Summary of the content on the page No. 1
LIMITED WARRANTY
INSTALLATION INSTRUCTIONS
Compool Corporation warrants tot he purchaser oft his control system, for the period of
TIME MASTER
one year from the date of original purchase for use, that any defective product proved to
POOL-SPA CONTROL SYSTEM
be caused by faulty workmanship or faulty material, will be repaired or replaced at
Compool's option for no charge, providing the product is returned to Compool
with all transportation charges prepaid.
IMPORTANT SAFETY PRECAUTIONS:
F
Summary of the content on the page No. 2
HYDRAULIC AND ELECTRICAL SCHEMATIC SAMPLE PROGRAM: In the adjacent examples 1 P. The first program will turn on the filter at 7:40 am. 2P: At 10:OO arq the filter pump will continue to run, and the pool cleaner will turn on 3P: The pool cleaner will turn off at 12:30 pm and valves will rotate so that filter pump cir- culates water through the spa 4 P: At 4:00 pm valves will rotate back to pool circulation, and filter pump will turn off (after 4 minute delay). 5P. The fifth program w
Summary of the content on the page No. 3
LOW VOLTAGE WlHlNti UlAGHAM OPERATING INSTRUCTIONS Do not untwist pairs. GENERAL CONTROL FEATURES It is neccessary to retain wires in pairs so that FILTER PUMP OFF DELAY. This causes the filter pump to run an additional appropriate connections can be identified. 4 minutes every time it is turned off. The purpose of this is to protect the gas heater and plumbing from possible scale build-up and thermal stress. These occur when residual heat in the gas heater is not allowed to dissipate
Summary of the content on the page No. 4
3. If the spa is constructed in concrete and optional Spa-side Remote Control (model SETTING THE CLOCK SS-100) is to be used, select a convenient location in the deck or above water level in the spa wall SS-100 should not be submerged by the spa water. 1. Push PROGRAM button until no flashing Install a6" to 12" length of 1 %" pvc pipe at this location to provide a receptable for SS number appears on the right of the display. It 100. This pipe should be level and protrude beyond the finis
Summary of the content on the page No. 5
AUXILIARY EQUIPMENT CONTROL (OPTIONAL): SYSTEM START-UP The standard Time Master system is provided with 3 power relays for controlling filter pump, pool cleaner, and auxiliary 1 (pool light). Apply power to the system. It is possible to control additional equipment (such as a jet pump, air blower, spa light, At theTime Master, pullout batteryshield toactivate back-up battery, and push HOURS etc) by installing extra relay kits (model RLY-LX). The LX-10 Service Center will button until di
Summary of the content on the page No. 6
ADDITIONAL REMOTE CONTROL IN LIEU OF CLEANER: HIGH VOLTAGE WIRING: If the system does not utilize aseparate pool cleanerpum~ it is possible to use the pool All high voltage connections are made to terminal blocks, which are located be cleaner relay to activate an additional remote circuit This circuit is controlled by the hind service panel in right side compartment of LX-10 Service Center. Spa-side Remote Control A high voltage wiring label is located adjacent to terminal blocks. NOTE: C