Summary of the content on the page No. 1
1
Summary of the content on the page No. 2
IMPORTANT SAFETY INSTRUCTIONS Warning When using electrical appliances, basic safety precautions to reduce the risk of fire, electric shock or injury to persons should be followed, including: 1.READ ALL INSTRUCTIONS BEFORE USING THIS WATER HEATER. 2.This water heater must be grounded. Connect only to properly grounded outlet. Use only the 3 prong plug that comes with the water heater. Do not use an adapter to bypass the ground connection. 3.Install or locate this water heater only in accordan
Summary of the content on the page No. 3
DIMENSIONS FOR P10 S / P15 S MOD A B C D E P10 S 14" 10 1/4" 14" 3 1/2" 6 1/8" P15 S 14" 12 1/4" 14" 3" 6 1/8" General Remarks Caution The manufacturer cannot be responsible for the damages caused by improper installation or by failure to follow instructions in this pamphlet. Comply with the installation instructions before completing electric connection. Caution The thermostat has been pre-set at the factory to about 60°C/140°F. To reduce the risk of scald injury,
Summary of the content on the page No. 4
Pipe Connect the cold water inlet pipe to the inlet nipple (marked with a blue ring - #1, Fig. 4). Connections IMPORTANT: You must use dielectric fittings if inlet piping/fittings are copper or brass. Failure to provide dielectric insulation may result in premature tank or nipple failure and will void warranty. Dielectric nipples are recommended over unions and are available from a supply house or CEC. Caution To reduce the risk of excessive pressures and temperatures in this water heater, ins
Summary of the content on the page No. 5
Instructions for use Starting and Before connecting the power, fillthe tank and system with water and check for leaks. To be testing certain that all the air is out of the water system, open the hot water faucets on your fixtures until constant water flows from them, otherwise damage to the element may occur. To start the heating cycle: A) first make sure tank is full. Otherwise the heating element may be damaged. B) move red on/off switch (letter F, Fig 3-4) to the ON position (to the left).
Summary of the content on the page No. 6
Descaling Scale deposits can affect the heating capability of the element. the heating Heavy scale can even cause the element to burn out. The element can be descaled Element either chemically or manually: A) Soak the element in white vinegar or other descaling solution, (do not soak the rubber gasket). Once descaled, rinse well with fresh water, to which you should add some baking soda, OR B) Once the element has dried up, use a soft brush (non metallic to prevent damag- ing the stainles
Summary of the content on the page No. 7
Resetting Occasionally, the high temperature limit shut off device may trigger and shut the High Limit system down. This occurs when water temperature exceeds 190°F and shuts off Switch power to the heating element. The shut off device may also trigger from a power outage or electrical storm. To reset: 1. IMPORTANT: Disconnect heater from electrical power. 2. Remove front cover plate and temperature selector dial. 3. Firmly press blue reset button, (B, Fig. 3-5). 4. Replace temperature dial a
Summary of the content on the page No. 8
8
Summary of the content on the page No. 9
ARISTON • LIMITED 2 YEAR WARRANTY COVERAGE 5. The OWNER and not the Manufacturer or his repre- ARISTON, THROUGH ITS U.S. DISTRIBUTOR sentative shall be liable for and shall pay for all field CONTROLLED ENERGY CORP., (hereinafter CEC) charges for labor or other expenses incurred in the guarantees this water heater to the Owner (hereinafter removal and/or repair of the product or any expense "Owner") of the water heater at the original installation incurred by the owner in order to
Summary of the content on the page No. 10
COMMON SENSE HEAT & HOT WATER TECHNOLOGY Controlled Energy Corp. 340 Mad River Park Waitsfield, VT 05673 800-642-3111 802-496-4436 Fax: 802-496-6924 www.controlledenergy.com 10
Summary of the content on the page No. 11
ARISTON P10 & P15 INTERIOR COMPONENTS DIAGRAM 1. ANODE ROD P10 / P15 574305 2. HEATING ELEMENT 810847 4. FLANGE GASKET 570016 6. HEATING ELEMENT BRACKET 7. HEATING ELEMENT RETAINING NUT 8. TEMPERATURE DIAL 9. COVER 10. SCREW 11. THERMOSTAT WIRE HARNESS 12. GROUND SCREW 13. GROUND SCREW LOCK WASHER 14. THERMOSTAT 691551 15. POWER CORD BRACKET 16. HANGING BRACKET 570341 17. POWER CORD 11
