Summary of the content on the page No. 1
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
DIRECT VENT MULTI-OPEN
®
ELITE SERIES
WARNINGS
VENTED GAS FIREPLACE HEATERS - DIRECT VENT MODELS
• Hot! Do not touch! The glass and
P/N 875,022M REV. C 03/2007
surfaces of this appliance will be hot
MODELS
during operation and will retain heat
for a while after shutting off the appli-
ance. Severe burns may result.Ms illivolt Models Electronic Model
• Carefully supervise children in the
EM DVSTNMEE DVCRNEE DVSTN EDVCRN
same room as appliance.
EM D
Summary of the content on the page No. 2
CONGRATULATIONS! WARNING: ELECTRONIC MODELS OF THESE APPLIANCES ARE EQUIPPED In selecting this LENNOX Direct-Vent Gas Appliance you have chosen the finest and most WITH A THREE-PRONG (GROUNDING) dependable fireplace to be found anywhere. Its a beautiful, prestigious alternative to a PLUG UTILIZED IN CONNECTING THE wood burning fireplace. Welcome to a Family of tens of thousands of satisfied LENNOX ELECTRONIC COMPONENTS TO THE Fireplace Owners. JUNCTION BOX IN THE LOWER COM- PARTMENT. THIS GRO
Summary of the content on the page No. 3
To open the control compartment access panel, The following table shows the units' orifice size WARNING: FAILURE TO COMPLY WITH actuate the spring-loaded magnetic catches for the elevations indicated. THE INSTALLATION AND OPERATING IN- securing the panel. First, depress the outer top STRUCTIONS PROVIDED IN THIS DOCU- right corner of the panel until the catch "pops" Elevation MENT WILL RESULT IN AN IMPROP- Orifice size Model the door free. Then, gently pull the door forward Feet ERLY INSTALLED
Summary of the content on the page No. 4
O I O L I P T O IGNITER OFF ON CONTROL it TPTH TP TH L I P F LO F 5. Always keep the appliance area clear and Variable Flame Height Adjustment Inlet Pressure Port free from combustible materials, gasoline and Manifold Pressure Port other flammable liquids. 6. Remember, Millivolt appliances have a con- tinuous burning pilot flame. Exercise caution when using products with combustible vapors. Glass Cleaning It will be necessary to clean the glass periodically. Main Gas During start-up it is normal
Summary of the content on the page No. 5
Maintenance Schedule Annually (Before the onset of the Burning Season) Maintenance Task Accomplishing Person Procedure Inspecting/Cleaning Burner, Logs Qualified Service Technician Inspect valve and ensure it is properly operat- and Controls ing. Check piping for leaks. Vacuum the con- trol compartment, fireplace logs and burner area. Check Flame Patterns and Flame Height Qualified Service Technician Refer to Figure 6 on page 7 and verify that the flame pattern and height displayed by the applia
Summary of the content on the page No. 6
3. Remove the bottom control compartment Sooting is indicated by black puffs developing WARNING: HANDLE THE GLASS WITH access panel by compressing the spring-loaded at the tips of very long orange flames. Sooting EXTREME CARE! DO NOT STRIKE hinge pin on the left side until it disengages results in black deposits forming on the logs, DOOR. TEMPERED GLASS IS SUSCEP- from the left cabinet corner post hole. Pull the appliance inside surfaces and on exterior sur- TIBLE TO DAMAGE (SCRATCHES, FOR pan
Summary of the content on the page No. 7
Operate the appliance for a period of time as the effect diminishes, ensuring that the appliance does not develop sooty flames. When satisfied that the appliance operates prop- erly, proceed to finish the installation. Leave the control knob in “ON” position and turn the remote switch “OFF.” Close the lower control compartment access panel. Log Placement WARNING: LOG SET GETS VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOG SET Glowing Embers (Ro
Summary of the content on the page No. 8
TH TH TP TP Electronic Appliance Checkout Electronic Wiring Diagram (Honeywell) Electronic Wiring Diagram (Honeywell) To light the burner, refer to the lighting instruc- Showing the Blower Wiring for the Optional Showing the Blower Wiring for the Optional tions on page 14 and 15. Ensure the ignitor FBK-100 and FBK-200 Kits FBK-250 Kits lights the pilot. The pilot flame should engulf 1. If any of the original wire as supplied must be replaced, 1. If any of the original wire as supplied must be r
Summary of the content on the page No. 9
ACCESSORY COMPONENTS Door Frame Kits A decorative door frame kit is available for use with these appliances. The DTK is designed to attach directly to the front face of the appli- ance at its extreme edges. The DTK provides a picture frame finish for the appliance. The door frame kit can be retrofitted onto previ- ously installed appliances. Twin-Pane Door Trim Kits Polished Brass - 40 inch 20M83 TPDK-40PB Brushed Stainless - 40 inch 20M86 TPDK-40BS Polished Brass and Brushed Stainless Door Fra
Summary of the content on the page No. 10
ACCESSORY COMPONENTS CONTINUED Remote Control System (Deluxe) H0251 RCL-T Remote Control System (Standard) H0249 RCL Flame Modulating Remote Control – Natural Gas H0301 RCL-MN Deluxe Remote Control System Standard Remote Control System Flame Modulating Remote Control – LP/Propane Gas H0302 RCL-ML The Model RCL-T (Deluxe) Remote Control The Model RCL (Standard) Remote Control System has all of the features of the standard Flame Modulating Remote Control System, features a simplistic on/off contr
Summary of the content on the page No. 11
ACCESSORY COMPONENTS CONTINUED Charcoal Finish Louvers Kits Decorative louvers are available for use with all Multi-Open Series appliances. These louvers are designed to replace the standard radiant panels that are provided with the appliance. These kits include a charcoal finish top 3-piece assembly and a bottom 3-piece assembly. These kits can be retrofitted to previously installed appliances. Charcoal Finish Louver Assembly Kits (3-piece Top and 3-piece Bottom Assembly) CATALOG NO. / MODEL NO
Summary of the content on the page No. 12
ACCESSORY COMPONENTS CONTINUED 2-Piece Polished Brass and Brushed Stainless Louvers Kits Decorative louvers are available for use with all Multi-Open Series appliances. These louvers are designed to replace either the middle char- coal louver of each set or the charcoal louver in each set closest to the glass door. These kits include two narrow louvers. They provide a touch of elegance to any Multi-Open Series appliance. These kits can be retrofitted to Screen Panel Kit previously installed ap
Summary of the content on the page No. 13
ACCESSORY COMPONENTS CONTINUED Bricaded Panel Liner Kits Catalog No. Model No. Model No. H0778 EDVPF EBLK-PF H0779 EDVST EBLK-ST H0780 EDVCL EBLK-CL H0779 H0781 EDVCR (Top Vent) EBLK-CR The brickaded liner kits include ceramic panels as shown here. The panels have brick-like fea- tures in relief. H0780 & H0781 H0778 (Top Vent) (Top Vent) H0779 (Rear Vent) H0778 H0780 & H0781 (Rear Vent) (Rear Vent) NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 13
Summary of the content on the page No. 14
ACCESSORY COMPONENTS CONTINUED Style View Doors - Style View Doors come in 4 beautiful styles. They are easy to install and will not require hardware to attach them to the standard glass door frame. The door includes heavy duty magnet door latches and functional twin-pane doors. Arch Design Square Design Arch Pane Design Square Pane Design ARCH DESIGN KITS SQUARE DESIGN KITS Cat. No. Model Description Model Series Cat. No. Model Description Model Series H0862 AD40C 40” Arch Doors, Charcoal H0950
Summary of the content on the page No. 15
ACCESSORY COMPONENTS CONTINUED Style View Doors Continued - Style View Doors also come in a Tall Arch Pane Design. Two distinctive grille kits, the “Crescents” and “Sunrise” design, are also offered seperately. They are easy to install and will not require hardware to attach them to the standard glass door frame. The door includes heavy duty magnet door latches and functional twin-pane doors. TALL ARCH PANE DOORS Cat. No. Model Description Model Series H3529 TAPD40C 40” Arch Pane Doors, Charcoa
Summary of the content on the page No. 16
I O O L I P T O it TPTH TP TH L I P F L F O LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo • Do not use any phone in your building. ignitor. When lighting the pilot, follow these instructions • Immediately call your gas supplier from a neighbor’s phone.
Summary of the content on the page No. 17
I O O L I P T O it TPTH TP TH L I P F L F O INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Cet appareil est muni d’une veilleuse qui doit être allumée avec un • Appelez immédiatement votre compagnie de gaz en utilisant le téléphone
Summary of the content on the page No. 18
IGNITER OFF ON CONTROL LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions • Immediately call your gas supplier from a neighbor’s exactly. phone. • If your gas supplier cannot be reached, call the fire B. BEFORE OPERATING smell all around the appliance area department. for g
Summary of the content on the page No. 19
IGNITER OFF ON CONTROL INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Lorsque vous allumez l’appareil, suivez exactement ces instruc- • Appelez immédiatement votre compagnie de gaz en utilisant tions. le téléphone du voisin. • S’il vous est
Summary of the content on the page No. 20
TROUBLESHOOTING THE MILLIVOLT GAS CONTROL SYSTEM Note: Before troubleshooting, make sure that the appliance main line gas shut-off valve and the gas control valve are in the "OPEN" position and the burner ON/OFF switch is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1. Spark ignitor will not light A. Defective ignitor Check for spark at electrode and pilot; if no spark and p
