BRK electronic FCD2BT user manual

Summary of the content on the page No. 1

INTRODUCTION
BASIC SAFETY INFORMATION
USER’S MANUAL
• Dangers, Warnings, and Cautions alert you to important
operating instructions or to potentially hazardous situations.
120V PLUG-IN CARBON MONOXIDE ALARM WITH
Pay special attention to these items.
BATTERY BACK-UP AND SILENCE FEATURE
• THIS IS NOT A SMOKE ALARM! This CO Alarm is designed to
detect carbon monoxide from ANY source of combustion. It is
NOT designed to detect smoke, fire, or any other gas.
• This CO Alarm is approved for use in si

Summary of the content on the page No. 2

WHERE CO ALARMS SHOULD NOT BE UNDERSTANDING YOUR CO ALARM INSTALLED What you see and hear during installation DO NOT LOCATE THIS CO ALARM: WHEN YOU FIRST INSTALL UNDER NORMAL CONDITIONS • In garages, kitchens, furnace rooms, or in any extremely dusty, THE BATTERY: (AC POWER): dirty or greasy areas. HORN: May chirp briefly HORN: Silent • Closer than 15 feet (4.6 meters) from a furnace or other fuel POWER/ALARM LIGHT: POWER/ALARM LIGHT: burning heat source, or fuel burning appliances like a wate

Summary of the content on the page No. 3

REGULAR MAINTENANCE IF YOUR CO ALARM SOUNDS To keep the CO Alarm working properly: • Test it every week as described in “Weekly Testing.” Actuation of your CO Alarm indicates the presence of carbon monoxide (CO) which can kill you. In other words, when your CO • Vacuum the CO Alarm cover at least once a month, using the soft Alarm sounds, you must not ignore it! brush attachment. Never use water, cleaners, or solvents, since they may damage the unit. Test the Alarm again after vacuuming. IF THE

Summary of the content on the page No. 4

HOW CAN I PROTECT MY FAMILY? A CO Alarm is an excellent means of protection. It monitors the air and sounds a • Make regular visual inspections of all fuel-burning appliances. Check loud alarm before carbon monoxide levels become threatening for average, appliances for excessive rust and scaling. Also check the flame on the healthy adults. burner and pilot lights. The flame should be blue. A yellow flame means fuel is not being burned completely and CO may be present. Keep the blower A CO Alarm

Summary of the content on the page No. 5

TROUBLESHOOTING GUIDE PROBLEM... THIS MEANS... YOU SHOULD... Red light is OFF. Unit will not alarm when you CO Alarms may not be plugged all the way in, or Gently push unit all the way into outlet. Make sure press the Test/Silence button. is not receiving power. it is not plugged into an outlet controlled by a switch. Three rapid chirps every minute. Red light Malfunction. CO Alarm needs to be replaced. Make sure unit is plugged in securely. FLASHES. CO Alarms under warranty should be returned