Summary of the content on the page No. 1
READ AND SAVE THESE INSTRUCTIONS
Fan Blades
Not Included
Ceiling Fan Owner's Manual
™ ™
PREMIUM CROWN
SELECT SELECT
Model Numbers Model Numbers
CF4801AB00 CF4501AP00
CF4801AP00 CF4501GBZ00
CF4801BS00 CF4501GES00
CF4801CK00 CF4501VNB00
CF4801GBZ00
CF4801GES00
CF4801ORB00
CF4801VNB00
CF4801WW00
Net Weight: 23.8 Lbs.
Part No. F40BP74470000 Form No. BP7447
U.L. Model No.: CF4801 and CF4501
Summary of the content on the page No. 2
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
Summary of the content on the page No. 3
This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. 14 One Phillips head screwdriver One stepladder 50-100 ft. 12 One wire stripper MATERIALS ! WARNING Wiring outlet box and box connectors must be of Before assembly your ceiling fan, refer to section type required by the local code. The minimum wire on proper method of wiring your fan (page 8). If y
Summary of the content on the page No. 4
Electrical Requirements Your new ceiling fan will require a grounded electrical ! WARNING supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and Turning off wall switch is not sufficient. To avoid capable of withstanding a load of at least 50 pounds. possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and ! WARNING Local codes and the ceiling fan must be properly
Summary of the content on the page No. 5
How to Put Your Ceiling Fan Together (continued) 6. Install the setscrew (supplied in loose parts bag) in the motor coupling and tighten using the 5/32" setscrew wrench (supplied) (Figure 3). 7. Screw two 1” threaded studs (provided) into the DOWNROD motor (Figure 4). Leave approximately 7/8” of the stud extending above the motor. Slide the motor cover over the downrod and rotate the cover until SETSCREW the threaded studs protrude; install two knurled knobs (supplied) to secure the cover. NOTE:
Summary of the content on the page No. 6
How to Put Your Ceiling Fan Together (continued) 11.Use four #10-24 x 12mm pan head screws and #10-24 x 12mm PAN HEAD BLADE SCREW (4) flat washers (supplied) to secure flange to blade (Figure 6). Repeat for the remaining four blades. FLAT WASHER (4) Illustration may not show the exact flange you are installing. FAN BLADE (Sold Separately) 12.Use the 10 round recessed holes in the motor hub marked with "5" and install the five blade assemblies (ordered separately) in accordance with Step 13. BLA
Summary of the content on the page No. 7
How to Hang Your Ceiling Fan ! WARNING CEILING The fan must be hung with at least 7' of clearance from floor to blades (Figure 9). ! AT LEAST WARNING 7' The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support of 22.7 FLOOR kg. (50 lbs.) or less”. Figure 9 ! WARNING To reduce the risk of fire, electrical shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 22.7
Summary of the content on the page No. 8
How to Wire Your Ceiling Fan If you feel that you do not have enough electrical EMERSON FAN CONTROL wiring knowledge or experience, have your fan installed by a licensed electrician. LISTED OUTLET BOX BLACK FAN WIRE ! BLACK LIGHT WARNING RED BLACK GREEN WIRE CONTROL (HOT) (GROUND) To avoid possible electrical shock, be sure electricity FROM TO 120 HANGER is turned off at the main fuse box before wiring. VOLT BRACKET SUPPLY NOTE: If you are not sure if the outlet box is WHITE grounded, contac
Summary of the content on the page No. 9
Using Your Ceiling Fan 1. Screw three 25-watt (maximum) candelabra base lamps (supplied) into the uplight sockets on top of the fan housing assembly (Figure 14). 25-WATT (Max.) CANDELABRA UPLIGHT 2. Slide the large pendant onto the the speed control BASE LAMPS (3) SOCKETS (3) pull chain, secure by connecting the coupling to the chain. Slide the pendant onto the accent light pull chain, secure by connecting the coupling to the chain. (Figure 15). 3. Assembly of the ceiling fan is now complete.
Summary of the content on the page No. 10
Attaching Optional Light Kit To install an Emerson accessory light kit, remove the ! WARNING three screws securing the switch cup assembly to the fan, remove the switch cup assembly, and disconnect To avoid possible electrical shock, be sure electricity the connector. Remove the screw plug from the is turned off at the main service box before wiring. bottom of the switch cup and install the light kit in accordance with the Emerson light kit Owner's Manual. Maintenance IMPORTANT CARE INSTRUCTIONS
Summary of the content on the page No. 11
Trouble Shooting WARNING: For your own safety, turn off power at fuse box or circuit breaker before trouble shooting your fan. ! TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1.Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. ! WARNING: Make sure main power is turned off. 2.Loose power line connections to the fan, 2. Check line wire connections to fan and or loose switch wire connections in the switch wire connections in the switch s
Summary of the content on the page No. 12
Repair Parts 2 1 3 16 6 14 15 18 17 13 18 32 31 28 24 5 4 27 23 21 22 7 8 29 9 30 19 10 26 33 25 12 12 11 20 11 12 U.L. Model No.: CF4801 and CF4501
Summary of the content on the page No. 13
Crown Select Repair Parts Listing Crown Select Series Ref. No. Description CF4501AP00 CF4501GBZ00 CF4501GES00 CF4501VNB00 Hanger Pack, 761655-34 761655-77 761655-35 761655-89 containing: 1 Bracket, Hanger (1) — — — — 2 Hanger Ball Assembly (1) — — — — 3 Downrod (1) — — — — 6 Cover, Ceiling 761620-AP 761620-GBZ 761620-GES 761620-VNB 7 Hub, Rubber 760601 760601 760601 760601 8 Blade Assembly ** * * (Full set for one fan) 9 Flange Set 764162-AP 764162-GBZ 764162-GES 764162-VNB (Full set for one fan
Summary of the content on the page No. 14
Premium Select Repair Parts Listing Premium Select Series Ref. No. Description CF4801AB00 CF4801AP00 CF4801BS00 CF4801CK00 CF4801GBZ Hanger Pack, 761655-3 761655-34 761655-17 761655-23 761655-77 containing: 1 Bracket, Hanger (1) — — — — — 2 Hanger Ball Assembly (1) — — — — — 3 Downrod (1) — — — — — 6 Cover, Ceiling 761620-AB 761620-AP 761620-BS 761620-CK 761620-GBZ 7 Hub, Rubber 760601 760601 760601 760601 760601 8 Blade Assembly ** * * * (Full set for one fan) 9 Flange Set 764164-AB 764164-AP 7
Summary of the content on the page No. 15
Premium Select Repair Parts Listing Premium Select Series Ref. No. Description CF4801GES00 CF4801ORB00 CF4801VNB00 CF4801WW00 Hanger Pack, 761655-35 761655-32 761655-89 761655 containing: 1 Bracket, Hanger (1) — — — — 2 Hanger Ball Assembly (1) — — — — 3 Downrod (1) — — — — 6 Cover, Ceiling 761620-GES 761620-ORB 761620-VNB 761620-WW 7 Hub, Rubber 760601 760601 760601 760601 8 Blade Assembly ** * * (Full set for one fan) 9 Flange Set 764164-GES 764164-ORB 764164-VNB 764164-WW (Full set for one fa
Summary of the content on the page No. 16
LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for the lifetime of your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your
