Measurements taken with 21" basic bl
