Summary of the content on the page No. 1
200 HT LGR Dehumidifier
TS-302
PO Box 8680 • Madison, WI 53708
Owner’s Manual — 200 HT LGR Dehumidifier
Installation, Operation and Service Instructions
Read and Save These Instructions
The Phoenix 200 HT features LGR (low grain refrigerant) technology. This technology enables the 200 HT to remove more
water and create more grain depression than standard refrigerant dehumidifiers.
Combined with this performance, the multiple ducting and the superior high temperature performance makes the Ph
Summary of the content on the page No. 2
Table of Contents 1 Specifications Introduction ................................................................ Part No. 4025900 1. Specifications ........................................................2 Power 7.5 amps, 0- 20 V AC, Grounded 2. Operation .............................................................2 2. T ransporting ...................................................2 Water 40 pints/da y @ AHAM (80 °F, 60%) Removal 26 pints/day @ saturation 2.2 Electrical Requi
Summary of the content on the page No. 3
is directed across the evaporator. This airflow lowers 2.3 Condensate Removal the refrigerant pressure in the condenser and improves The Phoenix 200 HT is equipped with an internal dehumidifier efficiency. The relative reduction or slowing condensate pump to remove the water that is condensed of airflow across the evaporator allows more time for the during dehumidification. This allows the condensate to be air temperature to be lowered to the dew point, which pumped 20’ with the attached
Summary of the content on the page No. 4
the evaporator more quickly and efficiently. See Figure 3 3 Maintenance below for correct grain control magnet position and defrost 3.1 Air Filter timer for operating in temperatures below 50°F. The Phoenix 200 HT is equipped with a pleated fabric air filter that must be checked regularly. The standard filter is a MERV- high efficiency filter. Operating the unit with a dirty filter will reduce the dehumidifier’s capacity and efficiency and may cause the compressor to cycle off and on un
Summary of the content on the page No. 5
Some dehumidification, blower runs continuously but compressor only runs sporadically. . Unit is in defrost cycle. 2. Defrost thermostat defective or loose. 3. Loose connection in compressor circuit. 4. Defective compressor overload. 5. Defective compressor. 6. Defective relay. No dehumidification, blower runs but compressor does not. . Bad connection in compressor circuit. 2. Pump safety switch closed. 3. Defective compressor capacitor. 4. Defective compressor overload. Figure 4: R
Summary of the content on the page No. 6
Evaporator coil frosted continuously, low dehumidifying capacity. . Defrost thermostat loose or defective. 2. Defrost timer incorrectly set or defective. 3. Low refrigerant charge. 4. Dirty air filter or air flow restricted. Compressor runs with power switch OFF. . Defective relay. 2. Defective power switch. 4.3 Blower Replacement The motorized impeller has a PSC motor and internal thermal overload protection. If defective, the complete assembly must be replaced. Figure 7: Condensate
Summary of the content on the page No. 7
4.7 Relay 5 Options and Accessories The contacts of the single pole, single throw relay 4024682 Air Filter, Pleated, 2” x 6” x 20” complete the power circuit to the compressor. The 57% MERV-8 contacts are closed when power is provided to the relay 4024750 Intake Flex Duct coil via the control circuit. The control circuit includes the 2” x 25” Metalized P olyester power switch, low pressure control, defrost thermostat and 4024935 Lay-Flat Duct, 0” Round x 250’ Roll timer. 6 Wir
Summary of the content on the page No. 8
8 Service Parts Item Description Qty Part No. Item Description Qty Part No. 7 Pump Purge Switch 402796 Air Filter, Pleated, 2 X 6 X 20 402475 8 Hour Meter 402597 2 Cord 4025078 9 Power Switch 402822 3 Front Panel Retaining Nut, /4-20 4023362 20 Skid Plate 402569 4 Wheel, 8” 2 4025676 Wheel Hub Cap 2 402486 2 Instruction Label 4025723 Retaining Ring 2 4025454 22 Handle Screw (M0- .5 x 35) 77792 Handle Washer 40
Summary of the content on the page No. 9
Phoenix 200 HT Dehumidifier Limited Warranty Warrantor: Therma-Stor LLC PO Box 8680 Madison, WI 53708 Telephone: -800-533-7533 Who Is Covered: This warranty extends only to the original end-user of the Phoenix 200 HT dehumidifier, and may not be assigned or transferred. Year One: Therma-Stor LLC warrants that, for one () year the Phoenix 200 HT dehumidifier will operate free from any defects in materials and workmanship, or Therma-Stor LLC will, at its option, repair or replace the defe
