Summary of the content on the page No. 1
VENTED DECORATIVE NATURAL GAS LOGS
OWNER’S OPERATION AND
INSTALLATION MANUAL
For more information, visit www.desatech.com
TESTED AND
LISTED BY
RGA 2-72 Approved
Models: PHK-18/24/30; BCS18/24/30
WARNING: Improper installation,
WARNING: If the information in this manual is not fol-
adjustment, alteration, service,
lowed exactly, a fi re or explosion may result causing
or maintenance can cause injury
property damage, personal injury, or loss of life.
or property damage. Refer to this
manual f
Summary of the content on the page No. 2
TABLE OF CONTENTS SAFETY INFORMATION 2 TABLE OF CONTENTS SAFETY INFORMATION ..............................................................2 TECHNICAL SERVICE ................................................................8 PRODUCT IDENTIFICATION ......................................................3 REPLACEMENT PARTS ..............................................................8 LOCAL CODES ............................................................................3 TROUBLESHOOTING .........
Summary of the content on the page No. 3
SAFETY INFORMATION 3 PRODUCT IDENTIFICATION LOCAL CODES UNPACKING 3 SAFETY INFORMATION LOCAL CODES Continued Install and use log set with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel 10. The installation and provisions for combustion and ventilation air Gas Code ANSI Z223.1/NFPA 54*. must conform with the National Fuel Gas Code, ANSI Z233.1/ *Available from: NFPA 54, Section 5.3, Air for Combustion and Ventilation. 11. Do not run log
Summary of the content on the page No. 4
INSTALLATION Flue Opening Specifi cations Check Gas Type Venting Specifi cations for Installation 4 INSTALLATION Burner BTU Input Minimum Vent Model CAUTION: Do not remove the data plates attached Description (Natural Gas) Opening to the burner pan. The data plates contain important PHK/ BCS 18 18" Ramp 57,000 8" warranty information. PHK/ BCS 24 24" Ramp 80,000 8" WARNING: Before installing in a solid fuel burning PHK/ BCS 30 30" Ramp 90,000 8" fi replace, the chimney fl ue and fi rebox must b
Summary of the content on the page No. 5
INSTALLATION 5 Installing Damper Clamp Connecting to Gas Supply 5 INSTALLATION Continued Installation must include a equipment shutoff valve, union, and INSTALLING DAMPER CLAMP plugged 1/8" NPT tap. Locate NPT tap within reach for test gauge Secure the damper stop clamp provided to the leading edge of the hook up. NPT tap must be upstream from log set (see Figure 4). damper as shown in Figure 3. If for any reason this clamp doesn't IMPORTANT: Install equipment shutoff valve in an accessible
Summary of the content on the page No. 6
INSTALLATION Checking Gas Connections Hearth Kit Assembly and Installation 6 INSTALLATION Continued HEARTH KIT ASSEMBLY AND INSTALLATION CHECKING GAS CONNECTIONS Kit Assembly - Ramp Pan Burner WARNING: Test all gas piping and connections, 1. Determine which side the gas line feeds into the fi replace. This internal and external to unit, for leaks after installing logset is factory set up for right side (facing) gas feed. If your or servicing. Correct all leaks at once. gas line is on the
Summary of the content on the page No. 7
INSTALLATION 7 Testing Burner for Leaks Adding Pan Material Installing the Grate and Logs 7 INSTALLATION Continued TESTING BURNER FOR LEAKS 1. Generously apply noncorrosive leak detection fl uid to all connections. WARNING: Never check for gas leaks with open fl ame. 2. Light the burner with the shutoff valve no more than half open and holding a match slightly in front of the pan (see Lighting Instructions, page 10). 3. Inspect all connections for bubbles, raw gas odor, or fl ame from any are
Summary of the content on the page No. 8
OPERATING APPLIANCE CLEANING AND MAINTENANCE For Your Safety Read Before Lighting REPLACEMENT PARTS Lighting Instructions TECHNICAL SERVICE 8 Gas Shutoff Valve Operation Curing Logs CURING OPERATING APPLIANCE LOGS FOR YOUR SAFETY During the 2-3 hour appliance break-in period, you may detect READ BEFORE LIGHTING an odor from the appliance as the various paints and compounds used in the manufacturing of this log set cure. This is a normal and temporary situation that is not cause for alarm. Ho
Summary of the content on the page No. 9
SERVICE HINTS 9 TROUBLESHOOTING 9 SERVICE HINTS When Gas Pressure is Too Low pilot will not stay lit • burners will have delayed ignition • heater will not produce specifi ed heat • propane/LP gas supply may be low You may feel your gas pressure is too low. If so, contact your local propane/LP or natural gas supplier. TROUBLESHOOTING WARNING: Turn off log set and let cool before servicing. Only a qualifi ed service person should service and repair log set. Note: All troubleshooting items are
Summary of the content on the page No. 10
TROUBLESHOOTING 10 TROUBLESHOOTING Continued WARNING: If you smell gas Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fi re department. IMPORTANT: Operating log set where impurities in air exist may create odors. Cleaning supplies, paint, paint remover,
Summary of the content on the page No. 11
ACCESSORIES 11 11 ACCESSORIES Purchase these log set accessories from your local dealer. If they DECORATIVE ASH BED CONTROL COVER can not supply these accessories, call DESA at 1-866-672-6040 CDABKA (Not Shown) for referral information. You can also write to the address listed An attractive way to cover control knob and piezo ignitor. on the back page of this manual. 18" ORNAMENTAL GRATE ENHANCER GA9350A (Not Shown) For 18" models only. Additional decoration for front grate. 24" ORNAMENTAL
Summary of the content on the page No. 12
ILLUSTRATED PARTS BREAKDOWN Models: PHK-18/24/30; BCS18/24/30 12 ILLUSTRATED PARTS BREAKDOWN Models: PHK-18/24/30; BCS18/24/30 ( Number and style of logs vary by model ) 21 23 10 22 24 19 8 15 18 20 17 12 7 16 6 14 13 9 3 11 1 2 4 5 For more information, visit www.desatech.com 115425-01
Summary of the content on the page No. 13
PARTS LIST 13 Models: PHK-18/24/30; BCS18/24/30 13 PARTS LIST This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 12 of this manual. Key No. Part Number Description Qty. PHK/BCS 18 PHK/BCS 24 PHK/BCS 30 1 1 14325 14325 14325 3/8 FLR x 1/2 FPT Elbow 1 2 901059-01 901059-01 901059-01 3/8 FLR x 3/8 FPT Adaptor 1 3 901232-01 901232-01 901232-01 Gas Line - 12" Aluminum 1 4 104506-27 104506-28 104506-29 Natur
Summary of the content on the page No. 14
OWNER'S REGISTRATION FORM In order to provide better customer service for this and future purchases, we recommend that you register your product with us. You can register online at www.desatech.com. If access to our website is not available to you, please complete this Owner's 14 Registration Form and mail to the address on the back of this owner's manual. Please provide the following product information: Brand: (Comfort Glow, Van
Summary of the content on the page No. 15
15 15 Postage Required 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004 For more information, visit www.desatech.com 115425-01 TAPE TAPE
Summary of the content on the page No. 16
16 WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifi cations at any time without notice. The only warranty applicable is our standard written warranty. We make no other warranty, expressed or implied. LIMITED WARRANTY - VENTED GAS LOGS DESA warrants this product to be free from defects for a lifetime, provided that the product has been properly installed,
