American Standard Ellisse Oval Bathtub 2709.XXXW user manual

Summary of the content on the page No. 1

ELLISSE OVAL™
2709.XXXW SERIES
HIGH GLOSS ACRYLIC
SHOWN LESS ALL FITTINGS WHIRLPOOL/BATHING POOL
INSTALLATION INSTRUCTIONS
1759 mm
(69-1/4)
240 mm
OUTLINE OF
(9-7/16)
CUTOUT
SEE FTTG.SPECS
FOR DIMENSION
THANK YOU...
ON/OFF
C OF SUPPLIES
L SWITCH
for selecting an American Standard bath. Your new
305mm(12) X 229 mm(9)
PUMP
CUTOUT IN FLOOR FOR DRAIN bath is shipped to you after careful inspection. The
978 mm
whirlpool version is completely assembled with pump,
(38-1/2)
motor, and system pipi

Summary of the content on the page No. 2

FRAMING AND INSTALLATION THE VARIETY OF INSTALLATIONS POSSIBLE FOR THIS BATH MAY REQUIRE FRAMING PROCEDURES OTHER THAN THOSE SHOWN. LOCATE STUDS AS REQUIRED. INSURE ROUGH DIMENSIONS ARE PROPER, PLUMB AND SQUARE. FOR WHIRLPOOLS, PROVISION MUST BE MADE IN ALL INSTALLATIONS FOR AN ACCESS OPENING FOR SERVICING PUMP AND CONTROLS. THE FOLLOWING PROCEDURE MUST BE USED FOR ALL INSTALLATIONS: STRINGER OR PIER HEIGHT SHOULD BE AS INDICATED. THE SUMP OF THE BATH IS SUPPORTED BY INTEGRAL FEET AND NO AD

Summary of the content on the page No. 3

ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install

Summary of the content on the page No. 4

WIRE SELECTION GUIDE Maximum distance from The sizes shown on this fusebox to motor Motor Hi-Performance chart are recommendations Rating 50' 100' 150' 200' for copper conductors only. Always follow 120V Power Line local and national electrical codes 10 8 8 2.1 12 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill w