Summary of the content on the page No. 1
K 3.67 M
English 3
Español 19
Français 37
5.962-122.0 12/06
Summary of the content on the page No. 2
2
Summary of the content on the page No. 3
HIGH PRESSURE WASHER OPERATOR MANUAL MODEL OVERVIEW 4 Safety Alert Symbols IMPORTANT SAFETY 5 - 6 INSTRUCTIONS DANGER ASSEMBLY INSTRUCTIONS 7 indicates “an imminently hazardous sit- OPERATING INSTRUCTIONS 7 - 8 uation which, if not avoided, will result in USING THE ACCESSORIES 9 death or serious injury.” WORKING WITH DETERGENTS 9 - 10 WARNING TAKING A BREAK 11 indicates “a potentially hazardous situa- SHUTTING DOWN & CLEAN-UP 11 - 12 tion which, if not avoided, could result in WINTERIZING
Summary of the content on the page No. 4
MODEL OVERVIEW 1 Power cord with Ground Fault Circuit 11 ON/OFF switch Interrupter (GFCI) 12 Vario Power Spray wand 2 Trigger gun 13 Dirtblaster® (Rotating spray wand) 3 Trigger gun safety lock 14 Wash brush 4 High pressure hose CAUTION 5 Water inlet with garden hose con- This unit has been designed for use with nector (not shown) cleaning detergents recommended by 6 Transport handle the manufacturer. The use of other 7 Accessory storage cleaning detergents may affect the op- 8 Detergent ta
Summary of the content on the page No. 5
IMPORTANT SAFETY INSTRUCTIONS WARNING! physical injuries to the operator and When using this product basic irreversible damage to the machine. precautions should always be To reduce the risk of electrocution, followed, including the following: keep all connections dry and off the Read all the instructions before us- ground. Do not touch plug with wet ing the product. hands. To reduce the risk of injury, close su- The Trigger Gun Safety Lock PRE- pervision is necessary when a prod- VENTS
Summary of the content on the page No. 6
plugged into an appropriate outlet that is supply. Direct connection via a receiver properly installed and grounded in ac- tank or backflow preventer, for example, cordance with all local codes and ordi- is permitted. nances. Dirt in the feed water will damage the unit. To avoid this risk, we recommend DANGER fitting a water filter. Improper connection of the equipment- Garden hose must be at least 5/8 grounding conductor can result in a risk inch in diameter. of electrocution. Check wi
Summary of the content on the page No. 7
ASSEMBLY INSTRUCTIONS STEP 3, 4: Required tools A Philips Screwdriver, medium size (not supplied) for final assembling the unit. STEP 1, 2: OPERATING INSTRUCTIONS STEP 1: STEP 2: Connect the high pressure hose to Insert the spray wand of your choice the unit’s high pressure outlet. into the trigger gun. Press in against the spring tension and twist into locked position. English 7
Summary of the content on the page No. 8
STEP 3: STEP 6: Connect garden hose to unit’s water Unlock the trigger gun safety lock. inlet. Trigger the gun to eliminate trapped air, wait for a steady flow of water to emerge from the spray nozzle. STEP 4: Connect garden hose to the cold wa- STEP 7: ter source and turn water on com- Turn on the high pressure washer pletely. (I). The motor starts only if the trigger of the gun is pulled and shuts off when the trigger is released. STEP 5: Plug the Ground Fault Circuit Inter- rupter
Summary of the content on the page No. 9
USING THE ACCESSORIES WARNING Dirtblaster® To avoid serious injury never point This nozzle features a 0º pencil jet spray nozzle at yourself, other per- which rotates 360º for maximum dirt sons or animals. cutting action, effectively increasing Vario Power Spray Wand cleaning performance up to 50%. This nozzle combines the cleaning The Vario Power Spray Wand allows performance of a 0º pencil jet with you to adjust the cleaning pressure. the surface coverage of a wide angle To clean
Summary of the content on the page No. 10
STEP 3: ronment and your pressure washer. The special formula won’t clog the suction Turn on the pressure washer (I). Pull tube filter and will protect the internal trigger to operate unit: Liquid deter- parts of the pressure washer for a long- gent is drawn into the unit and mixed er life. For Kärcher Detergents, check with water. Apply detergent to work your retailer or visit our website: area. Do not allow detergent to dry www.karcher-usa.com/home on surface. The following Kärcher de
Summary of the content on the page No. 11
SHUTTING DOWN & CLEAN-UP STEP 1: STEP 5: Turn the switch to OFF (0) position Disconnect the high pressure hose and unplug cord from outlet. from the high pressure outlet. STEP 2: Turn off the water source. STEP 6: STEP 3: Release trigger and engage gun Press trigger to release water pres- safety lock. sure. STEP 4: Disconnect the garden hose from the water inlet on the unit. English 11
Summary of the content on the page No. 12
WINTERIZING AND LONG-TERM STORAGE 1: Disconnect all water connections. of heat as it may dry out the pump seals. 2: Turn on the machine for a few seconds, until the water which had CAUTION remained in the pump exits, turn off Failure to follow the above directions immediately. will result in damage to the pump as- 3: Do not allow high pressure hose sembly and accessories and will void to become kinked. the warranty. 4: Store the machine and accesso- Kärcher also recommends the regu
Summary of the content on the page No. 13
CLEANING TIPS Deck Cleaning Cement Patios, Brick and Stone (with or without detergent). Pre-rinse (with or without detergent). Pre-rinse deck and surrounding area with fresh cleaning surface with fresh water. If us- water. If using Kärcher Deck Wash, ap- ing Kärcher Pressure Wash or Degreas- ply to surface at low pressure. For best er, apply to surface at low pressure. For results, limit your work area to smaller best results, limit your work area to sections of approximately 25 square smalle
Summary of the content on the page No. 14
Barbecue Grills, Outdoor Power Recommendations Equipment & Gardening Tools Before cleaning any surface an in- conspicuous area should be cleaned (with or without detergent). Pre-rinse to test spray pattern and distance for cleaning surface with fresh water. If us- maximum cleaning results. ing Kärcher Pressure Wash or Degreas- er, apply detergent at low pressure. If painted surfaces are peeling or Allow Pressure Wash to remain on sur- chipping, use extreme caution as face 1-3 minutes. Do
Summary of the content on the page No. 15
OPTIONAL CLEANING ACCESSORIES Optional accessories are available to this extension kit. Includes 4 aluminum further enhance your cleaning capabili- sections for variable length. 66" fully as- ties. These accessories are accurate as sembled. Fits most Karcher pressure of the printing date of this manual. washers up to 2300 PSI. (bayonet) Please check our website for pricing Part No. 2.640-746.0 and up-to-date information. Pump Guard Rotating Wash Brush (bayonet) Specially formulated to protec
Summary of the content on the page No. 16
downspout, pull the trigger on the pres- T 100 Wide Area Surface Cleaner sure washer gun and watch as the noz- zle shoots out leaves and other debris For cleaning surfaces such as patios, while climbing upward. Connects direct- terraces and driveways without splash- ly to the trigger gun of most Karcher back, there is no better solution than pressure washers up to 2300 PSI. (bay- Karcher's T 100. It saves time by clean- onet) ing a one foot wide area gently as it hov- Part No. 2.640-747.0 ers,
Summary of the content on the page No. 17
TROUBLESHOOTING Disconnect the machine from the power CAUTION source before making any repair. Symptom Cause Solution Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I) (O) position. position Power cord is not plugged in. Plug in power cord. Electrical outlet does not Try a different outlet. supply adequate power. Tripped GFCI plug. Press “RESET” button on GFCI plug. Tripped circuit breaker. Switch off pressure washer. The reset comes automatically once the tem
Summary of the content on the page No. 18
Symptom Cause Solution No detergent. Detergent suction tube not Check connection. properly connected to the machine. Detergent is too thick. Dilute detergent, for best re- sults use Kärcher detergent. Filter on detergent suction Run warm water through filter tube is clogged. to remove debris. Damaged or clogged Remove obstruction or replace detergent suction tube. detergent suction tube. Spray wand is in high Turn spray wand tip to low pressure position. pressure position. Discharge nozzle
Summary of the content on the page No. 19
MANUAL DE USUARIO DEL LIMPIADOR DE ALTA PRESIÓN Vista general 20 Soporte Kärcher Mexico Instrucciones de seguridad impor- 21 - 22 Llame al: 01-800-024-13-13 si necesita tantes ayuda o visite nuestra página Web: Instrucciones de montaje 23 www.karcher.com.mx Instrucciones de funcionamiento 23 - 24 Utilización de los accesorios 25 Símbolos de aviso de seguridad Trabajar con detergentes 26 - 27 Tomarse un descanso 27 PELIGRO Apagado y limpieza 28 indica “una situación de peligro inmi- Protecció
Summary of the content on the page No. 20
VISTA GENERAL DEL MODELO 1 Cable de potencia con interruptor de 11 Interruptor de encendido/apagado circuito de avería por puesta a tierra 12 Pulverizador telescópico variable 2 Pistola de disparo 13 Dirtblaster® (pulverizador telescópi- 3 Pestillo de seguridad de la pistola de co rotatorio) disparo 14 Cepillo para lavar 4 Manguera de alta presión ATENCIÓN 5 Toma de agua con conector de man- Siga las instrucciones de mantenimien- guera de jardín (no ilustrada) to especificadas en el manual 6 A
