Summary of the content on the page No. 1
E
N
G
L
I
S
H
SUPER PHONE RINGER
MODEL SR100
User Guide
Summary of the content on the page No. 2
Table Of Contents Operation . . . . . . . . . . . . . .3 Safety Information . . . . . . . . .4 Installation . . . . . . . . . . . . .11 Warranty . . . . . . . . . . . . . .14 Your Satisfaction . . . . . . . . .15 Regulatory Compliance . . . .16
Summary of the content on the page No. 3
E N Operation G L 1. Select the ring pattern. I S 2. Adjust ringing tone. H 3. Adjust the volume. (When it is turned to OFF, light will still flash when phone rings.) xxx3
Summary of the content on the page No. 4
Important Safety Instructions When using your SR-100 Super Phone Ringer, basic safety precautions should always be followed to reduce the risk of fire, electric shock and persons including the following: 1. Read and understand all instructions. 2. Follow all warnings and instruction marked on the SR-100 Super Phone Ringer. 3. Do not use this SR-100 Super Phone Ringer near a bathtub, wash basin, kitchen sink or laundry tub, in a wet basement, near a swimming pool or anywhere else there is
Summary of the content on the page No. 5
E not use liquid cleaners or aerosol N cleaners on the product. Use a damp G cloth for cleaning. L 7. Place this ringer on a stable surface. I Serious damage and/or injury may S result if the telephone falls. H 8. Do not cover the slots and openings on this product. It should never be placed near or over a radiator or heat register. It should not be placed in a built-in installation unless proper ventilation is provided. 9. Operate this product using the electrical voltage as stated on
Summary of the content on the page No. 6
or electrical shock. 12. Never push any objects through the slots in the product. They can touch dangerous voltage points or short out parts that could result in a risk of fire or electrical shock. Never spill liquid of any kind on the product. 13. To reduce the risk of electrical shock, do not take this product apart. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the product is subsequently used. 14.
Summary of the content on the page No. 7
E rain or water. N D.If the product does not operate G normally by following the operating L instructions. Adjust only those controls I that are covered by the operating S instructions. Improper adjustment may H require extensive work by a qualified technician to restore the product to normal operation. E. If the ringer has been dropped or the case has been damaged. F. If the product exhibits a distinct change in performance. 15. Never install telephone wiring during a lightning sto
Summary of the content on the page No. 8
18. Use caution when installing or modifying telephone lines. 19. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions. ADDITIONAL SAFETY NOTES FOR CANADIAN USERS The following items are included as part of the CS-03 Requirements. The standard connecting arrangement for the equipment is CA11A. This product meets the applicable Industry Canada technical spec
Summary of the content on the page No. 9
E requirements. The Department does not N guarantee that the equipment will operate to G the user’s satisfaction. Before installing this L equipment, users should ensure that it is I permissible to be connected to the facilities of S the local telecommunications company. The H equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be extended by means of a certified connector ass
Summary of the content on the page No. 10
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The Ringer Equivalent Number is an indication of the maximum numbe
Summary of the content on the page No. 11
E N Installation G L 1. Unplug the telephone line from I your telephone. S H 2. Plug the telephone line into the LINE jack of the Super Phone Ringer. xxx11
Summary of the content on the page No. 12
Installation 3. Connect one end of the cord provided with the unit into the PHONE jack of the Super Phone Ringer and the other end into your telephone. 12xxx
Summary of the content on the page No. 13
E N G L I S H Connecting the Phone Ringer: For wall mounting, use two screws, three inches apart, or use heavy-duty double- xxx13 sided tape.
Summary of the content on the page No. 14
Warranty Ameriphone will repair or replace your Super Phone Ringer for one year from the date of purchase if the unit is defective in workmanship or materials. Proof of purchase is required. After the one-year warranty period, Ameriphone will repair your unit at a minimal charge. For further information on either in-warranty or out-of-warranty repairs, contact customer service @ 800.874.3005 14xxx
Summary of the content on the page No. 15
E N Your Satisfaction G L Your satisfaction with our I products is very important to S H us. We would like to know what you like or dislike about this product and what we can do to make this product even more beneficial to you. Please give us your comments by calling our Customer Service Department at (800) 874- 3005. We value your comments and thank you again. 15
Summary of the content on the page No. 16
Regulatory Compliance Part 68 of FCC Rules Information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. A plug and jack used to connect this SR-100 Ringer to the premises wiring and telephone network must comply with the applicable FCC Part 68 ru
Summary of the content on the page No. 17
E N installation instructions for details. G L The REN is used to determine the number of I devices that may be connected to a S telephone line. Excessive RENs on a H telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. For products approved after J
Summary of the content on the page No. 18
will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advanc
Summary of the content on the page No. 19
E N G the equipment until the problem is resolved. L I DO NOT DISASSEMBLE THIS EQUIPMENT. S H This telephone equipment is not intended to be repaired and it contains no repairable parts. Opening the equipment or any attempt to perform repairs will void the warranty. For service or repairs, call 1-800- 874-3005.Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information. If your
Summary of the content on the page No. 20
will disable alarm equipment, consult your telephone company or a qualified installer. This telephone equipment is hearing aid compatible. We recommend the installation of an AC surge arrester in the AC outlet to which this equipment is connected. The telephone companies report that electrical surges, typically lighting transients, are very destructive to customer terminal equipment connected to AC power sources. 20xxx
