Summary of the content on the page No. 1
USER'S GUIDE
74T5 SERIES 220-240V
2
Thank You
3
Safety Instructions
4
Product View
5
Assembly
6-7
Operations
8-12
Maintenance and Care
13-14
Troubleshooting
14
Replacement Parts
15
Warranty
16
Consumer Services
Summary of the content on the page No. 2
Thanks for buying a BISSELL Cleanview™ Pet Plus Cyclonic We’re glad you purchased a BISSELL Cleanview Pet Plus cyclonic bagless vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL Cleanview Pet Plus cyclonic bagless vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a p
Summary of the content on the page No. 3
Thanks for buying a BISSELL Cleanview™ Pet Plus Cyclonic IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, ■ Young children should be supervised to ensure basic precautions should be observed, that they do not play with the appliance. including the following: ■ Remove plug from electrical outlet before cleaning or maintaining the appliance. REAd ALL ■ If the supply cord is damaged, it must be replaced by the manufacturer or its service INSTRUCTIONS agent in order to a
Summary of the content on the page No. 4
Product view Cord Clip Hose Clip Deluxe Stretch Hose Handle Crevice Tool Carrying ™ TurboBrush Handle Tool Extension Twist 'n Wand ™ Snap Hose Quick ™ Connector Release Quick Cord Wrap ™ Reach Handle Primary Combination Separator Dusting Hose Wand Brush/ Upper Tank Upholstery Tool Power Hose Cord Wand Base Power Switch Inner and Dirt Outer Handle Container Circular Release Filters Pedal Filter Cup Lock ’n Pre-Motor ™ Seal Lever Filter HEPA Media Foot Hose Height Pos
Summary of the content on the page No. 5
Assembly The only tool you’ll need to assemble your vacuum cleaner is a screwdriver. WARNING: Attach handle to vacuum Plastic film can be dangerous. To avoid danger of suffocation, keep 1. Locate the vacuum handle and remove away from babies and children. the screw packet taped to the base of the handle. 2. Stand the vacuum upright and place the handle on the top of the vacuum body. 3. Insert the screws into the existing holes on each side. Tighten securely with a screwdriver. Attach
Summary of the content on the page No. 6
Operations Handle position 1 Press the handle release pedal with your foot to place your BISSELL Cleanview Pet Plus into one of three cleaning positions. 2 1. Upright- For storage and above floor cleaning with special tools. 2. Normal Cleaning- Press handle release pedal once. Use for most household floor 3 cleaning tasks. 3. Low Cleaning- With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs CAUTION:
Summary of the content on the page No. 7
Operations Special tools NOTICE: The floor brush will continue to rotate while Your BISSELL Cleanview Pet Plus is not you use your vacuum for above floor only a powerful carpet and rug vacuum cleaning. To prevent carpet damage, do cleaner, it’s also a versatile above floor not lean on the vacuum or let the power- vacuum cleaner when you select one of foot tilt forward. the special tools. 1. Raise handle to upright position. Tip: 2. Grasp the Quick Reach handle and lift hose wand to se
Summary of the content on the page No. 8
Maintenance and care To maintain maximum cleaning performance from your BISSELL Cleanview Pet Plus, perform these WARNING: simple maintenance steps. To reduce the risk of electric shock, turn 1. Empty the dirt container when the dirt power switch OFF and disconnect plug reaches the “Full” line on the side. from electrical outlet before performing maintenance or troubleshooting checks. 2. Check the inner and outer circular filters, and the pre-motor filter at least once a month and clea
Summary of the content on the page No. 9
Maintenance and care Cleaning the inner & outer circular filters 1. Unplug cleaner from electrical outlet. NOTICE: 2. Remove the dirt container as described This product is intended for household use in the previous section. Grasp the filter only and not for commercial or industrial cup located at the bottom of the dirt use. Vacuuming of dust from products like container and twist counterclockwise to plaster, concrete or ashes will damage the unlock and remove. motor and void the warr
Summary of the content on the page No. 10
Maintenance and care Replacing the HEP A media post-motor filter* The post-motor filter is a H13 HEPA media filter*, which assists in the filtration process to return clean air to the room. 1. Unplug the vacuum from electrical outlet. HEPA Media 2. Remove the filter door, located on the Post-Motor front of the vacuum. Filter* 3. Remove the post motor filter. 4. Replace the post-motor filter with a new filter. NOTE: The post-motor filter is a white pleated HEPA media filter*. This
Summary of the content on the page No. 11
Maintenance and care Check r otating floor brush and drive belt You should check your vacuum cleaner’s rotating floor brush and drive belt regu- larly for wear or damage. You should also clean the brush and brush ends of string, hair and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accu- mulated under the brush cover. 1. Unplug cleaner from electrical outlet. Brush 2. Place handle in low position an
Summary of the content on the page No. 12
Maintenance and care Replace light bulb 1. Unplug cleaner from electrical outlet. 2. Using a flat screwdriver, table knife or coin, insert into the slot on the right of the lens and gently push inner latch to the left, as shown, to remove the lens. 3. Remove the bulb from the socket by grasp- ing bulb and pulling straight out. Install the new bulb by pushing it gently into the socket until the bulb snaps into place. 4. Reposition lens by inserting tab on left side and then pushing the rig
Summary of the content on the page No. 13
Troubleshooting WARNING: To reduce the risk of electric shock, turn power OFF and dis- connect plug from electrical outlet before performing maintenance or troubleshooting. Vacuum cleaner won’t turn Possible causes Remedies 1. Power cord not firmly plugged in 1. Check electrical plug Vacuum cleaner won't pick up dirt Possible causes Remedies 1. Incorrect height adjustment 1. Adjust powerfoot to correct height setting 2. Hose not attached to suction opening 2. Grasp Quick Release handle a
Summary of the content on the page No. 14
Troubleshooting Visible dirt escaping from cleaner continued Possible causes Remedies 3. Dirt container installed incorrectly 3. Position correctly and lock into place 4. Filter cup installed incorrectly 4. Remove dirt container and make sure filter cup is fully attached Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this pr oduct to the store.
Summary of the content on the page No. 15
Warranty - BISSELL CleanView™ Pet Plus Cyclonic This warranty gives you specific legal rights, and you may also have other rights which may vary from country to country. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by telephone, or regular post as described below, or contact your local in country distributor. Limited One Year Warranty Subject to the *EXCEPTIONS AND EXCLUSIONS identified b
Summary of the content on the page No. 16
BISSELL consumer services If your BISSELL product should require service: Call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local in country distributor for questions, service, or repair. If you have questions about your warranty or need replacement parts please contact the numbers below. For spare parts and accessories: For UK inquiries: Monday - Friday 9 am — 5
