Summary of the content on the page No. 1
COLONY™ 5 x 30 AFR
INTEGRAL APRON WITH
2740.XXX SERIES
REMOVABLE ACCESS PANEL
FOR ABOVE-FLOOR
WHIRLPOOL/BATHING POOL
ROUGH INSTALLATION
HIGH GLOSS ACRYLIC
SHOWN LESS ALL FITTINGS INSTALLATION INSTRUCTIONS
59-7/8
THANK YOU...
(1521mm)
for selecting an American Standard bath. Your new bath is shipped
WATER
7
RETENTION
to you after careful inspection. The whirlpool version is completely
(178mm)
3/4 FLANGE
C/L OF DRAIN
assembled with pump, motor, and system piping. All you need to
(19mm)
Summary of the content on the page No. 2
INSTALLATION AND FRAMING INSTRUCTIONS Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Access to Pump/Motor may be made through the access opening in the apron panel. It is strongly recommended that an additional opening be provided for access to the drain components. NOTE: The apron may be used as the primary access opening. 1. As shown in Fig. 1, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
Summary of the content on the page No. 3
ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install
Summary of the content on the page No. 4
WIRE SELECTION GUIDE Maximum distance from The sizes shown on this fusebox to motor Motor High chart are recommendations Performance 50' 100' 150' 200' for copper conductors Rating only. Always follow 115V Power Line local and national electrical codes 12 12 10 8 1.1 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fil
