Summary of the content on the page No. 1
m!r
❑IGITAL AUDIO
~
ADC-EXI06YU
COMPACT DISC CHANGER
CAMBIADOR DE DISCOS COMPACTOS
.
B“
OWNER’S RECORD
For your convenience, record the model number
and serial number (you will find them on the rear of
your set) in the space provided below. Please refer
to them when you contact your AIWA dealer in
case of difficulty.
Model No. IADC-EX106
‘eria’ ‘0 ~
Summary of the content on the page No. 2
Welcome Thank you foryourpurchasmg this AIWAproduct. Tooptimize theperformance ofthisunit, please read through this manual carefully. ●TABLE OF CONTENTS ~ FEATURES ● Tracks from 10 CDs stored in the disc magazine NOTE can be selected and played. This equipment has been tested and found to ● Horizontal, vertical, slanted or suspended comply with the limits for a Class B digital device, installation can be made. pursuant to Part 15 of the FCC Rules. These ●The EASS (Electronic Anti-Shock System) l
Summary of the content on the page No. 3
■ PRECAUTIONS ● Do NOT install the unit in a location where it ● Clean the discs before inserting them into the disc magazine. Always clean a disc from the may be subjected to: — Direct sunlight or other sources of excessive center outward with a cleaning cloth. heat — Fluid, rain or moisture — Excessive dirt or dust — Excessive vibration ● This unit is designed to be operated on a 12-volt DC negative-ground electrical system only. ● Choose the mounting location carefully so that the unit will n
Summary of the content on the page No. 4
■ UNPACKING Compact disc changer Compact disc magazine Connecting cable Supplied mounting kit for the compact disc changer The letters are keyed to those in the instructions. Use only the supplied mounting hardware for safe and secure installation. @ Brackets (1 pair) @ Washer screws @ Plate brackets @ Nuts (4 ea.) (4 ea.) (2 ea.) @ Adhesive label (1 sheet) 3 ENGLISH
Summary of the content on the page No. 5
●INSTALLATIONS Mounting angle setting levers Precautions Be sure to change the position of both mounting Select the mounting location very carefully, angle setting levers according to the angle at referring to the following points. which the unit is to be installed. ● Make sure that there is no fuel tank, wiring or Mounti~g angle setting levers piping on the other side of the mounting surface. ● Make sure that the installation of the unit will not hinder the movement of the deck lid or interfere
Summary of the content on the page No. 6
~ INSTALLATIONS Horizontal installation Construction 1 For details on @@@..., see page 3. The effective angle of the unit. The position of the lever. 450 ,n HORIZONTAL Note r If the mounting surface needs to be strengthened, secure the plate brackets @to the bottom surfece of the car trunk, etc. with the tapping screws (not supplied). Deciding the position Making holes in the carpet 2 4 /’”/ v Removing temporarily ~ Completion 5 ENGLISH
Summary of the content on the page No. 7
Vertical installation Construction 1 For details on @@@..., see page 3. The effective angle of The position of the unit, the lever. I Notes ● If the mounting surface needs to be strengthened, . If installation space is narrow, bend the plate bracket secure the plate brackets @ to the bottom surface ~eb:;:and forth along the perforated line to break off of the car trunk, etc. with the tapping screws (not suppliad). Deciding the position Making holes in the carpet 2 Removing temporarily Completion
Summary of the content on the page No. 8
~ INSTALLATIONS Caution Suspended installation Before drilling the holes, make sure that there is When installing the unit in the trunk below the nothing on the other side of the mounting surface. package tray, observe the following. ● Select the mounting location carefully so that the unit does not hinder the movement of the torsion bars of the deck lid. Construction 9 1 For details on @@@..., see page 3. The effective angle of the unit. 4!3 u HORIZONTAL (f” Making holes Completion 2 3 Tapping
Summary of the content on the page No. 9
●CONNECTIONS This unit is designed only for AIWA brand car stereo. Therefore you cannot use the unit with other brand’s equipment. Compact disc changsr to AIWA brand car stereo Note Caution Use only the supplied connecting cable. Using an Be sure to disconnect the ground wire terminal of unspecified connecting cable may cause background the car battery before making a connection in noise. order to prevent shorl circuiting. ENGLISH 8
Summary of the content on the page No. 10
●HOW TO USE How to use a compact disc magazine With the label side up, inserl a disc all the way. 10 discs, one in 7 each disc tray To remove a disc, pull part@ in the direction Recorded side of the arrow as illustrated. 2 Open the d 3 & INSERT Disc magazine A (eject) button Insert the magazine (which has been taken To remove the magazine, press the A button and pull out the disc magazine. out of the unit) firmly with the LA mark visible on the top side. Close 9 ENGLtSH
Summary of the content on the page No. 11
~ SPECIFICATIONS Compact disc changar Notes on the disc magazine Compact disc digital audio System ● Be sure to place a disc on the disc tray with the system label side up. If a disc is not set properly, it may Frequency response 5 Hz – 20 kHz Below measurable limit cause damage to the unit. Wow and flutter Signal to noise ratio 91 dB or more outputs Line output (for changer connector only) Disc magazine Operating temperature –lo “c to 55 “c 254 x83x 173 mm (w/h/d) Dimensions (10 X3 ‘/, x 6 7/8
Summary of the content on the page No. 12
Bienvenifios Muchas gracias por su compra de este producto AlWA. Para utilizar este aparato en Ias mejores condiciones posibles, lea cuidadosamente Ias instrucciones de este manual. ~ INDICE m DETALLES ● Se pueden seleccionar y reproducer canciones PRECAUTION de 10 discos compactos colocados en el Las modificaciones y ajustes de este producto cargador de discos. que no han sido autorizadas a titulo expreso por ●Se puede instalar horizontal mente, el fabricate pueden anular el derecho o autoridad
Summary of the content on the page No. 13
●PRECAUCIONES c NO instale el aparato en un Iugar donde pueda ● Limpie Iosdiscos antes de colocarlos en etcargador quedar expuesto a: de discos. Empiece siempre por el centro y vaya — Ios rayos del sol o a temperatures muy altas. hacia afuera Iimpiando con un patio Iimpiador. — Iiquido, Iluvia o humedad. — demasiada suciedad o polvo — vibration excesiva ● Este aparatofunciona solo con CC de 12voltios con conexion a tierra negativa. ● Seleccione cuidadosamente el Iugar para la instalacion de tal
Summary of the content on the page No. 14
●DESEMBALAJE Cambiador de discos Cargador de discos Cable de conexion compactos compactos @ QQ Juego de montaje suministrado para el cambiador de discos compactos Las Ietras en cfrculos tienen sus referencias a 10Iargo de Ias instrucciones. Utilice solo Ias piezas para montaje suministradas para que la instalacion sea segura. @ Mensulas (1 par) @ Tornillos con @ Tuercas (4 c/u) arandela (4 c/u) w @ Etiqueta adhesiva (1 hoja) 3 ESPAliOL
Summary of the content on the page No. 15
~ INSTALACIONES Precauciones Instaiacion de Ios herrajes de angulo Seleccione cuidadosamenteel Iugardondese Cambieiaposicion deinstalaciondelos herrajes va a instalar, teniendo en cuenta Ios siguientes de angulo de acuerdo al angulo en el que desea puntos. instalar el aparato. Angulo de @stalacion ● Confirme quenohayaun tanquedecombustible detrasde Iasuperficie de montaje yquetampoco haya cables o caries. ● Lainstalacion delaparato nodeberaimpedirel movimiento de Iatapa del haul ni el desmontaje
Summary of the content on the page No. 16
~ INSTALAL70NES Instalacion horizontal Diseiio 1 Para mas detalles de @@@..., lea la pagina 3. Angulo efectivo del aparato. *O P. 30” [“” 15” ‘o @ Position del ojete protector. 450 ,El Nota HORIZONTAL S fuere necesario reforzar la superficie de instalacion, c asegure Ias mensulas de placa @ en la superficie inferior del haul del coche con tornillos autoterrajantes (no incluido). Decida la position Abra orificios en la alfombra 2 4 ,.,,~., Desmontaje provisorio Fin 3 5 5 ESPANOL
Summary of the content on the page No. 17
Instalacion vertical Diseiio 1 Para mas detalles de @@@..., lea la pagina 3. Angulo efectivo del Position del ojete protector. aparato. Notas ● Si fuera necesario reforzar la superficie de instalac ion, ● El espacio para su instalacitm es angosto, doble la mensula @ hacia atras y hacia adelante a 10Iargo de asegure Ias mensulas de placa @ en la suPeticie la Iinea peforada para romper la punta. inferior del haul del coche con tornillos autoterrajantes (no incluido). 4 Atmorif” Icios en la alfombr
Summary of the content on the page No. 18
~ INSTALACIONES Precaution Instalacion colgada Verifique que no haya nadadetrasdel Iugarde la Cuando se instala el aparato en el haul, debajo instalacion antes de abrir Ios orificios. de la bandeja para paquetes, tenga en cuenta Ios siguientes puntos. ● Seleccione cuidadosamente ellugardondesevaa instalar elaparato, para que no impida el movimiento de Ias barras de soporte de la tapa del batil. Diseiio 1 Para mas detalles de @@@..., lea la pagina 3. Angulo efectivo del aparato, ,,. ) Position de
Summary of the content on the page No. 19
●CONEXIONES Este aparato fue disefiado solo para Ios estereos de coche AlWA. Por 10 tanto, no utilice este aparato con equipos de otra marca. Cambiador de discos compactos al estereo de coche de la marca AIWA Nota Precaution Utilice solo el cable de conexion suministrado. El usode Desconecte el terminal del cable a tierra de la un cable de conexion no eapecificado puede provocar baterfa del coche antes de hater Ias conexiones, ruidos de fondo. para evitar un cortocircuito. ESPAIiOL 8
Summary of the content on the page No. 20
~ UTILIZATION Utilization del cargador de discos compactos 1 Coloq.eeldiscocompacto hastaelfondo con ei Iado de la etiqueta hacia arriba. e&”eta - 10 discos, uno en t Lado grabado Para sacar un disco compacto, tire de la parte @ en cada bandeja de el sentido de la flecha, tal como se puede apreciar en discos la figura. 2 Abra la pue 3 Cargador de discos Bo;on de expulsion & Coloque el cargador, (despues de sacarlo) Para sacar el cargador, presione el boton con el Iado de la marca A hacia arriba,
