Summary of the content on the page No. 1
Super Turf Renovator
& Seedbox
STR48S-2
STR60S-2
STR72S-2
Tested. Proven. Unbeatable.
MAN0101
Rev. 3/09/2010
OPERATOR'S MANUAL
Summary of the content on the page No. 2
TO THE DEALER: ® Assembly and proper installation of this product is the responsibility of the Woods dealer. Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Operator’s Manual are completed before releasing equipment to the owner. The dealer must complete the online Product Registration form at the Woods Dealer Website which certifies that all Dealer Check List items have been completed. Please contact your dealer to com
Summary of the content on the page No. 3
TABLE OF CONTENTS INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 SAFETY RULES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 SAFETY DECALS . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
SPECIFICATIONS Super Turf Renovator STR48S STR60S STR72S Working Width 47" 59" 71" Overall Width 58" 70" 82" Roller Pins 1/2" x 1-3/4" 1/2" x 1-3/4" 1/2" x 1-3/4" Bearing (Self-Aligning) Six 1" Six 1" Six 1" Front Roller Positions Adjustable for Increased Agitation Roller Diameter: Front & Rear 8" 8" 8" Hitch Cat. I Cat. I Cat. I Tractor HP Requirement 65 HP Max. 65 HP Max. 65 HP Max. Weight STR48: 565 lbs. STR60: 710 lbs. STR72: 855 lbs. Weight w/Seedbox STR48S: 820 lbs. STR60S: 920 lbs. STR72S
Summary of the content on the page No. 5
SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! fastened. Falling off power unit can result in death Safety is a primary concern in the design and from being run over or crushed. Keep foldable manufacture of our products. Unfortunately, our ROPS system in “locked up” position at all times. efforts to provide safe equipment can be wiped Make sure all safety decals are installed. out by an operator’s single careless act. Replace if damaged. (See Safety Decals section for In additio
Summary of the content on the page No. 6
SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! (Safety Rules continued from previous page) Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear Watch for hidden hazards on the terrain during sturdy, rough-soled work shoes and protective operation. equipment for eyes, hair, hands, hearing, and head; Stop power unit and equipment immediately and respirator or filter mask where appropriate. upon striking an obstruction. Turn off engine, r
Summary of the content on the page No. 7
SAFETY & INSTRUCTIONAL DECALS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged! MODEL NO. SERIAL NO. Woods Equipment Company Oregon, Illinois, U.S.A. 3 - Serial Number Plate 6 - PN 20106 Red Reflector 9 - PN 24611 Slow Moving Vehicle 4 - PN 15502 WARNING 5 - PN 18868 ROTATING COMPONENTS Do not operate without cover in place. Look and listen for rotation. Do not DANGER open cover until all components have stopped. SHIELD MISSING Do not operate. CONTACT WITH ROTATI
Summary of the content on the page No. 8
SAFETY & INSTRUCTIONAL DECALS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged! (Safety Decals continued from previous page) WARNING FALLING OFF CAN RESULT IN BEING RUN OVER. Tractor must be equipped with ROPS (or ROPS CAB) and seat belt. Keep foldable ROPS systems in “locked up” position at all times. Buckle Up! Keep seat belt securely fastened. Allow no riders. RAISED IMPLEMENT CAN DROP AND CRUSH. Never go underneath raised implement which can drop from equ
Summary of the content on the page No. 9
OPERATION The operator is responsible for the safe operation of this renovator. The operator must be properly trained. Operators should be familiar with the equipment, the tractor, and all safety practices before starting opera- tion. Read the safety rules and safety decals on page 5 through page 8. Recommended tractor ground speed is from 2 to 5 mph. Power unit must be equipped with ROPS or ROPS cab and seat belt. Keep seat belt securely fastened. Falling off power unit can result in
Summary of the content on the page No. 10
adjusted to deliver the desired down pressure and 1. Attach the tractor’s lower lift arms to the renovator roller action and achieve the desired seedbed appear- and secure with mounting pins (11) and klik pins. ance. See Figure 4. When the situation permits, making a second pass 90- degrees to the first is an effective way for the roller pins to penetrate areas where uneven soil conditions exist. In extremely compacted soil conditions, add extra weight to the renovator to help the roller pins pe
Summary of the content on the page No. 11
6. Install lock assembly (5), lock pin (15), and klik pin Adjust Front Roller Angle (21) to secure front roller into position. 1. Position tractor and renovator on a level surface. 7. Reverse this procedure to move front roller back 2. Raise renovator slightly off the ground. into normal position. 3. Stop engine and set parking brake. 4. Remove klik pin (21), lock pin (15), and lock Seeding Operation assembly (5) from front of renovator. See Figure 6. Tractor speed and seed flow settings are cri
Summary of the content on the page No. 12
Operating Tips Pre-Operation Check List (OWNER’S RESPONSIBILITY) IMPORTANT ___ Review and follow all safety rules and safety ■ Before closing down the cup (reducing rates), decal instructions on page 5 through page 8. the operator should make certain that the cups are not full of seed. If cups are full of seed (especially ___ Check that equipment is properly and securely small, round, hard seed), it may be necessary to attached to tractor. cover the meter holes and run seeder a short dis- ___ C
Summary of the content on the page No. 13
MAN0101 (Rev. 9/15/2006) Operation 13 SEEDING RATE CHART Alfalfa Bermuda Blue Grass Clover Fescue Italian Rye Timothy (uncoated) (hulled) (Kentucky) (sweet, red) (creeping red) Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Lbs per Setting 1000 Sq Ft Acre 1000 Sq Ft Acre 1000 Sq Ft Acre 1000 Sq Ft Acre 1000 Sq Ft Acre 1000 Sq Ft Acre 1000 Sq Ft Acre 1000 Sq Ft Acre 1/4 Open* 1-1/4 52 1-1/4 52 1/2 22 1-1/2 67 1/2 18 1-1/4 5
Summary of the content on the page No. 14
OWNER SERVICE The information in this section is written for operators who possess basic mechanical skills. If you need help, your dealer has trained service technicians available. For your protection, read and follow the safety informa- tion in this manual. A NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak-down, hydraulic system failures, mechanical failures,
Summary of the content on the page No. 15
ASSEMBLY DEALER SET-UP INSTRUCTIONS Assembly of this equipment is the responsibility of the Woods dealer. It should be delivered to the owner com- 12 pletely assembled, lubricated, and adjusted for normal 15 operating conditions. In most cases the Super Turf Renovator is shipped completely assembled from the factory. The seed box is an option that can be added to the Super Turf Reno- vator at a later time if desired. Install Seedbox 1. Place seedbox on top of renovator mounting 12 saddles. 13 2.
Summary of the content on the page No. 16
5. Slide idler bracket assembly forward to apply tension to the horizontal drive chain. 6. Slide idler and spring bracket down to apply tension to the vertical drive chain. NOTE: Do not over tighten. Allow some slack in chain. Idler Bracket Assembly 7. Adjust opposite side of roller to level. 30 31 A 30 31 Idler Bracket Assembly DP14 Figure 14. Idler Bracket Assembly Installed Install Roller Chains 1. Place roller chain (A - 35 link) around the seed box sprocket and the large inner sprocket on
Summary of the content on the page No. 17
PARTS INDEX Super Turf Renovator & Seedbox Kit STR48S-2 STR60S-2 STR72S-2 Main Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18 - 19 Seedbox Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . .20 - 21 Drive Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Quick Hitch Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 MAN0101 (Rev. 9/15/2006) Parts 17
Summary of the content on the page No. 18
STR48S-2, STR60S-2 & STR72S-2 MAIN ASSEMBLY 18 Parts MAN0101 (Rev. 9/15/2006)
Summary of the content on the page No. 19
STR48S-2, STR60S-2 & STR72S-2 MAIN ASSEMBLY PARTS LIST REF STR 48-2 STR 60-2 STR72-2 QTY DESCRIPTION 1 ………… ………… ………… 1 STR Frame 2 1000778 1000778 1000778 1 Rear roller arm, right 3 1000779 1000779 1000779 1 Rear roller arm, left 4 D2213 D2213 D2213 4 Bushing, 0.88 ID 5 1002912 1001716 1001716 1 Lock assembly 6 1001984 1001984 1001984 2 Spring pin, .75 x 11.8 7 20A125 20A125 20A125 2 Compression spring 8 20A920 20A920 20A920 6 Bearing w/housing 9 46483 46483 46483 2 Sleeve, .82 x 1.05 x .66 10
Summary of the content on the page No. 20
STR48-2, STR60S-2 & STR72S-2 SEEDBOX ASSEMBLY 20 Parts MAN0101 (Rev. 9/15/2006)
