Fisher-Price SHAKE `N GO N0246 user manual

Summary of the content on the page No. 1

N0246
Please keep this instruction sheet for future reference,
as it contains important information.
Requires nine “AA” (LR6) alkaline batteries (not included) for operation.
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips screwdriver (not included).
™
This product functions with most other Shake ‘n Go vehicles. Each sold separately.
www.fisher-price.com
1

Summary of the content on the page No. 2

Starting Gate Tab • Slide the tab near the starting gate to release it. Lift the starting gate. Red Start Lights Starting Arrow • Set the cars on each starting arrow. The red start light turns on when a car is placed on a starting arrow.

Summary of the content on the page No. 3

Ready - Set - Go! Light Post • Lift the light post. • Once both cars are on the starting arrows the lights on the light post flash red, yellow and then green to go!

Summary of the content on the page No. 4

Car Base Slide the power switch on each car and the base on . • Shake the cars to start the “engine” and the sound effects. Note: For maximum distance, shake the car 7 or 8 times. Shaking more than this does not increase the distance it will travel. Pedals • Press the pedal next to each car to start the race! Note: If one car takes off before the green light, you will hear a buzzer and the lights will reset.

Summary of the content on the page No. 5

Battery Installation Battery Safety Information 1.5V x 9 "AA" (LR6) In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid Car battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batt

Summary of the content on the page No. 6

Consumer Information FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio c