Summary of the content on the page No. 1
UCCDS20T UCCDS40T UCCDM27T UCCDL18T UCCDL36T
UCCDS20H UCCDS40H UCCDM27H UCCDL18H UCCDL36H
UCCDS30T UCCDM18T UCCDM36T UCCDL27T
UCCDS30H UCCDM18H UCCDM36H UCCDL27H
Universal Computing Carts (UCC) Double Cart
Mobile, secure, and powered storage for
®
BL A C K B OX
up to 18, 20, 27, 30, 36, or 40 computing devices.
The perfect storage solution for tablets, notebooks, and laptops.
Customer Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
Support FREE technical sup
Summary of the content on the page No. 2
FCC and IC RFI Statements/NOM Statement FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interf erence to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Su
Summary of the content on the page No. 3
NOM Statement 4. Todas las instrucciones de operación y uso deben ser seguidas. 5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca de una alberca, etc. 6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por el fabricante. 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario
Summary of the content on the page No. 4
NOM Statement 16. El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo de tiempo. 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato; o C: El aparato ha sido expuesto a la
Summary of the content on the page No. 5
Trademarks Used In This Manual Trademarks Used In This Manual Black Box and the Double Diamond logo are registered trademarks of BB Technologies, Inc. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. UCCDM20-T 724-746-5500 | blackbox.com Page 5
Summary of the content on the page No. 6
Table of Contents Table of Contents 1. Specifications ...................................................................................................... 7 2. Overview............ ............................................................................................... 11 2.1 Introduction ....................................................................................... 11 2.2 What‘s Included ................................................................................ 11
Summary of the content on the page No. 7
Chapter 1: Specifications 1. Specifications Table 1-1. Cart Specifications Part Number UCCDS20T, UCCDS30T, UCCDS40T, UCCDS20H UCCDS30H UCCDS40H Slot Dimensions Height (in.) 13" 13" 13" Height (cm) 33 cm 33 cm 33 cm Width (in.) 1.3" 1.3" 1.3" Width (cm) 3.5 cm 3.5 cm 3.5 cm Depth (in.) 10" 10" 10" Depth (cm) 25.4 25.4 cm 25.4 cm Device Capacity Number of 20 30 40 Devices External Dimensions (Including Handle)* Height (in.) 44.3" 44.3" 44.3" Height (cm) 112.4 cm 112.4 cm 112.4 cm Width (in.) 54.4
Summary of the content on the page No. 8
Chapter 1: Specifications Table 1-1 (continued). Cart Specifications Part Number UCCDM18T, UCCDM27T, UCCDM36T, UCCDM18H UCCDM27H UCCDM36H Slot Dimensions Height (in.) 13" 13" 13" Height (cm) 33 cm 33 cm 33 cm Width (in.) 1.5" 1.5" 1.5" Width (cm) 3.9 cm 3.9 cm 3.9 cm Depth (in.) 15" 15" 15" Depth (cm) 38.1 cm 38.1 cm 38.1 cm Device Capacity Number of 18 27 36 Devices External Dimensions (Including Handle)* Height (in.) 44.3" 44.3" 44.3" Height (cm) 112.4 cm 112.4 cm 112.4 cm Width (in.) 54.4" 5
Summary of the content on the page No. 9
Chapter 1: Specifications Table 1-1 (continued). Cart Specifications Part Number UCCDL18T, UCCDL27T, UCCDL36T, UCCDL18H UCCDL27H UCCDL36H Slot Dimensions Height (in.) 13" 13" 13" Height (cm) 33 cm 33 cm 33 cm Width (in.) 1.5" 1.5" 1.5" Width (cm) 3.9 cm 3.9 cm 3.9 cm Depth (in.) 17" 17" 17" Depth (cm) 43.2 cm 43.2 cm 43.2 cm Device Capacity Number of 18 27 36 Devices External Dimensions (Including Handle)* Height (in.) 44.3" 44.3" 44.3" Height (cm) 112.4 cm 112.4 cm 112.4 cm Width (in.) 54.4" 5
Summary of the content on the page No. 10
Chapter 1: Specifications Table 1-2. Power Strip Specifications Part Number Timer Included Power Strips UCCDS20T, (1) 4-outlet, 4-bank timer (2) 12-outlet, 15 A max. UCCDS20H with ”always-on outlet,” 15-minute increments, UCCDS30T, (3) 12-outlet, 15 A max. 100–125 V, 50–60 Hz, UCCDS30H 15 amp max. UCCDS40T, (4) 12-outlet, 15 A max. UCCDS40H UCCDM18T, (2) 12-outlet, 15 A max. UCCDM18H UCCDM27T, (3) 12-outlet, 15 A max. UCCDM27H UCCDM36T, (3) 12-outlet, 15 A max. UCCDM36H UCCDL18T, (2) 12-out
Summary of the content on the page No. 11
Chapter 2: Overview 2. Overview 2.1 Introduction The Universal Computing Cart (UCC) is designed to store, charge, and transport tablets, e-readers, laptops, netbooks, and other similar devices. Units are available with capacities for 18, 20, 27, 30, 36, or 40 separate storage slots. Each unit plugs into a typical 120-volt 15-amp outlet. Carts are available with tambour or solid-steel doors. Please read these operating instructions carefully. They contain important advice concerning the use
Summary of the content on the page No. 12
Chapter 2: Overview 2.3 Hardware Description Cable Grommet or Pop-Up Power Module Laminate Top Ventilation Handle and Power Cord Wrap Removable Rear Door Tambour Door Cable Access Non-Locking Locking Swivel- Casters Casters Figure 2-1. Front and back of cart with tambour door. Ventilation Cable Grommet or Pop-Up Power Module Laminate Top Handle and Power Cord Wrap Removable Rear Door Solid Steel Door Locking Swivel- Non-Locking Cable Casters Casters Access Figure 2-2. Front and
Summary of the content on the page No. 13
Chapter 3: Electrical Precautions 3. Electrical Precautions • The power switch must be in the “OFF” position before plugging the UCC into a wall receptacle. • The UCC must ONLY be connected to a 120-volt AC 15- or 20-amp power supply. • The UCC must only be used by adults or with adult supervision. • Always store the power cord around the cord wraps when transporting the UCC. • Never pull the UCC by the power cord. • Do not plug the UCC in if the switch, receptacle(s), or power cord has been d
Summary of the content on the page No. 14
Chapter 4: Configuration and Setup 4. Configuration and Setup Remove and discard all packaging materials and then lock the lockable casters. Open and inspect the UCC to verify all doors, locks, and casters are working properly. Do not plug the UCC into a wall outlet until all configurations and setup are complete. 4.1 Installing the Handle The handle/cord wrap installs on the side of the cart with the locking swivel casters. NOTE: The casters swivel on one side of the UCC and are fixed on the o
Summary of the content on the page No. 15
Chapter 4: Configuration and Setup 4.2 Routing the Cable (UCCDS20T, UCCDS20H, UCCDS30T, UCCDS30H, UCCDS40T, UCCDS40H) 1. A t the back of the cart, loosen the two screws on the cable manager, pull up on the top section of the cable manager, and place the device side of the charging cable into one of the slots. (See Figure 4-2.) Loosen screws on cable manager and pull up Cable manager Route cable to the front of the cart Power Strip Wrap excess cable Charger around cable wrap Figure 4-2.
Summary of the content on the page No. 16
Chapter 4: Configuration and Setup Loosen screws on cable manager and pull up Cable manager Route cable to the front of the cart Figure 4-3. Routing the cable. 4.3 Fastening the Power Bricks and Routing the Cable (UCCDM18T, UCCDM18H, UCCDM27T, UCCDM27H, UCCDM36T, UCCDM36H, UCCDL18T, UCCDL18H, UCCDL27T, UCCDL27H, UCCDL36T, UCCDL36H) 1. A ttach the wrapped cord and power brick to the back of the shelf using the hook and loop strap. Keep some extra cable unwrapped to plug into the power
Summary of the content on the page No. 17
Chapter 4: Configuration and Setup Route cable to the Loosen screws on front of the cart cable manager and pull up Cable manager Power brick and cord Power strip Figure 4-4. Fastening the power brick and routing the cable. UCCDM20-T 724-746-5500 | blackbox.com Page 17
Summary of the content on the page No. 18
Chapter 5: Using Your Universal Computing Cart 5. Using Your Universal Computing Cart 5.1 Charging Your Computers • After the devices have been loaded into the UCC, plug the power cord of the UCC into a suitable receptacle. • Locate the internal power switches on the timer and power strips of the UCC and push the switches to the ON position. 5.2 Moving Your Universal Computing Cart • Turn the timer power switch to the off position. • Remove the UCC plug from the wall receptacle and wrap the co
Summary of the content on the page No. 19
Chapter 5: Using Your Universal Computing Cart Timer Power cord To wall outlet Cable access ports Figure 5-1. Plug the cart into the wall. UCCDM20-T 724-746-5500 | blackbox.com Page 19
Summary of the content on the page No. 20
Chapter 5: Using Your Universal Computing Cart 5.3 Timer Instructions Before using your timer: • F or your safety, we recommend that a qualified electrician test the circuit you will plug the cart into. The circuit should be checked for ground integrity and appropriate branch circuit protection. • The cart’s ground prong must be present for safe operation. If the plug is damaged or if the ground prong has been removed, it should be replaced by a qualified electrician. • Using the cart, inc
