Summary of the content on the page No. 1
Daily ........................................................................... 5
Pedometer With 7-Day Memory
Target ......................................................................... 6
(Model: PE823)
Timer .......................................................................... 6
Pedometer With Pulse Meter Memory ...................................................................... 7
View Total Weekly Records ..................................... 7
(Model: PE826)
View Daily Records
Summary of the content on the page No. 2
PE826 – FRONT AND BACK VIEW INTRODUCTION TM Thank you for selecting an Oregon Scientific pedometer (PE823 / PE826 / PE828 / PE829). These unique products are ideal for monitoring your exercise routine. The pedometer counts the number of steps taken from one location to another, calculating the total distance covered and calories expended. Other key functions include target step / distance / calories, 7-day memory function, estimated target finish time and keypad lock function. Keep this manual h
Summary of the content on the page No. 3
1. LCD screen 2. MODE / SET button 3. / button 4. RESET / / / button 5. / button 6. Belt clip 7. Battery door 8. Pulse meter 9. Pulse rate button 10. LED light button 11. LED light 12. Panic alarm pin PE829 – FRONT AND BACK VIEW 13. Fastening clip and chord 14. Selects radio channel 15. Radio ON 16. / Scan up and down FM frequency 17. Increase and decrease volume 18. Radio OFF 19. Talk button 20. Earphone jack 3 PE82X_M_EN_V2.p65 3 2005.7.19, 12:16 PM EN
Summary of the content on the page No. 4
LCD GETTING STARTED SET UP You must set up the device (as shown below) when you first activate the unit, reset it or change the batteries, or your pedometer will not work properly. 1. To activate the device, pull out the insulation tape underneath the battery cover. (For PE828, insert batteries.) 2. Set the clock and user profile (see Clock / User Profile section). 3. PE826 only – Calibrate the stress index baseline (see 1. Shows when in Target Mode Pulse Meter / Stress Index section). 2. Shows
Summary of the content on the page No. 5
2. Frequent up and down movements, such as standing DAILY up and/or sitting down; running, jumping, or ascending/ To view the step, distance and calorie display: descending stairs or steep slopes. 1. Press MODE to navigate to Daily USEFUL TIPS Mode. When changing settings you can: • Press and hold / to speed through the setting options. 2. Press to switch between the 3 displays; • Press SET to bypass or confirm a setting and move on to the next one. STEP During setting mode, if a key is not
Summary of the content on the page No. 6
2. While you are walking, the ESTIMATED FINISH TIME TARGET (EFT) will periodically appear to advise you how long To set step, distance or calorie target: it will take to complete your target, based on your current pace. The target bar at the bottom of the display 1. Press MODE to navigate to Target will move from left to right (start to finish) to show your progress. Mode. 3. Press to toggle between the EFT and remaining steps, distance or calories left until target is reached. 4. When target w
Summary of the content on the page No. 7
2. Press and hold SET for 2 seconds to enter setting 2. Press to toggle between the total weekly step, mode. distance and calorie display. 3. Press / to select countdown or count-up timer and press SET. If the countdown timer is selected you VIEW DAILY RECORDS will need to set the hr:min:sec by pressing / to 1. Press MODE to navigate to Memory Mode. change a value and SET to confirm. 2. Press to enter the daily record display. To use timer: 3. Press repeatedly until you reach the day you
Summary of the content on the page No. 8
CLOCK The bar at the bottom of the display will indicate • 12/24hr format which day’s memory record you are looking at. •Hour •Minute CLEAR ALL RECORDS • Day of the week Press and hold RESET. USER PROFILE CLOCK / USER PROFILE • Upper pulse limit (PE826 only) ST • Lower pulse limit (PE826 only) TO SET THE USER PROFILE FOR 1 TIME •Weight unit USE OR AFTER A BATTERY CHANGE •Weight When the installation tape is removed to activate the •Stride unit pedometer and whenever the batteries are changed, t
Summary of the content on the page No. 9
5. The setting sequence is: CHANGE INDIVIDUAL CLOCK OR USER •Hour • Minute • On / Off PROFILE SETTINGS To stop the alarm sound, press any key If after the initial setting of the clock / user profile (as detailed in previous section), you wish to change the clock time or edit one of the user profile settings, simply: PULSE METER / STRESS INDEX (AVAILABLE IN PE826 ONLY) 1. Press MODE to navigate to Clock or User Profile Mode. For first-time use, or after replacing a battery or 2. Profile Mode onl
Summary of the content on the page No. 10
4. Relax and put the 5. The LCD will display your stress level as follows: tip of your thumb or ICON BAR COLOR MEANING index finger on the pulse sensor. Green Relaxed Yellow Normal Red Not relaxed 5. Wait for about 10 seconds until the word FINISH appears on the LCD panel. Retry if failed (if no reading is showing within 1 6. Repeat 3-5 if the minute the pedometer will escape from pulse mode). You calibration fails. then press pulse rate button again. TIPS • Cold fingertips and cold air can af
Summary of the content on the page No. 11
A large heart rate variation is an indication that the One new 12V battery can last for approx. 15 parasympathetic nervous system has a predominance, minutes if the panic alarm is activated. It is recommended which generally corresponds to someone in a relaxed that you quickly test the alarm function every time you state. use the pedometer. As for a smaller value, it indicates that the sympathetic nervous system is active, which is related to physical or FM RADIO (AVAILABLE IN PE829 ONLY) menta
Summary of the content on the page No. 12
To change the volume level, press . • Pacer ON / OFF. If ON is selected you will need to set the pacer frequency which ranges from 45 to 180 To listen to a stored channel, press CH. beeps per minute. This function helps you maintain Prolonged use of the FM Radio will significantly the pace of your walk / run, as each beep represents one step. reduce battery life. • Languages available – English, French and Spanish OR English, Italian and German. TALK FUNCTION (AVAILABLE IN PE829 The radio funct
Summary of the content on the page No. 13
PE829 PE823 / PE826 To change the battery: To change the battery: 1. Gently press down on button with a blunt stylus to 1. Gently press down on button with a blunt stylus to release battery compartment. release battery compartment. 2. Insert 1 x CR2032 battery. 2. Insert 2 x CR2032 batteries. 3. Gently push back the battery compartment. 3. Gently push back the battery compartment. PE828 WARNINGS This product is designed to give you years of service if handled properly. Observe the following guid
Summary of the content on the page No. 14
• Do not use rechargeable batteries with this product. Dimensions – without clip (W x H x D) and weight • Remove the batteries if storing this product for a long period of time. PE823 2.1 x 1.9 x 1.0 inches • Do not scratch the LCD display. (52 x 47 x 25 mm) 33 g (1.16 ounces) The contents of this user manual and technical specifications are subject to change without further notice. PE826 2.4 x 2.2 x 1.0 inches Images not drawn to scale. (60.3 x 54.9 x 24 mm) 38 g (1.34 ounces) SPECIFICATIONS PE
Summary of the content on the page No. 15
ABOUT OREGON SCIENTIFIC EC-DECLARATION OF CONFORMITY Visit our website (www.oregonscientific.com) to learn more Hereby, Oregon Scientific, declares that this pedometer about Oregon Scientific products such as digital cameras; model PE823 / PE826 / PE828 / PE829 is in compliance MP3 players; children’s electronic learning products and with the essential requirements and other relevant games; projection clocks; health and fitness gear; weather provisions of EMC directive 89 / 336 / CE and LVD dire
