Summary of the content on the page No. 1
G 2650 OH
English 2
Español 16
Français 32
9.139-188.0 01/06
Summary of the content on the page No. 2
HIGH PRESSURE WASHER OPERATOR MANUAL Model Overview 3 Owner/User Responsibility Important Safety Instructions 4 The owner and/or user must have an Assembly Instructions 6 understanding of the manufacturer’s Operating Instructions 7 operating instructions and warnings be- Using the Accessories 8 fore using this pressure washer. Working with Detergents 9 Warning information should be empha- Taking a Break 10 sized and understood. Shutting Down & Clean-Up 10 If the operator is not fluent in Engli
Summary of the content on the page No. 3
MODEL OVERVIEW 1 Handle 8 Water inlet with garden hose con- nector 2 Trigger gun 9 High pressure outlet 3 Trigger gun safety lock 10 Detergent suction tube with filter 4 High pressure hose 11 Quick connect nozzles 5 Gas tank 12 Spark plug 6 Spray wand 13 Water inlet filter 7 Dipstick For engine details see engine manual. English 3
Summary of the content on the page No. 4
IMPORTANT SAFETY INSTRUCTIONS Read the operating instructions of Do not use acids, alkaline, solvents, the engine manufacturer before or any flammable material in this start-up and follow the safety instruc- product. These products can cause tions carefully. physical injuries to the operator and irreversible damage to the machine. WARNING WARNING When using this product basic pre- cautions should always be followed, Gun Kicks Back – Hold with both including the following: hands. Re
Summary of the content on the page No. 5
WATER SUPPLY (Cold Water Only) CAUTION When connecting the water inlet to the water supply mains, local regula- tions of your water company must be observed. In some areas the unit must not be connected directly to the public drinking water supply. This is to ensure that there is no feedback of chemicals into the water supply. Di- rect connection via a receiver tank or backflow preventer, for example, is permitted. Dirt in the feed water will damage the unit. To avoid this risk, we r
Summary of the content on the page No. 6
ASSEMBLY INSTRUCTIONS STEP 1: STEP 5: Attach the handle to the frame of the Attach the wand to the spray gun. pressure washer. Align holes, insert bolts, and tighten with knobs. STEP 6: Pull the spring-loaded collar of the wand back to insert your choice of STEP 2: quick connect nozzle. Fasten the rubber grommets in the nozzle holder. STEP 7: Release the collar and push the noz- STEP 3: zle until the collar clicks. Mount the nozzle holder and the gun/hose storage handle. WARNING Hig
Summary of the content on the page No. 7
STEP 8: Attach the high pressure hose to the spray gun. OPERATING INSTRUCTIONS STEP 6: CAUTION Unlock the Safety lock. Trigger the Do not run the engine with a high or low gun to eliminate trapped air, wait for oil level as this can cause engine dam- a steady flow of water to emerge age. from the spray nozzle. If you have further questions regarding STEP 7: the engine, please refer to the engine manual included with the unit. Pull the choke rod to the CLOSED STEP 1: position. Check o
Summary of the content on the page No. 8
USING THE ACCESSORIES 65° spray angle = Black detergent Quick connect nozzles nozzle 0° spray angle = Red nozzle For operating with detergent or cleaning For particularly stubborn accumulation with negligible pressure. of grime. Not recommended for soft materials like sidings, decks, painted surfaces, cars. 15° spray angle = yellow nozzle WARNING For dirt accumulation over a surface. High pressure in nozzle area. Risk of injury caused by improperly locked nozzle. Make sure you hear a ‘cl
Summary of the content on the page No. 9
WORKING WITH DETERGENTS Detergents can only be applied with the manufacturer. The use of other the black detergent nozzle. cleaning detergents may affect the op- eration of the machine and void the war- STEP 1: ranty. Install the black detergent nozzle for Always Use Kärcher Detergent for detergent application at low pres- Best Results sure. Kärcher biodegradable detergents are STEP 2: specially formulated to protect the envi- Fill a container with Kärcher deter- ronment and your pressure
Summary of the content on the page No. 10
TAKING A BREAK ..five minutes or more STEP 1: For engine details see engine manu- al. Engine with manual throttle: STEP 2: Move the throttle lever to the SLOW position. Allow the engine to idle for Release trigger and engage gun a few seconds, then move the throt- safety lock. tle lever to the STOP position. Engine with fixed throttle: Move the engine stop switch to the OFF position. SHUTTING DOWN & CLEAN-UP STEP 1: STEP 5: Remove detergent suction tube from Release trigger and engage gun
Summary of the content on the page No. 11
WINTERIZING AND LONG-TERM STORAGE 1: Disconnect all water connections. CAUTION 2: Turn on the machine for a few Failure to follow the above directions seconds, until the water which had will result in damage to the pump as- remained in the pump exits, turn off sembly and accessories. immediately. 3: Do not allow high pressure hose Kärcher also recommends the regular to become kinked. practice of using a pump protector like 4: Store the machine and accesso- “Kärcher Pump Guard” to he
Summary of the content on the page No. 12
CLEANING TIPS sweeping motion keeping the spray Deck Cleaning nozzle approximately 6 inches from the (with or without detergent). Pre-rinse cleaning surface. deck and surrounding area with fresh CAUTION water. If using Kärcher Deck Wash, ap- Do not use Dirtblaster spray nozzle ply to surface at low pressure. For best on siding as it may cause damage. results, limit your work area to smaller Cement Patios, Brick and Stone sections of approximately 25 square feet. Allow Deck Wash to rema
Summary of the content on the page No. 13
clean from top to bottom and from left to sults, clean from top to bottom and from right. For best results, wipe surface dry left to right. with a chamois or soft dry cloth. CAUTION CAUTION Do not use Dirtblaster spray nozzle Do not use Dirtblaster spray nozzle on patio or lawn furniture as it may on vehicles as it may cause damage. cause damage. Barbecue Grills, Outdoor Power Recommendations Equipment & Gardening Tools Before cleaning any surface an in- conspicuous area should be clea
Summary of the content on the page No. 14
TROUBLESHOOTING CAUTION Remove the spark plug cable to prevent accidental ignition of the engine before making any repair. Symptom Cause Solution Engine will not No gasoline Fill gas tank start Choke is not in the correct Slide choke lever out to position. closed position. Water pressure built up in the Squeeze the trigger to release machine. the pressure. For additional engine problems refer to the engine manual. Unit does not Diameter of garden hose is too Replace with a 5/8 inch or rea
Summary of the content on the page No. 15
Symptom Cause Solution No detergent. Detergent suction tube not prop- Check connection. erly connected to the machine. Detergent is too thick. Dilute detergent, for best re- sults use Kärcher detergent. Filter on detergent suction tube Run warm water through filter is clogged. to remove debris. Damaged or clogged detergent Remove obstruction or re- suction tube. place detergent suction tube. A high pressure nozzle is Replace with black detergent attached. nozzle. Spray nozzle is obstructed. B
Summary of the content on the page No. 16
MANUAL DE USUARIO DEL LIMPIADOR DE ALTA PRESIÓN Vista general del modelo 17 Responsabilidades del propieta- Importantes instrucciones de seguri-18 rio/usuario dad El propietario y/o el usuario deben com- Instrucciones de montaje 20 prender bien las instrucciones de servi- Instrucciones de funcionamiento 21 cio y advertencias del fabricante antes Utilicación de los accesorios 22 de empezar a utilizar este limpiador de Trabajar con detergentes 23 alta presión. Tomarse un descanso 24 Debe prestar
Summary of the content on the page No. 17
VISTA GENERAL DEL MODELO 1 Asa de transporte 9 Salida de alta presión 2 Pistola de disparo 10 Tubo de succión de detergente con filtro 3 Pestillo de seguridad de la pistola de disparo 11 Boquillas de conexión rápida 4 Manguera de alta presión 12 Enchufe de chispa 5 Depósito de gasolina 13 Dispositivo de filtrado en la entrada del agua 6 Barra pulverizadora Consulte el manual del motor para más 7 Varilla del aceite información sobre el motor. 8 Toma de agua con conector para manguera de jard
Summary of the content on the page No. 18
INSTRUCCIONES IMPORTANTES DE SEGURIDAD Antes de la puesta en marcha, leer No pulverizar sobre conexiones el manual de instrucción del fabri- eléctricas, enchufes o aparatos. cante del motor, especialmente las ADVERTENCIA indicaciones de seguridad. Riesgo de explosión - no pulverizar ADVERTENCIA sobre líquidos inflamables. Al utilizar este producto, tome siempre No usar ácidos, alcalinos, disolven- las precauciones básicas, incluidas las tes, o cualquier material inflamable siguiente
Summary of the content on the page No. 19
No tocar las superficies calientes o No usar la limpiadora de alta presión permitir a los accesorios que estén para agua contaminada con disol- en contacto con las superficies ca- ventes, por ejemplo para diluir pintu- lientes. ra, gasolina, aceite etc. No permitir a la manguera de alta Evitar que entren escombros en la presión que esté en contacto con la unidad, para ello use una fuente de cinta de protección. agua limpia. No dejar la máquina sin supervisión No utilizar la limpiadora
Summary of the content on the page No. 20
INSTRUCCIONES DE MONTAJE PASO 1: PASO 5: Conectar el mango al bastidor de la Conectar la barra con la pistola pul- limpiadora a presión. Alinear orifi- verizadora. cios, insertar pernos y apretar con la empuñadura. PASO 6: Colocar el cuello con resorte a la ba- rra para insertar la boquilla rápida de PASO 2: conexión elegida. Fije el ojal de goma. PASO 7: PASO 3: Soltar el cuello y empujar la boquilla Montar el soporte de la boquilla y el hasta que encaje. mango de almacenamiento de
