Summary of the content on the page No. 1
MICROCOMPUTER MN101C00
MN101C115/117
LSI User’s Manual
Pub. No. 21411-011E
Summary of the content on the page No. 2
Summary of the content on the page No. 3
PanaXSeries is a trademark of Matsushita Electric Industrial Co., Ltd. The other corporation names,logotype and product names written in this book are trademarks or registered trademarks of their corresponding corporations. Request for your special attention and precautions in using the technical information and semiconductors described in this book (1) An export permit needs to be obtained from the competent authorities of the Japanese Government if any of the products or technologies describ
Summary of the content on the page No. 4
How to Read This Manual The MN101C11x incorporates more than one ROM/RAM to meet a variety of applications. An EPROM version as well as a Mask ROM version is available so users can write a program by themselves. ROM RAM 8K MN101C115*1 256 16K MN101C117 512 16K MN101CP117 512 ? ?? ?? ??? ??
Summary of the content on the page No. 5
n Manual Configuration Each section of this manual consists of a title, summary, main text, supplemental information, precautions and warnings. The layout and definition of each section are shown below. Chapter 4 Timer Functions Subtitle 4-3 16-bit Timer Operation (timer 4) Sub-subtitle Summary The smallest block 4-3-1 Overview Introduction to the in this manual. section. Timer 4 is a 16-bit programmable counter that can be used as an event counter. A signal with frequency of 1/2 of the timer
Summary of the content on the page No. 6
n Finding Desired Information This manual provides four methods for finding desired information quickly and easily. (1) Consult the index at the front of the manual to locate the beginning of each section. (2) Consult the table of contents at the front of the manual to locate desired titles. (3) Consult the list of figures at the front of the manual to locate illustrations and charts by title name. (4) Chapter names are located at the top outer corner of each page, and section titles are located
Summary of the content on the page No. 7
? ?? @@@?he O26Xe ??? ?@@@@@@@@@@@@@@@@@@@)?e ?I’Xg@Xh @@Y?e?O26X?e @@@@@@@@@@@@@@@@@@@@@)e @Khf?O26X?e W&g O2@@6Kf O2@@6Kf O2@@6Kf ?O2@@@e W&g W2@@6Xf W&g ?O2@@@e ??? W2@@@@@(e W&f W26Xf7
Summary of the content on the page No. 8
Summary of the content on the page No. 9
? ?? @@@?he O26Xe ??? ?@@@@@@@@@@@@@@@@@@@)?e ?I’Xg@Xh @@Y?e?O26X?e @@@@@@@@@@@@@@@@@@@@@)e @Khf?O26X?e W&g O2@@6Kf O2@@6Kf O2@@6Kf ?O2@@@e W&g W2@@6Xf W&g ?O2@@@e ??? W2@@@@@(e W&f W26Xf7
Summary of the content on the page No. 10
Contents Chapter 1 Overview 1-1 Product Overview...........................................................................................................2 1-1-1 Overview ..........................................................................................................2 1-1-2 Product Summary .............................................................................................2 1-2 Hardware Functions ................................................................................
Summary of the content on the page No. 11
Chapter 3 Port Functions 3-1 Overview ......................................................................................................................38 3-2 Port Control Registers ..................................................................................................41 3-2-1 Overview ........................................................................................................41 3-2-2 I/O Port Control Registers .........................................................
Summary of the content on the page No. 12
Chapter 5 Serial Functions 5-1 Overview ......................................................................................................................92 5-2 Synchronous Serial Interface .......................................................................................94 5-2-1 Overview ........................................................................................................94 5-2-2 Setup and Operation ...................................................................
Summary of the content on the page No. 13
Appendices 8-1 EPROM Versions .......................................................................................................130 8-1-1 Overview ......................................................................................................130 8-1-2 Cautions on Use............................................................................................131 8-1-3 Erasing Written Data in Windowed Packages ..............................................132 (PX-AP101C11-SDC, PX-AP101C
Summary of the content on the page No. 14
Summary of the content on the page No. 15
? ?? @@@?he O26Xe ??? ?@@@@@@@@@@@@@@@@@@@)?e ?I’Xg@Xh @@Y?e?O26X?e @@@@@@@@@@@@@@@@@@@@@)e @Khf?O26X?e W&g O2@@6Kf O2@@6Kf O2@@6Kf ?O2@@@e W&g W2@@6Xf W&g ?O2@@@e ??? W2@@@@@(e W&f 7
Summary of the content on the page No. 16
Chapter 1 Overview 1-1 Product Overview 1-1-1 Overview The MN101C00 series of 8-bit single-chip microcomputers incorporate several types of peripheral functions. This chip series is well suited for VCR, MD, TV, CD, LD, printer, telephone, home automation, pager, air conditioner, PPC, remote control, fax machine, musical instrument, and other applications. The MN101C117 has an internal 16 KB of ROM and 512 bytes of RAM. Peripheral functions include four sets of timers, one set of serial interf
Summary of the content on the page No. 17
Chapter 1 Overview 1-2 Hardware Functions * 2 Differs depending upon the model. ROM/RAM Size: [+ 1-1-2 "Product Summary"] * 2 3 Internal ROM 16,384· 8-bit* * 2 Internal RAM 512· 8-bit *3 Bit 8 of the last address for the built-in ROM of MN101C11X Machine Cycles: High speed mode 0.10μs/20MHz (4.5V to 5.5V) is an optional bit; therefore, this 0.25μs/8MHz(2.7V to 5.5V) cannot be used as an ordinary 1.00μs/2MHz(2.0V to 5.5V) ROM. 4 Low speed mode 125μs/32KHz(2.0V to 5.5V)* *4 Ex
Summary of the content on the page No. 18
Chapter 1 Overview Timers 2 and 3 can be cascaded. Timer 4 16-bit timer Square wave output, 16-bit PWM output are possible. Clock source: fosc, fs/4, fs/16, TM4IO pin input Input capture function Time base timer 4 13 4 13 Clock source: fosc, fs/4, fx* , fx/2 * or fosc/2 4 XIOat 32kHz, can be set to measure one minute intervals* Can operate independently as timer 5 (8-bit timer). Watchdog timer 16 18 20 Selected by the mask option as fs/2 , fs/2 , or fs/2 Remote control Based on the timer
Summary of the content on the page No. 19
Chapter 1 Overview 1-3 Pins 1-3-1 Pin Diagram Figure 1-3-1 Pin Diagram (42-SDIP: TOP VIEW) Pins 5
Summary of the content on the page No. 20
Chapter 1 Overview Figure 1-3-2 Pin Diagram (44-QFP: TOP VIEW) 6 Pins
