Pitney Bowes Integra N400 user manual

Summary of the content on the page No. 1

Scale
Installa Installation Instructions tion Instructions
for the Integra™ N400 3-lb. Scale
for the Integra™ N400 3-lb. Scale
Do not connect power until Step 10.
1
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaa
Make sure you have:
2

Scale

User Guide

Power Cord (in its own box)

Scale-Meter Interface Cable
Power Cord Scale-Meter Interface Cable
(if ordered, packed separately)
(if ordered, packed separately)
User Guide
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a

Summary of the content on the page No. 2

Remove packing. Level the scale. 4 5 Bubble must be in center. Lift the platter, Adjustable remove the Feet (4) packing Level the scale by turning the scale feet until material, the leveling bubble is centered and the scale and replace the platter on the scale. does not wobble. aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaa Connect scale-meter interface Locate the plug ports. 6 7 cable to scale. Locate the plug ports If you're under the using a front of the scale Pit

Summary of the content on the page No. 3

Result: The scale powers up and displays Plug power cord into outlet. 10 the LC (location code) prompt below. Go to Step 11 to continue. Note: If the scale does not power-up, check that the power cord is firmly attached. Also check that the wall outlet you are using has power by plugging in another device. aaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa Enter your location code. 11 Note: Your scale will not work unless you perform this step. Location Codes a. Find the numb

Summary of the content on the page No. 4

Congratulations! You have successfully installed your Pitney Bowes electronic scale. If you have any questions about the initial setup, BE NEAR YOUR SCALE and call 1-800-537-2488 (menu option 1). Or visit our website at www.pitneybowes.com/ms_service/support/integra For information on using the scale, refer to the User Guide. *SV60406Rev.E* 4