Aube Technologies TH104 user manual

Summary of the content on the page No. 1



   
  

 
To set the day
Current time SETPOINT:
FAN: displayed when
To set the
and day displayed when
conventional temperature
time
viewing or
control is selected
To set the
setting the
minutes
temperature
Heating
TIME: displayed
indicators
To access
when time needs
programming mode
to be adjusted
and view programs
Room
LP: displayed
temperature
To exit a function during a power
failure
Current program
MODE: to select the number when the

Summary of the content on the page No. 2

            ! Push the excess wire into To change the time display format from 12 to the electrical box to prevent 24 hours and vice-versa: interference with the thermostat. Press and hold ; do not release. Secure the base to the electrical Reset the thermostat using a pointed object box using the provided screws. TO RESET (e.g. paperclip). THE The base can be secured on the Release the button. THERMOSTAT left or right hand side of the electri- cal box.   

Summary of the content on the page No. 3

( ( ()"( This mode automatically runs the programs of the Econo schedule. Ideal for cottages, chalets or weekend residences, this schedule Press MODE until ECONO is outlined. enables the user to enter 2 settings. The current program number is displayed above the The first setting lets the user enter a time (i.e. shortly before ECONO icon. expected arrival) at which the thermostat commands the heating system to warm to comfort setpoint. The second setting commands a temperature decr

Summary of the content on the page No. 4

( &($ ( "&&% Model: TH104 If you have any questions concerning the installation of the TH104 thermostat, contact our technical support team at: Supply: 120/240 VAC, 50/60 Hz Power consumption (off): 860 mW Load: 14.6 A maximum (resistive only), 2 A minimum Tel.: (450) 358-4600 Power: 1750 W @ 120 VCA / 3500 W @ 240 VCA 1-800-831-AUBE (2823) Temperature display range: 0°C to 99°C (0°F to 99°F) Fax: (450) 358-4650 Temperature setting range: 5°C to 27 °C (40°F to 80°F)

Summary of the content on the page No. 5

LOCKED IN AUTO MODE 1- Press the MODE button to place the thermostat in AUTO mode. 2- Press on the PGM button and enter the desired programming (see the Suggested Typical Programming TH104-SW PROCEDURE section in the instruction sheets). LOCKED KEYBOARD 3- Press on the RET button to end the programming. Wait a minimum of 30 seconds for the program to be saved. MAINTAINING THE TEMPERATURE AROUND THE CLOCK To prevent access to the thermostat keyboard: 1- Start by turning off the heating system to