Summary of the content on the page No. 1
Service
Washer-Extractor
Cabinet Freestanding
HX, SX and UX OPL Models
Refer to Page 8 for Model Numbers
CFS462N
Part No. 9001900
www.comlaundry.com
December 2005
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Table of Contents Section 1 – Safety Information Section 4 – Service Procedures General Safety Precautions .....................................3 19. Top Cover Removal and Replacement ..........65 Important Safety Instructions ..................................4 20. Keypad Removal and Installation ..................65 Locating an Authorized Servicer ............................6 21. Computer Board Removal and Installation ...66 22. Keymode Switch Removal and Installation ...69 Section 2 – Introd
Summary of the content on the page No. 4
2 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9001900
Summary of the content on the page No. 5
Section 1 Safety Information Throughout this manual and on machine decals, you will find precautionary statements (“CAUTION,” “WARNING,” and “DANGER”) followed by specific instructions. These precautions are intended for the personal safety of the operator, user, servicer and those maintaining the machine. a DANGER Indicates an imminently hazardous situation that, if not avoided, will cause severe personal injury or death. a WARNING Indicates a hazardous situation that, if not avoided, could c
Summary of the content on the page No. 6
Section 1 Safety Information WARNING To reduce the risk of electric shock, fire, explosion, serious injury or death: � Disconnect electric power to the washer-extractor before servicing. � Never start the washer-extractor with any guards/panels removed. � Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer-extractor is properly grounded. W460 WARNING Repairs that are made to your products by unqualified persons can result in hazar
Summary of the content on the page No. 7
Section 1 Safety Information 6. Do not allow children to play on or in a washer-extractor. Close supervision of children is necessary when the washer-extractor is used near children. 7. Before the washer-extractor is removed from service or discarded, remove the door to the washing compartment. 8. Do not reach into the washer-extractor if the wash basket is moving. 9. Do not install or store the washer-extractor where it will be exposed to water and/or weather. 10. Do not tamper with the washe
Summary of the content on the page No. 8
Section 1 Safety Information Locating an Authorized Servicer Alliance Laundry Systems is not responsible for personal injury or property damage resulting from improper service. Review all service information before beginning repairs. Warranty service must be performed by an authorized technician, using authorized factory parts. If service is required after the warranty expires, Alliance Laundry Systems also recommends contacting an authorized technician and using authorized factory parts. 6
Summary of the content on the page No. 9
Section 2 Introduction Customer Service Alliance Laundry Systems is not responsible for personal injury or property damage resulting from improper service. Review all service information before beginning repairs. If literature or replacement parts are required, contact the source from whom the machine was purchased or contact Alliance Laundry Systems at (920) 748-3950 for the name of the nearest authorized parts distributor. For technical assistance, call (920) 748-3121. 9001900 © Copyrig
Summary of the content on the page No. 10
Section 2 Introduction Model Identification Information in this manual is applicable to these washer-extractors. HX18PVQM6 HX75PVQU6 SX35PVQU6 UX18PVPA6 UX25PVXM6 UX75PVNU6 HX18PVQU6 HX100PVNU6 SX35PVXM6 UX18PVPU6 UX25PVXU6 UX75PVPU6 HX18PVXM6 HX100PVQU6 SX35PVXU6 UX18PVQA6 UX35PVNA6 UX75PVQU6 HX18PVXU6 HX135PVNU6 SX55PVNU6 UX18PVQM6 UX35PVNU6 UX100PVNU6 HX25PVQM6 HX135PVQU6 SX55PVQU6 UX18PVQU6 UX35PVPA6 UX100PVPU6 HX25PVQU6 HX165PVNU6 SX55PVXU6 UX18PVXA6 UX35PVPU6 UX100PVQU6 HX25PVXM6 HX165PVQU
Summary of the content on the page No. 11
Section 3 Troubleshooting WARNING To reduce the risk of electrical shock, fire, explosion, serious injury or death: � Disconnect electrical power to the washer-extractor before servicing it. � Close the gas shut-off valve to the washer-extractor (when applicable) before servicing it. � Never start the washer-extractor with any guards/panels removed. � Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer-extractor is properly ground
Summary of the content on the page No. 12
Section 3 Troubleshooting 1. WE-8 CONTROL HAS NO VISIBLE DISPLAY (P AND N-VOLTAGE MODELS) The WE-8 control has no visible display. Is the main NO Turn on the main power power circuit circuit breaker. breaker on? YES 1 Is there voltage NO Check the wiring between the main (380-480 Volts) power block and the control transformer. into the control Repair or replace the wiring as needed. transformer? YES 2 Is there voltage NO (200-240 Volts) out of the Replace the control transformer. control tr
Summary of the content on the page No. 13
Section 3 Troubleshooting Please refer to the following 2 pages for wiring diagram information. 9001900 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 11
Summary of the content on the page No. 14
Section 3 Troubleshooting WE-8 Control Has No Visible Display (P and N-Voltage Models) (Sheet 1 of 2) 4 2 3 4 5 1 6 7 NOTE: Refer to the wiring diagram supplied with your machine. 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9001900
Summary of the content on the page No. 15
Section 3 Troubleshooting WE-8 Control Has No Visible Display (P and N-Voltage Models) (Sheet 2 of 2) CFD3S 063787600D 9001900 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 13
Summary of the content on the page No. 16
Section 3 Troubleshooting 2. WE-8 CONTROL HAS NO VISIBLE DISPLAY (Q AND X-VOLTAGE MODELS) The WE-8 control has no visible display. Is the main NO Turn on the main power power circuit circuit breaker. breaker on? YES Is 1 there voltage (200-240 Volts) coming out of the NO Check the main power circuit main power block breaker and power to the machine. between wires L2 (blue) and L1 (brown)? YES 2 Is there Voltage (120 NO Volts) into Replace the 3.15 Amp fuse. and out of the 3.15 Amp fuse? YES
Summary of the content on the page No. 17
Section 3 Troubleshooting Please refer to the following 2 pages for wiring diagram information. 9001900 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 15
Summary of the content on the page No. 18
Section 3 Troubleshooting WE-8 Control Has No Visible Display (Q and X-Voltage Models) (Sheet 1 of 2) 6 NOTE: Refer to the wiring diagram supplied with your machine. 16 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9001900
Summary of the content on the page No. 19
Section 3 Troubleshooting WE-8 Control Has No Visible Display (Q and X-Voltage Models) (Sheet 2 of 2) 5 3 3.15 A 4 2 3 1 CFD5S 9001900 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 17
Summary of the content on the page No. 20
Section 3 Troubleshooting 3. NO FILL ANALYSIS Check the main water valve Is shut-offs to make sure that there water NO coming in through they are turned on. Check Replace the valve’s solenoid if the water supply inside of the water hoses and in-line screens for any available. If the solenoid isn’t lines? blockages. available, replace the entire valve. YES NO 1 Is there voltage Is there (220 Volts) between the magnetism within YES two wires of the the center water valve that walls of the has bee
