Casio 5089 user manual

Summary of the content on the page No. 1

MA0908-EA
Operation Guide 5089
Important!
Congratulations upon your selection of this CASIO watch.
• Keep the watch in an area normally exposed to bright light when storing it for long
periods. This helps to ensure that power does not run down.
This watch does not have a city code that corresponds to the UTC offset of –3.5
• Storing the watch for long periods in an area where there is no light or wearing it in
hours. Because of this, the radio-controlled atomic timekeeping function will n

Summary of the content on the page No. 2

Operation Guide 5089 Important! To perform manual receive • The areas covered by HNL and ANC are quite far from the calibration signal 1. In the Timekeeping Mode, keep A depressed (for about two seconds) as the transmitters, so certain conditions may cause reception problems. x Second Hand goes through the following sequence. • Moves to YES (or Y for some models) or NO (N) to indicate the last signal • When HNL or HKG is selected as the Home City, only the time and date are reception

Summary of the content on the page No. 3

Operation Guide 5089 To select a mode Note Press C to cycle between the modes as shown below. The v Left Dial Hand • After you specify a city code, the watch will use UTC* offsets to calculate the indicates the currently selected mode. World Time based on the current time in your Home City. • Selecting some city codes makes it possible for the watch to receive the time Timekeeping Mode C Stopwatch Mode calibration signal for the corresponding area automatically. * Coordinated Universal

Summary of the content on the page No. 4

Operation Guide 5089 Dec Checking the Current Time in a Different Time Zone 6. After you select the year ones digit, press C. Nov Jan • The x Second Hand will move to the currently You can use the World Time Mode to view the current time in one of 29 time selected month. This is the month setting Oct Feb zones around the globe. Each time zone has a “city code”, which is a three-letter mode. abbreviation of a representative city in the zone. The representative city of the time zone

Summary of the content on the page No. 5

Operation Guide 5089 Using the Alarm 5. After confirming that the n Right Dial Hands are in the correct home position, press C. This will advance to When the alarm is turned on, an alarm will sound for about 10 seconds each day v Left Dial Hand home position adjustment. when the time in the Timekeeping Mode reaches the preset alarm time. This is true • The v Left Dial Hand is in the correct home position if even if the watch is not in the Timekeeping Mode. it is pointing at 12 o’cloc

Summary of the content on the page No. 6

Operation Guide 5089 ■ ■The current time setting changes after I set it manually. City Code Table You may have the watch configured for Auto Receive of the time calibration signal, which will cause the time to be adjusted automatically according to your currently City UTC Offset/ City UTC Offset/ City City Code GMT Differential Code GMT Differential selected Home City. If this results in the wrong time setting, check your Home City setting and correct it, if necessary. PPG Pago Pago –11 JED