Summary of the content on the page No. 1
Summary of the content on the page No. 2
Keys and the Display Switches phone on/off when you press and hold. Adjusts volume of the earphone or handsfree speaker. PWR These keys perform Menu Memory the function shown on the display directly above them (e.g., here the keys are the “Menu” and CLR ABC “Memory” keys.) TALK END abc def 1 2 3 ghi jkl mno 4 5 6 pqrs tuv wxyz 7 8 9 0 # 9351330 PRINTED IN CANADA
Summary of the content on the page No. 3
A: SIM Card memory is in use OR B: The phone’s internal memory is in use. A call is in progress. A data call is in progress. The phone is in alpha mode. You have a voice message. You have a text message. If flashing, text memory is full. Memory location, menu, or option number. “AL”: Alternate Line is in use. AB D Battery charge. Signal strength. Menu Memory These words change; they determine the function of the keys below them (see previous page). ▲▼ scroll the menu and memories. Press and hold
Summary of the content on the page No. 4
Ê Ë Ì For Rapid Cigarette Lighter Charger and Rapid Travel Charger Power connector for Desktop Charger CHH-2/CHH-2L System and data connector for accessories and desktop chargers
Summary of the content on the page No. 5
Contents 1. Important Safety Information . . . . 1 Traffic Safety . . . . . . . . . . . . . . . . . . . . . 1 Operating Environment . . . . . . . . . . . . . . . 1 Emergency Calls . . . . . . . . . . . . . . . . . . 2 Using this Owner’s Manual . . . . . . . . . . . . . 3 FCC/INDUSTRY CANADA NOTICE . . . . . . . . . 4 2. The Battery and SIM Card . . . . 5 3. The Basics . . . . . . . . . . . . 11 Switching On or Off . . . . . . . . . . . . . . .
Summary of the content on the page No. 6
6. The Memory . . . . . . . . . . . 25 Alpha Mode . . . . . . . . . . . . . . . . . . . . 25 Storing Numbers and Names . . . . . . . . . . . 27 Notepad Memory Locations . . . . . . . . . . . 30 7. Touch Tones . . . . . . . . . . . 31 8. The Menu . . . . . . . . . . . . . 33 Menu Summary . . . . . . . . . . . . . . . . . . 34 Menu 01, Recent Calls . . . . . . . . . . . . . . 36 Menu 2, Messages . . . . . . . . . . . . . . . . 36 Menu 3, Call
Summary of the content on the page No. 7
1. Important Safety Information Traffic Safety Do not use a hand-held telephone while driving a vehicle. If using a hand-held telephone park the vehicle before conversing. Always secure the phone in its holder; do not place the phone on the passenger seat or where it can break loose in a collision or sudden stop. The use of an alert device to operate a vehicle’s lights or horn on public roads is not permitted. Remember road safety always comes first! Operating Environment Remember to follow any
Summary of the content on the page No. 8
Do not store or carry flammable liquids, gases or explosive materials in the same compartments as the phone, its parts or accessories. Only qualified personnel should install or service the phone in a vehicle. Faulty installation or service may be dangerous and may invalidate the warranty. Electronic fuel injection systems, electronic anti-skid braking systems, electronic cruise control systems and other electronic systems can malfunction due to the lack of protection from radio signals. Check r
Summary of the content on the page No. 9
When making an emergency call, remember to give all the necessary information as accurately as possible. Remember that your PCS1900 phone may be the only means of communication at the scene of an accident – do not cut off the call until given permission to do so. If certain features are in use (such as Key Lock), you may first need to turn those features off before you can make an emergency call. Consult this document and your local PCS1900 service provider. To Make an Emergency Call If phone
Summary of the content on the page No. 10
IMPORTANT! Use only accessories approved by the phone manufacturer. The use of any other types will invalidate any approval or warranty applying to the telephone, and may be dangerous. When you disconnect the power cord of an accessory, grasp and pull the plug, not the cord. FCC/INDUSTRY CANADA NOTICE Your phone may cause TV or radio interference (e.g. when using telephone in close proximity of receiving equipment). The FCC/Industry Canada can require you to stop using your telephone if such int
Summary of the content on the page No. 11
2. The Battery and SIM Card The Battery Your phone is powered by a rechargeable battery. Use only batteries approved by the phone manufacturer and recharge your battery only with the chargers approved by the manufacturer. See “Important Battery Information” later in this section. New batteries must be charged with the phone off for at least 24 hours before initial use. A new battery’s full performance is achieved only after two or three complete charge and discharge cycles! Note: See “Accessorie
Summary of the content on the page No. 12
Charging a New Battery or Recharging a Battery Connect the charger to the phone before plugging the charger into a standard 120V AC outlet. The battery segments scroll to show that the battery is charging. Allow the battery to completely charge. See the “Accessories” chapter for information on battery charging times. Charging is finished when the segments stop scrolling. When charging is finished, disconnect the charger from the AC outlet and from the phone. Using the phone near the network’s ba
Summary of the content on the page No. 13
eventually wear out. When the operating time is noticeably shorter than normal, it is time to buy a new battery. Battery Low/Recharge A You get this message and hear BATTERY two short beeps when a couple of LOW minutes of talk time remain. When no more battery power remains, you get another tone and the Menu Memory message RECHARGE BATTERY. The phone switches itself off. If the message NOT CHARGING is displayed, charging is suspended. Check that the battery is not overheated (over 104°F/40°C), t
Summary of the content on the page No. 14
Temperature extremes affect the ability of your battery to charge: it may require cooling or warming first. Do not short circuit the battery. Accidental short circuiting can occur when a metallic object (e.g. coin, clip, or pen) causes direct connection of the + and - terminals of the battery (metal strips on the back of the battery), for example when you carry a spare battery in your pocket or purse. Short circuiting the terminal may damage the battery or the connecting object. Use the battery
Summary of the content on the page No. 15
Installing the SIM Card Switch off the phone, wait for a few seconds, and remove the battery before installing or removing the SIM card. 2. Open the cover of the SIM Card reader and 3. open the SIM holder. 1. Slide the card into the holder. The beveled corner of the card faces up and you should be able to see the metal contacts. Close the holder by pushing it towards the phone. Pull the catch gently toward “Lock” (1). When you are sure that the holder is firmly engaged, slide the cover of the SI
Summary of the content on the page No. 16
The PIN2 code comes with some SIM cards and is required to access some functions, such as charging unit counters, which must be supported by the SIM card. If you enter a wrong PIN or PIN2 code three times in a row, that PIN or PIN2 code is disabled. You will be prompted for the PUK code (for the PIN) or the PUK2 code (for the PIN2) and a new PIN or PIN2 code. PUK and PUK2 Codes (at least 8 digits) The PUK (Personal Unblocking Key) is required to change a disabled PIN code. The PUK2 code is requi
Summary of the content on the page No. 17
3. The Basics Switching On or Off Press and hold theP button. When switching on, extend the antenna fully. As with any other radio transmitting device, avoid unnecessary contact with the antenna when the phone is switched PWR on. The phone displays a Reminder Note if you have programmed one with Menu 9 1. PressKeep to save it or Erase to delete it. The phone may also display a Welcome Message preprogrammed in your SIM card. If there is not a SIM card in the phone, you will be prompted to insert
Summary of the content on the page No. 18
Making a Call - Method 1 Note: WheneverFind appears at the bottom of the display, you can press ▼ or ▲ to scroll through stored numbers. B Number: TALK Find Quit After you key in the number you want to dial (at the Number: prompt), the phone dials the number. Making a Call - Method 2 Key in number, or recall stored TALK number Note: Check with your PCS1900 system operator for information about when you need to dial a ‘1’ and/or an area code in addition to the number. Answering a Call Press any k
Summary of the content on the page No. 19
Unlock Unlock To unlock, press theUnlock key then * . Note: With KEYS LOCKED, calls may be possible to the emergency number 911. Answering a Call with Key Lock Active TALK During the call the keypad remains unlocked. After you end the call, Key Lock becomes active again. Access Codes Your phone comes with a Security B Code of 12345. See the Security description of Menu 5, Security code: Options, for details on Security functions, including how to change the Security Code. OK Quit If you enter an
Summary of the content on the page No. 20
4. For Your Convenience. . . These extra features can simplify using your phone. On-Line Quick Guide Menu 14 contains on-line descriptions of 11 of the phone’s functions. Last Number Redial The display must be clear of names or numbers for this to TALK TALK work. To redial any of the last 10 dialed numbers, after you pressBB, press ▼ until you see the number you want. The phone dials the number after a few seconds. 1-Touch Dialing Press and hold key 2 to 8 for a abc def 1 2 3 few seconds until
