Summary of the content on the page No. 1
KOBE Brand Range Hood
Model No. RA9430SQB
RA9436SQB
RA-094 SERIES – 12” HEIGHT
INSTALLATION INSTRUCTIONS
AND OPERATION MANUAL
Summary of the content on the page No. 2
- READ AND SAVE THESE INSTRUCTIONS - CONTENTS IMPORTANT SAFETY INSTRUCTIONS......................................................................... 1 COMPONENTS OF PACKAGE....................................................................................... 3 INSTALLATION ............................................................................................................... 4 OPERATION INSTRUCTIONS...............................................................................
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS - PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATION - WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY, OBSERVE THE FOLLOWING: 1) Installation and electrical wiring must be done by qualified professionals and in accordance with all applicable codes and standards, including fire-rated construction. 2) When cutting or drilling into wall or ceiling, be careful not to damage electrical wiring or other hidden utilities. 3) Ducted fan
Summary of the content on the page No. 4
What to Do In The Event Of a Range Top Grease Fire � SMOTHER FLAMES with a tight fitting lid, cookie sheet, or metal tray, and then turn off the burner. KEEP FLAMMABLE OR COMBUSTIBLE MATERIAL AWAY FROM FLAMES. If the flames do not go out immediately, EVACUATE THE AREA AND CALL THE FIRE DEPARTMENT or 911. � NEVER PICK UP A BURNING PAN – You May Get Burned. � DO NOT USE WATER, including wet dishcloths or towels – a violent steam blast will result. � Use an extinguisher ONLY if: a) You hav
Summary of the content on the page No. 5
COMPONENTS OF PACKAGE (Must keep all material for returns or refunds) Range Hood Box Model No. RA9430SQB {F} Baffle Filter - 2 (for 30” hood) RA9436SQB - 3 (for 36” hood) {A} KOBE Range Hood – 1 {G} Baffle Handle - 2 (for 30” hood) {B} Warranty Registration Card – 1 - 3 (for 36” hood) {C} Instructions Manual – 1 {H} Screws Package – 1 {D} Hood-Mounting Bracket – 2 {E} Screws Package – 1 {A} {F} {G}
Summary of the content on the page No. 6
INSTALLATION PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING Calculation before Installation To calculate installation, please refer to TABLE 1. (All calculation in inches.) TABLE 1 A = Height of Floor to Ceiling B = Height of Floor to Counter Top (Standard: 36”) C = Preferred Height of Counter Top to Hood Bottom (Recommended 27” to 30”) D = Height of Hood E = Height of the Hood Installation [A – (B+C)] F = Height of Duct Cover [E – D] SAFETY WARNING HOOD MAY
Summary of the content on the page No. 7
Preparation before Installation Figure 1 NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. - Decide the location of the venting pipe from the hood to the outside. (Figure 1) - A straight, short venting run will allow the hood to perform more efficiently. - Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood. Figure 2 - Temporarily wire the hood to test for proper operation before installin
Summary of the content on the page No. 8
4. Secure and tighten the mounting screws. CAUTION: MAKE SURE THE HOOD IS Figure 5 SECURE BEFORE RELEASING. Ductwork Installation 5. Using Reference E from Table 1 and measurements on Page 11, mark the leveling point for duct cover-mounting bracket. 6. Secure the duct cover-mounting bracket to the wall with two screws (not provided). (Figure 6) Make sure all screws are tightened. NOTE: Inner duct cover will cover the duct cover-mounting bracket. Figure 6 7. Use aluminum or st
Summary of the content on the page No. 9
inner duct cover with two (4x8 mm) screws Figure 9 (provided). 12. Fasten outer duct cover to plastic plate on the hood with four (4x8 mm) screws (provided). Install Accessories 13. Place baffle filters underneath the hood. Refer to Figure 10. Final Assembly 14. Turn power ON in control panel. Check Figure 10 all lights and fan operation. 15. Leave this Installation Instructions and Operation Manual for the homeowner. 7
Summary of the content on the page No. 10
OPERATION INSTRUCTIONS This KOBE hood is equipped with four electronic controls with a 10-second standby startup & 30- second delay shutoff, one powerful centrifugal squirrel with baffle filters, and two bright 12-volt 20-watt halogen lights. The four electronic controls are Light Control, Speed Control A, Speed Control B and the Power Control (On/Off). Refer to Figure 11. Light Control Power Control Speed Control A Speed Control
Summary of the content on the page No. 11
MAINTENANCE SAFETY WARNING NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN WHILE THE FAN IS OPERATING. Cleaning Hood Surface CAUTION: NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHS. DO NOT USE PAPER TOWEL ON STAINLESS STEEL. For optimal operation, clean range hood and all baffle/spacer/filter/oil tunnel/oil container regularly. *** Regular care will help preserve the appearance of the hood. 1. Use only mild soap or detergent solutions. Dry surfaces using soft cloth. 2. If hood looks spl
Summary of the content on the page No. 12
Replacing Light Bulb CAUTION: HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL. 1. Make sure all controls are off, and range hood is unplugged. 2. Place the flat-headed screwdriver into the groove of the halogen light glass covering and the housing. 3. Pop out the halogen light glass covering. 4. Gently pull out the defective light bulb and discard. Light bulbs sh
Summary of the content on the page No. 13
SPECIFICATIONS MODEL / SIZE RA9430SQB / 30" RA9436SQB / 36" COLOR Commercial Grade Stainless Steel CONSUMPTION / RA9430SQB - 215W / 1.79A AMPERE RA9436SQB - 215W / 1.79A VOLTAGE 120V 60Hz NUMBER OF MOTORS 1 DESIGN 18-Gauge Seamless / Satin Finish FAN TYPE Double Horizontal Squirrel Cage EXHAUST Top 6" Round CONTROLS Electronic Control (4 Buttons) – 10-Second Standby Startup 30-Second Delay Shutoff HALOGEN LIGHTS RA9430SQB - 12V 20W x 2 RA9436SQB - 12V 20W x 2 HOO
Summary of the content on the page No. 14
MEASUREMENTS & DIAGRAMS Front View Bottom View 30" Hood 36" Hood 12
Summary of the content on the page No. 15
PARTS LIST MODEL RA9430SQB NO.: RA9436SQB NO. DESCRIPTION MODEL / PART NO. SIZE 1 Duct Cover-Mounting Bracket C1-0203-0092 2 Duct Cover RA9236DC B102-0192 3 Plastic Plate C1-0506-0092 4 6” round Plastic Exhaust C1-0505-0001 5 Hood-Mounting Bracket C1-0221-0001 6 Rubber Stand C1-0510-0101 7 Hood Casing RA9430SQB RA-2530-A RA9436SQB RA-25900-A 8 Wiring Box C1-0231-2590 9 Halogen Lights (12V 20W) C1-0403-0001 10 Air Chamber & Motor C1-0302-A120-01 11 Safety Screen C1-
Summary of the content on the page No. 16
MODEL RA9430SQB NO.: RA9436SQB 14
Summary of the content on the page No. 17
CIRCUIT DIAGRAM MODEL RA9430SQB NO.: RA9436SQB 15
Summary of the content on the page No. 18
TROUBLE SHOOTING Issue Possible Cause Solution After Installation, The power is not on. Make sure the circuit breaker and the unit’s power is both motors and ON. Use a voltage meter to check the power supply. lights are not The wire connection is not secure. Check and tighten wire connection. working. The control panel and processor board Check wire continuity from control panel to processor wiring are disconnected. board. The motor transformer is defective. Check the power input and
Summary of the content on the page No. 19
DISCLAIMER CAREFULLY INSPECT ALL ITEMS FOR DAMAGES BEFORE ACCEPTING DELIVERY. NOTE ANY DAMAGES ON THE FREIGHT BILL OR EXPRESS RECEIPT. REQUEST NAME AND SIGNATURE OF THE CARRIER’S AGENT AND KEEP COPY TO SUPPORT YOUR CLAIM. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately. Failure to do so may result in the denial of your claim. The carrier will furnish you with necessary forms for filing a claim.
Summary of the content on the page No. 20
WARRANTY WARRANTY CERTIFICATE KOBE Range Hoods, Inc. warrants all products manufactured or supplied by it to be free from defects in workmanship and materials. Its obligations pursuant to this warranty are limited to a period of two years from the date of purchase and to the repair or replacement at its option and subject to the terms and conditions stated below, of any component part, which its examination shall disclose to be so defective. TWO-YEAR WARRANTY SERVICE PERIOD Any covered
