Summary of the content on the page No. 1
¤
Agri-Fab
OWNERS
MANUAL
Model No.
45-02921
15 GALLON "PRO"
TOW SPRAYER
CAUTION:
Read Rules for
Safe Operation
and Instructions
Carefully
Assembly
Operation
Maintenance
Repair Parts
the fastest way to purchase parts www.speedepart.com
PRINTED IN USA
FORM NO. 48301 (REV. 4/04)
Summary of the content on the page No. 2
RULES FOR SAFE OPERATION Any power equipment can cause injury if operated improperly or if the user does not understand how to operate the equipment. Exercise caution at all times when operating equipment. 1. Read this owners manual carefully before attempting to assemble or operate this sprayer. 2. Read your vehicle owners manual for operating and safety rules before using this equipment. 3. Never allow children to operate this sprayer, and do not allow adults to operate without proper instruc
Summary of the content on the page No. 3
SHOWN FULL SIZE F G E A B C D I H J K NOT SHOWN FULL SIZE P O Q 40 60 M L N 20 80 0 100 T S R U X W V HARDWARE PACKAGE - FULL SIZE KEY QTY. DESCRIPTION KEY QTY. DESCRIPTION A 8 Hex Bolt, 5/16" x 2" M 2 Knob B 2 Hex Bolt, 5/16" x 1-1/4" N 1 Spray Gun Clip, Small C 2 Carriage Bolt, 5/16" x 1-1/4" O 1 Spray Gun Clip, Large D2 Screw, #10 x 1/2" P 1 Pressure Gauge E 10 Hex Nut, 5/16" Q 2 Spacer F 2 Flat Washer, 5/16" R 1 Hose Clamp, 1/4" G 6 Flat Washer, 1/2" S 1 Gasket, 3/4" Garden Hos
Summary of the content on the page No. 4
4. Assemble a hitch arm to the inside of a frame tube ASSEMBLY INSTRUCTIONS underneath the tank. Use two 5/16" x 2" hex bolts and 5/16" hex nuts as shown in figure 2. Do not tighten yet. Repeat for other side. TOOLS REQUIRED FOR ASSEMBLY (2) 1/2" Wrenches (1) Screwdriver (1) Pliers (1) Hammer 1. Remove all items from carton and lay out as shown on pages 2 and 3. 2. Assemble the axle through the large holes in the 5/16" HEX NUT frame tubes. If the axle will not fit, slightly loosen the bolts in t
Summary of the content on the page No. 5
7. At this time tighten all bolts starting with the bolts in 10. Assemble the boom bars to the boom mount bracket figure 2, then the bolts in figure 3. using two 5/16" x 1-1/4" carriage bolts, tooth lock washers (between the bar and bracket), 5/16" flat 8. Install the drain in the rear of the tank as shown in washers and knobs. The boom connecting hose figure 4. Place a 3/4" garden hose gasket onto the should extend upward. See figure 6. drain body and insert the drain body out through the hole
Summary of the content on the page No. 6
12. Insert a garden hose gasket into the swivel nut on 16. Attach the sprayer to the tractor hitch and connect the the bypass/return hose. Screw the nut onto the wiring to the tractor battery. The red wire must be upper outlet of the "Y" valve fitting. Place the other connected to the positive post on the battery or to the end of the hose down through the hole at the rear "HOT" connection on a tractor switch or ammeter. The of the tank. See figure 8. brown wire may be grounded or connected to t
Summary of the content on the page No. 7
USING THE SPRAYER OPERATION 1. Determine the application rate (gallons per 1,000 sq. feet or gallons per acre) based on the chemical manufacturers recommendations. Use this rate to BEFORE STARTING help select the pressure setting and tractor speed It is important to test the boom and spray gun with in the following instructions. plain water before using chemicals. This will enable you to check the sprayer for leaks and to set the spray 2. Determine the approximate square footage of the pattern a
Summary of the content on the page No. 8
MAINTENANCE 1. Do not store sprayer with any solution left in tank. 2. Periodically clean the strainer in the end of the intake hose at the bottom of the tank. Remove the nylon swivel nut from the hose, pull out the screen and flush it with clear water. 3. Periodically clean the strainers in the boom nozzles. Remove the nozzle, pull out the screen and flush it with clear water. AFTER EACH USE 4. After use, fill the sprayer part way with water, start the sprayer and allow clear water to be pumped
Summary of the content on the page No. 9
U.S. GALLON TIP CHART Tip Spray Pressure Tip Capacity GALLONS PER ACRE (BASED ON WATER) No. Height PSI US Gallons Inches Per Minute 1 MPH 2 MPH 3 MPH 4 MPH 5 MPH 7.5 MPH 10 MPH 10 .30 44.2 22.1 14.8 11.1 8.9 5.9 4.4 #3 13" 20 .42 63 31.5 20.9 15.7 12.6 8.4 6.3 30 .52 76.8 38.4 25.8 19.3 15.4 10.3 7.7 Tip Spray Pressure Tip Capacity GALLONS PER 1000 SQ. FT. (BASED ON WATER) No. Height PSI US Gallons Inches Per Minute 1 MPH 2 MPH 3 MPH 4 MPH 5 MPH 7.5 MPH 10 MPH 10 .30 1.0 0.50 0.34 0.26 0.20 0.14
Summary of the content on the page No. 10
REPAIR PARTS FOR 15 GALLON SPRAYER MODEL 45-02921 41 39 32 40 7 61 42 36 27 28 27 32 27 B 27 38 32 27 43 64 41 25 39 57 66 36 40 37 A C 67 42 27 65 60 43 9 59 6 24 46 10 61 61 23 26 8 2 B 7 47 21 A 22 13 14 20 11 12 18 4 21 3 35 15 71 69 72 70 19 1 63 5 54 34 7 56 61 53 54 56 68 C 44 55 48 29 44 52 62 66 31 33 34 50 50 30 29 50 66 44 58 31 45 51 66 49 10
Summary of the content on the page No. 11
REPAIR PARTS LIST FOR 15 GALLON SPRAYER MODEL 45-02921 REF. PART QTY. DESCRIPTION REF. PART QTY. DESCRIPTION NO. NO. NO. NO. 40 45029 2 Strainer, Screen Type 1 47752 1 Tank (15 Gal.) 41 45037 2 Nut, Screen Body 2 45015 1 Pump and Motor 42 47396 2 Elbow, Plastic 11/16" Thd. 3 46278 1 Hose, 1/2" ID (24" Lg.) 43 726-0178 2 Nylon Tie 4 45021 1 Hose, 1/2" ID (20" Lg) 44 44180 8 Bolt, Hex 5/16-18 x 2" 5 45024 1 Strainer, Cap Type 1" 45 43840 2 Bolt, Hex 5/16-18 x 1-1/4 6 45031 1 Adapter, 1/2" NPT x
Summary of the content on the page No. 12
the fastest way to purchase parts www.speedepart.com REPAIR PARTS Agri-Fab, Inc. 303 West Raymond Sullivan, IL. 61951 217-728-8388 www.agri-fab.com
