Summary of the content on the page No. 1
Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan weight with
light kit included
For 5NCR56 Series Fans
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans
Summary of the content on the page No. 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1996), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections, t
Summary of the content on the page No. 3
7 8 9 Align hole in downrod with hole in Install cotter pin into cross pin. Tighten the 2 set screws on the yoke yoke and install cross pin. once the downrod is in place. Then tighten locking nut. 10 11 12 Push yoke cover down. Attach blade brackets to blades using the Install 4 Max. 25 watt candelabra blade bracket screws and washers provid- base bulbs into the sockets on top of ed. the fan as shown. 14 13 15 Install upper glass to top of fan. Install 3 screws and clips to hold Mounting brack
Summary of the content on the page No. 4
20 21 19 Remote Transmitter Dip swtiches Remote Receiver Dip switches Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the Raise fan with downrod assembled to units will communcate properly. If you have other fans you the ceiling bracket and hang fan can set to control from one transmitter by setting both With the bracket shut (see # 23) start the two assembly. Be sure to rotate the receivers the same as the transmitter. If you have mor
Summary of the content on the page No. 5
31 33 32 Replace inspection plate from light kit Install the 2x50 watt halogen bulbs. Find tabs on light kit pan. Align the pan. Do not touch bulb glass surface as indentions on glass with tabs lift oily residue from skin can cause the glass and twist till glass is secure. bulb to explode. 35 36 34 AC 120V input white black white black ground black black Warning! Hook up In Series Only. Do Attach front cover to wall control Install wall control unit to outlet box not connect to hot and common
Summary of the content on the page No. 6
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleaning
