Summary of the content on the page No. 1
DO NOT
DISCARD
Owner’s Manual
Installation and Operation
Models:
RED40
RED40ST
NOTICE
DO NOT DISCARD THIS MANUAL
• Important operating • Read, understand and follow • Leave this manual with
and maintenance these instructions for safe
party responsible for use
instructions included. installation and operation.
and operation.
WARNING
WARNING: If the information in these
HOT SURFACES!
instructions is not followed exactly, a fi re
Glass and other surfaces are hot during
or explosion may result
Summary of the content on the page No. 2
Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. This owner’s manual should be retained for future A. Congratulations reference. We suggest that you keep it with your other Congratulations on selecting a Heat & Glo gas fi replace, an important documents and product manuals. elegant and clean alternative to wood burning fi replaces. The information contained in this owner’s manual, unless The Heat & Glo gas fi replace you h
Summary of the content on the page No. 3
Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Used to address practices not related to personal injury. Table of Contents A. Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
13 Finishing A. Splatter Guard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 B. Framing and Finishing Instructions . . . . . . . . . . . . . . . . . 52 C. Mantel and Wall Projections . . . . . . . . . . . . . . . . . . . . . . . 54 D. Facing Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 E. Mesh Fronts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58 14 Appliance Setup A. Remove Fixed Glass Assembly . . . . . . . .
Summary of the content on the page No. 5
B. Limited Lifetime Warranty Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within
Summary of the content on the page No. 6
B. Limited Lifetime Warranty (continued) WARRANTY CONDITIONS: WARRANTY EXCLUSIONS: - - - - - This warranty is void if: LIMITATIONS OF LIABILITY: 4021-645C 12-29-10 Page 2 of 2 6 Heat & Glo • RED40, RED40ST • 2155-900 Rev. o • 7/12
Summary of the content on the page No. 7
Listing and Code Approvals 1 1 A. Appliance Certifi cation C. BTU Specifi cations Minimum Orifi ce Maximum Models MODEL: RED40, RED40ST Input Size Input BTU/h (U.S. or Canada) BTU/h (DMS) LABORATORY: Underwriters Laboratories, Inc. (UL) US TYPE: Vented Gas Fireplace Heater 34,000 24,000 #34 RED40 (0-2000 FT) RED40ST STANDARD: ANSI Z21.88b-2008 CSA 2.33a-2008 CANADA (NG) 29,500 22,000 #36 Vented Gas Fireplace Heaters (2000-4500 FT) US 34,000 25,000 #50 RED40 (0-2000 FT) This product is list
Summary of the content on the page No. 8
Inspection Note: The following requirements reference various The state or local gas inspector of the side wall horizon- Massachusetts and national codes not contained in this tally vented gas fueled equipment shall not approve the document. installation unless, upon inspection, the inspector ob- serves carbon monoxide detectors and signage installed H. Requirements for the Commonwealth of in accordance with the provisions of 248 CMR 5.08(2)(a)1 Massachusetts through 4. For all side wall
Summary of the content on the page No. 9
CLEAR SPACE 3 FT. IN FRONT OF FIREPLACE User Guide Operating Instructions 2 2 • Install a switch lock or a wall/remote control with child A. Gas Fireplace Safety protection lockout feature. • Keep remote controls out of reach of children. WARNING • Never leave children alone near a hot fi replace, whether HOT SURFACES! operating or cooling down. Glass and other surfaces are hot during operation AND cool down. • Teach children to NEVER touch the fi replace. Hot glass will cause burns. • Co
Summary of the content on the page No. 10
D. Decorative Doors and Fronts G. Before Lighting Fireplace WARNING! Risk of Fire! Install ONLY doors or fronts Before operating this fi replace for the fi rst time, have a approved by Hearth & Home Technologies. Unapproved qualifi ed service technician: doors or fronts may cause fi replace to overheat. • Verify all shipping materials have been removed from This appliance has been supplied with an integral inside and/or underneath the fi rebox. barrier to prevent direct contact with the fi xed glass
Summary of the content on the page No. 11
H. Lighting Instructions (IPI) FOR YOUR SAFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS (IPI) WARNING: If you do not follow these instructions exactly, a fi re or explosion 1. This appliance is equipped with an ignition may result causing property damage, personal injury or loss of life. device which automatically lights the burner. DO NOT try to light the burner by hand. • Immediately call your gas supplier A. This appliance is equipped with an from a neighbor’s phone. Follow the interm
Summary of the content on the page No. 12
I. After Fireplace is Lit Initial Break-in Procedure • The fireplace should be run three to four hours continuously on high. • Turn the fi replace off and allow it to completely cool. • Remove fi xed glass assembly. See Section 14.H. • Clean fi xed glass assembly. See Section 3. • Replace the fi xed glass assembly and run continuously on high an additional 12 hours. This cures the materials used to manufacture the fi re- place. NOTICE! Open windows for air circulation during fi re- place break-in. •
Summary of the content on the page No. 13
Maintenance and Service 3 3 Doors, Surrounds, Fronts Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace. Frequency: Annually By: Homeowner When properly maintained, your fi replace will give you many years of trouble-free service. We recommend an- Tools needed: Protective gloves, stable work surface nual service by a qualifi ed service technician. • Assess condition of screen and replace as necessary. A. Maintenance Tasks-Homeowner • Ins
Summary of the content on the page No. 14
Venting • Remove all foreign objects. • Verify unobstructed air circulation. Frequency: Seasonally By: Homeowner Burner Ignition and Operation Tools needed: Protective gloves and safety glasses. Frequency: Annually • Inspect venting and termination cap for blockage or By: Qualifi ed Service Technician obstruction such plants, bird nests, leaves, snow, debris, Tools needed: Protective gloves, vacuum cleaner, whisk etc. broom, fl ashlight, voltmeter, indexed drill bit set, and a • Verify term
Summary of the content on the page No. 15
Installer Guide Getting Started 4 4 A. Typical Appliance System NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual HORIZONTAL TERMINATION CAP (SECTION 7) WALL PENETRATION FRAMING (SECTION 8B) VERTICAL TERMINATION CAP (SECTION 10.I) CONVECTION DUCTING (SECTION 9.C) NON-COMBUSTIBLE ROOF FLASHING MAINTAINS MINIMUM CLEARANCE AROUND PIPE STORM COLLAR (
Summary of the content on the page No. 16
B. Design and Installation Considerations D. Inspect Appliance and Components Heat & Glo direct vent gas appliances are designed to • Carefully remove the appliance and components from operate with all combustion air siphoned from outside of the packaging. the building and all exhaust gases expelled to the outside. • The vent system components and decorative doors and No additional outside air source is required. fronts may be shipped in separate packages. Installation MUST comply with loca
Summary of the content on the page No. 17
Framing and Clearances 5 5 NOTICE: Illustrations refl ect typical installations and are A. Selecting Appliance Location FOR DESIGN PURPOSES ONLY. Illustrations/diagrams When selecting a location for the appliance it is important to are not drawn to scale. Actual installation may vary due to consider the required clearances to walls (see Figure 5.1). individual design preference. WARNING! Risk of Fire or Burns! Provide adequate It is important to follow the framing and fi nishing instruc-
Summary of the content on the page No. 18
Note: Consider installation of the active con- vection blower when determining appliance location. See Section 9.C for more detailed information. C 1/2 IN. A B 1/2 IN. C AB C Inches 48 17-1/4 36 Millimeters 1218 438 914 Figure 5.2 Appliance Locations RED40ST 18 Heat & Glo • RED40, RED40ST • 2155-900 Rev. o • 7/12
Summary of the content on the page No. 19
B. Constructing the Appliance Chase C. Clearances A chase is a vertical box-like structure built to enclose the NOTICE: Install appliance on hard metal or wood surfaces gas appliance and/or its vent system. In cooler climates extending full width and depth. DO NOT install directly the vent should enclosed inside the chase. on carpeting, vinyl, tile or any combustible material other than wood. NOTICE: Treatment of ceiling fi restops and wall shield fi restops and construction of the chase may v
Summary of the content on the page No. 20
A MEASURE FROM TOP OF FIREPLACE OPENING E F B J C H G D I MINIMUM FRAMING DIMENSIONS* AB C D E F G H I J Rough Rough Rough Rough Clearance Combustible Combustible Behind Sides of Front of Opening Opening Opening Opening to Ceiling Floor Flooring Appliance Appliance Appliance (Vent Pipe) (Height) (Depth) (Width) Inches 10 46-3/4 18-1/4 50-1/4 31 0 0 1 1 36 254 1187 464 1276 787 0 0 25 25 914 Millimeters Figure 5.4. Clearances to Combustibles-RED40 MEASURE FROM TOP OF FIREPLACE OPENING A E F C
