Summary of the content on the page No. 1
Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan weight
For 5DOR52 Series Fans
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans
Summary of the content on the page No. 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1. 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. 3. After making the wire connections,
Summary of the content on the page No. 3
7 8 9 Set screws Secure mounting neck to the mounting plate Loosen two set screws holding half ball, slide Lift mounting neck to mounting Plate and align screws. with four screws to become a complete mount- down ball and remove pin. Remove the ball. ing bracket. 10 12 11 Insert cotter pin in to cross pin to secure. Thread leadwire and safety cable through Loosen the 2 set screws in the yoke. Insert downrod and half ball. downrod into yoke, aligning large hole in the downrod with the large hole i
Summary of the content on the page No. 4
19 20 21 AC 120 V input black white white black green ground Remote Transmitter Dip swtiches green ground Remote Receiver Dip switches Set dip switches on the Remote Transmitter and Remote Make wire connections to power source using Receiver to the same settings. This must be done so the wire nuts provided. Make sure that no filiments units will communcate properly. If you have other fans you are outside of the wirenut. After making the Make wiring connections as shown black wire can set to c
Summary of the content on the page No. 5
33 31 32 Fan speed control Light dimmer buttons for lights Fan reverse Fan on / off button To control fan speed select from High, Medium or low speed buttons. To turn the fan off press the Fan on / off button. To dim lights press and Attach front cover to wall control hold button. To turn off light press and quickly Install wall control unit to outlet box release button. Press button marked REV to with screws provided. using machine screws provided. reverse the rotation direction of the fan
Summary of the content on the page No. 6
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin
