Hearth and Home Technologies WTBC36DB user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
REFRACTORIES FOR CB & CD SERIES
WTBC36BB and WTBC42BB - B-vent Refractory
WTBC36DB and WTBC42DB - Direct Vent Refractory
These refractories are intended for use with the Caliber CB Series B-Vent and CD Series Direct Vent gas appliances. Refer to the installa-
tion instructions supplied with the appliance for the correct accessories to be used. If you encounter any problems regarding code approv-
als or if you need clarifi cation of the instructions contained here, cont

Summary of the content on the page No. 2

REFRACTORY - CB & CD SERIES INSTALLATION INSTRUCTIONS 1. Shut off the electricity to the appliance and turn the gas shutoff valve to the closed position. See Figure 1. Remove the screen and glass from the appliance. OFF Figure 3 - Remove Rear Log 4. Carefully install a side refractory. Tip the bottom edge into posi- tion, and swing the top up. This will hold the back refractory in Figure 1 - Gas Shutoff Valve place. See Figure 4. 2. Lift the two top logs off the log set. See Figure 2. 3. Rem

Summary of the content on the page No. 3

REFRACTORY - CB & CD SERIES INSTALLATION INSTRUCTIONS 6. Direct Vent 7. Repeat Step 4 to install the other side refractory piece. Place the back refractory into position and slide the side edge 8. Adjust the back and sides so no gaps are visible in the corners of the back refractory behind the side refractory. This will hold where the pieces come together. the back refractory in place. See Figure 6. 9. Tighten screws. 10. Reinstall the rear log, grate/log assembly, glass panel assembly and sc

Summary of the content on the page No. 4

REFRACTORY - CB & CD SERIES INSTALLATION INSTRUCTIONS 4 4040-227 Rev B 12/05