Summary of the content on the page No. 1
CW897 Integrated Frost Free
fridge freezer
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
Summary of the content on the page No. 2
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it, unless they have had supervision or
Summary of the content on the page No. 3
Important Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance. This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage only, not for storage of blood, medicine and biological products. To prevent risk of fire, keep the appliance away from petrol or any other inflammables. To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the
Summary of the content on the page No. 4
Use Fridge • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being put into the refrigerator. • Nothing should rest against the rear wall of the refrigerator, as this will cause frost and possible condensation problems which will be difficult to remove. • Make sure food is clean and any extra water is wiped away before putting into the fridge. • Wrap or cover food before putting
Summary of the content on the page No. 5
Control panel C D ALARM ON B A fig. 1 The control panel for the fridge has two lights: A. Green Power light This light is illuminated when the power supply to the appliance is on. B. Red Temperature Warning light This light will switch on when the interior temperature is too warm. There will also be three intermittent beeps to serve as an audio alert. C. Audio Alert release / Force Defrost button When the fridge is over temperature, press this button to switch off the audio alert. The red t
Summary of the content on the page No. 6
Care and cleaning Always disconnect the appliance from the power supply before any cleaning or maintenance. The fridge and freezer sections should be cleaned using a solution of bicarbonate of soda and lukewarm water. Do not use abrasive products or detergents. After washing, rinse and dry thoroughly. Clean the shelves and balconies separately by hand with soap and water. Do not put them in the dishwasher. The water drain hole at the back of the fridge compartment and the evaporating tray sho
Summary of the content on the page No. 7
Changing the light bulb Disconnect the appliance from the power. • Release the light cover by pressing on the hooks at the back of the cover, then slide it towards the back of the fridge to remove it. • Unscrew the light bulb to remove it and replace with a new bulb of the same rating (not more than 15W). • Replace the light cover and reconnect the power. Troubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care t
Summary of the content on the page No. 8
Installation And Ventilation This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places. • To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance. • The cooling system at the rear of the appliance must not touch the rear wall. • The appliance must be installed with adequate ventilation. Ensure that there is clearance above the appliance to allow air to escape and that there is space betw
Summary of the content on the page No. 9
Mounting the Fascia Door x4 • Using a screwdriver, fix the mounting brackets to the appliance door, as shown in figure 4. • Position the appliance within the unit. Ensure that there is a gap of 3 to 4 mm between the non-hinged side and the cabinet wall. • Locate the slider in the bracket and fix the slider to the fascia door 20 to 22 mm from the edge of the fascia as shown in figure 5, ensuring that the slider is positioned centrally and horizontally
Summary of the content on the page No. 10
Reversing the door We recommend you seek the help of another individual to support the doors whilst performing this operation 1. Carefully prise off the cover cap for the top hinge and unscrew the screws fixing the top hinge to the appliance, you should support the upper door whilst doing this. 2. Carefully remove the upper door and place it somewhere safe. Note that there are spacers between the door and the hinge; note how many and their position. 3. Remove the central hinge by removing
Summary of the content on the page No. 11
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in position. How to connect an alternative plug If the fitted plug is not suitable f
Summary of the content on the page No. 12
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
