Summary of the content on the page No. 1
A1228di_dsiUGcover.qxp 8/16/00 1:36 PM Page 2
User’s Guide
User’s Guide
Mobile Phone
Mobile Phone
Mobile Phone
A1228di
A1228di
A1228di
A1228dsi
A1228dsi
A1228dsi
Summary of the content on the page No. 2
9/99 This manual is published by Ericsson Inc., without any warranty. Improvements and changes to this manual due to typographical errors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by Ericsson Inc. at any time and without notice. Such changes w
Summary of the content on the page No. 3
International Calls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Connecting and Removing Your Battery . . . . . . . . . . . . . .1 Charging Your Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
! Problems and Possible Solutions . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
Not for commercial use – Ericsson Inc.
Summary of the content on the page No. 5
4 Then, lift the battery up and out of the battery % & ' cavity. Note! You can find your phone’s model number by removing the battery and looking on the back of the phone. 1 Place the battery over the back of the phone. The label on the battery should face down. Insert the top portion of the battery into the % ' phone. The tab on the bottom of the battery should be
Summary of the content on the page No. 6
3 Hold the small plug on the charger cord so the lightning bolt
If your phone is off, attaching the charger will cause the phone to symbol ( ) is up. activate in charge-only mode. When this mode is activated the 4 Align the small plug on the charger cord with the connector on message Charging Only appears in the display. Your phone is the bottom of your phone. The connector on the phone is above now fast (rapid)
Summary of the content on the page No. 7
CLR
Your Ericsson mobile phone is dual-band, tri mode for TDMA The following is a list of the terms used in this user’s guide to systems. It operates in three modes – two digital ( ) modes (800 describe your Ericsson mobile phone: and 1900 MHz frequency bands) and one analog ( ) (800 MHz range) mode. 1 Antenna 1 2 Upper Side Key (" 3Lower Side Key 2 4Earpiece 3 •25 Ring t
Summary of the content on the page No. 8
)'* Press to move through menus and menu setting selections when your phone is in menu mode, or to scroll through stored numbers when you are recalling numbers from your Press to answer a call. phonebook. Press to access last dialed number from the Standby screen. Press to scroll through messages one line at a time when Press to send a call after entering a phone number. viewing text messages. Press to store menu setting
Summary of the content on the page No. 9
+ ', + ' 1 Voice Mail Waiting Icon indicates 1 23 4 The following are common display messages on your mobile phone: the number of voice mail messages Your phone is receiving a call. that have not been read. 2 New Text Mail Icon indicates the number of text messages that have not been read. 8 7 6 5 Your phone is dialing the 3 Ringer Off ()/Silent Mode () number shown in the display. Icon indicates that
Summary of the content on the page No. 10
!
The number of calls you have The PHONEBOOK Menu not answered. tab that is accessed by pressing once from the Standby screen. Press to select. The microphone is muted. The MESSAGES Menu tab that is accessed by pressing twice from the Standby screen. Press to select. The keypad is locked to prevent inadvertent key presses. The CALL INFO Menu tab that is accessed by pressing three times from the The phone
Summary of the content on the page No. 11
"
!" '" - "" Turn your phone Off by pressing and holding until your phone Turn your phone On or Off Press and hold sounds a beep and turns off. Turn your phone On by pressing and Answer a call holding until your phone sounds a beep and turns on. End a call Increase/decrease ear volume during a call Either side key .% Access the main menu
Summary of the content on the page No. 12
#
& / % .% % % Your telephone temporarily stores numbers you have previously You can make calling card calls from your phone by doing the called. To view these numbers, press from the Standby screen. following: The last number you called is shown in the display. Press or to 1 Press from the Standby screen to access the main menu. scroll through the other numbers. You can pl
Summary of the content on the page No. 13
$
For example, if your office has a voice mail system that requires you & to dial a phone number, followed by your extension, followed by an The Received submenu allows you to display the list of read and access code, you could enter the following: unread text messages you have received. The subject line or the first 555-1111 2222 33333. few words of each message, is displayed. Press to view the When you press , your
Summary of the content on the page No. 14
Note! To send a message, you must enter a 10-digit number (unless Auto Note! Update allows you to replace a previously sent message if the Prefix is enabled). recipient has not yet read the original message and has a phone that supports this option. If the previously sent message was already read, then the updated message appears as a new message
to the recipient. Canned Message allows you to use the 10 editable te
Summary of the content on the page No. 15
options? before you send a message. You will be given the option to alter your preferences. The Delivery Receipt submenu allows you to receive notification when your message is delivered to the destination address. The two options for Delivery Receipt are On or Off. The Priority submenu allows you to set delivery priority for your message. The three options for Priority are Normal, Urgent (+), and !"
Summary of the content on the page No. 16
3 Press
to select Add Entry. 1 % 4 Press or to scroll to the name and number line. See the next section to learn how to enter names in your phonebook. When your phone receives a call, the ring tone sounds, Incoming Call appears in the 5 Press to store the new entry. display, and the display and keypad backlight # ' are illuminated. (you can disable the ring tone through the SETTINGS
Summary of the content on the page No. 17
- '&- 1 '1 To temporarily mute the ring tone without answering the call, press The low battery alert sounds when your battery is reaching its lowest or the upper or lower side volume key. Incoming Call is still operational power level. The words Low Battery! will appear in shown in the display, and you can still answer the call by pressing the display. When this happens, leave you
Summary of the content on the page No. 18
7 Press to return to the previous screen or press to return to & the Standby screen. To select the ring sound for your mobile phone: 1 Press from the Standby screen to access the main menu. # '% 2 Press to display the SETTINGS Menu. Your phone was programmed with an emergency number (911) 3 Press
to display the Sounds submenu. when it was manufactured. The programmed emergency number
Summary of the content on the page No. 19
1 Press from the Standby screen to access the main menu. ' + /1 .* 2 Press to display the SETTINGS Menu. 3 Press to display the Phone Number submenu. /1 . 4 Press the or repeatedly until the appropriate number Your phone should be configured by your service provider for assignment module is highlighted. optimal network selection during roaming. If you want and your 5 When the appropri
Summary of the content on the page No. 20
!
() + ' #3 The phone does not Recharge or replace the battery. The signal is too weak to make a call. Try again when turn On. the signal strength is one bar or stronger. The phone is not Check for Ringer Off ( ) or Silent Mode ( ) ringing when a call icons on the Standby screen. is received. The battery does Your battery is fully charged when the power The ba
