Summary of the content on the page No. 1
Keep this manual for future reference. If you sell this stroller or
give it away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
SATURN STROLLER
Operating Instructions
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you
have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F,
8:00 a.m. – 5:00 p.m. C.T. or visit us at www.instep.net or E-mail us at inf
Summary of the content on the page No. 2
IMPORTANT We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with your selection. We regret that although great care and effort have been taken, occasionally problems may occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer questions, please contact us at either our Toll-Free Customer Service number or E-mail us at our address listed below. Service will be quicker if you have your model
Summary of the content on the page No. 3
Step 2. Rear Wheel Assembly A3 Turn stroller onto its side. Grasp rear wheel in one hand, slide wheel’s axle into hole in rear of frame (Figure B1). Check to see that the wheel is properly Side Latches inserted by pulling on the wheel firmly, the wheel should not come off if fully inserted/locked. Repeat for other side. To release wheel push up on axle release lever while pulling off wheel (Figure B2). To engage rear brakes: Step lightly on the side brake levers or rear brake bar to engage brakes
Summary of the content on the page No. 4
Step 3. Front Wheel Assembly C1 Turn stroller upright onto its rear wheels, then tip Front Wheel Post stroller back so the handlebar is down on the ground and the front is up. Slide the front wheel assembly onto the front wheel post, push until the wheel assembly locks into place (Figure C1). Check to see that the wheel assembly is properly inserted by pulling on the wheel firmly. To remove wheel push on release tab and pull off wheel (Figure C2). To lock the front wheel from turning: Push down o
Summary of the content on the page No. 5
Step 5. Installing Child Tray E Position tray as shown with the levers open, when aligned close both levers to lock in place (Figure E). To remove open both levers and pull off. Note the child tray can not be used when using the car seat adapter bar. Child Tray Step 6. Installing Parent’s Convenience Levers Tray Snap parent tray onto the handlebar aligning the tray’s holes with the handlebar’s knobs (Figure F). Step 7. Adjusting Handle Height While pushing both handle buttons in, rotate handle
Summary of the content on the page No. 6
To recline seat: I To fully recline, unhook buckle on back of the seat (Figure I). To place seat in upright position, push seat forward Rear Recline Strap and reconnect buckle located on back of seat. Extra webbing can be placed in the rear pouch so it does not hang down and drag. To adjust the recline position, adjust the buckle on the strap. WARNING: Child may slip into leg openings and strangle. Never use in a reclined car- riage position unless the T-shield and shoulder straps have been read
Summary of the content on the page No. 7
Mounting infant car seat onto the J3 adapter bar Note: The stroller seat should be in the full recline Car Seat Locking position with the recline strap unbuckled prior to Mounting Notch placing car seat on. With the car seat adapter bar installed on the stroller, position the infant car seat (WITHOUT CHILD) so its mounting notch aligns with bar. The car seat will be mounted rearward facing towards the handle of the stroller. Push firmly down on the car seat so the bar is in contact Adapter Bar wi
Summary of the content on the page No. 8
If you are unable to securely attach the infant car seat, discontinue use and contact our Customer Service representative. Please refer to the infant car seat manufacturers instruction’s and warnings for harnessing your child in the car seat. Do not lift stroller by using the infant car seat handle. Care and Maintenance Check fasteners After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary. Periodically check the stroller to ensure that it is in good operati
