Summary of the content on the page No. 1
EN
User manual 2
Refrigerator
ZRG715SW
Summary of the content on the page No. 2
This Quick user manual contains all the basic facts of your new product and is easy to use. Electrolux wants to lower our paper consumption related to user manuals by some 30%, which will help spare 12,000 trees every year. The Quick user manual is one of many steps taken by Electrolux for the environment. It may be a small step, but just by doing a little you do a lot. A complete user manual can be found at www.electrolux.com Safety information In the interest of your safety and to ensure the
Summary of the content on the page No. 3
5. If the power plug socket is loose, do not insert the • Do not use sharp objects to remove frost from the ap- power plug. There is a risk of electric shock or fire. pliance. Use a plastic scraper. 6. You must not operate the appliance without the • Never use a hair drier or other heating appliances to 1) speed up defrosting. Excessive heat may damage the lamp cover of interior lighting. plastic interior, and humidity could enter the electric • This appliance is heavy. Care should be taken when
Summary of the content on the page No. 4
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials. The appliance shall not be er. The materials used on this appliance marked by the discarded together with the
Summary of the content on the page No. 5
Defrosting of the refrigerator Important! Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor com- To remove the frost, do these steps: pressor stops, during normal use. The defrost water 1. Switch off the appliance. drains out through a trough into a special container at the 2. Remove any stored food, wrap it in several layers of back of the appliance, over the m
Summary of the content on the page No. 6
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Levelling Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance When placing the appli- before installing the appliance. ance ensure that it stands Positioning level. This can be achieved 1 Install this appliance at a location where the ambient tem- by two adjustable feet at 2 perature corresponds to the cli
Summary of the content on the page No. 7
8. Remove the lower hinge. Put over the pin in the di- rection of the arrow. 9. Unscrew and install the screw on the opposite side. 10. Install the lower hinge on the opposite side leav- ing the position of the door unchanged. 1. Remove the plug from 5. Take off the appliance 12. Remove and install the 11. Screw in the one screw 1) the power socket. door by pulling it slightly handle on the opposite in the place set free on the 2. Tilt back the appliance downwards. side. other side as well as th
Summary of the content on the page No. 8
Reversibility of the freezer door 180˚ Electrical Connection Important! The wires in the mains lead are coloured in accordance with the following code: Caution! Any electrical work required to install this appliance should be carried out by a qualified Green and Yellow: Earth 1 electrician or competent person. Brown: Live 3 Warning! This appliance must be earthed. The manufacturer declines any liability should these Blue: Neutral 5 safety measures not be observed. As the colours of the wires
Summary of the content on the page No. 9
2 The appliance is supplied with a 13 amp plug fitted . Warning! A cut off plug inserted into a 13 amp In the event of having to change the fuse in the plug sup- socket is a serious safety (shock) hazard. Ensure plied, a 13 amp ASTA approved (BS 1362) fuse must be that it is disposed of safely. used. Environmental concerns negative consequences for the environment and human The symbol on the product or on its packaging health, which could otherwise be caused by inappropriate indicates that
Summary of the content on the page No. 10
10
Summary of the content on the page No. 11
11
Summary of the content on the page No. 12
To buy accessories, consumables and spare parts at our online shop please visit: www.zanussi.co.uk www.zanussi.com 200383444-00-19032010
