Summary of the content on the page No. 1
USE AND CARE GUIDE
®
1000, 29 & 75 SERIES
WINE CAPTAIN® MODELS
BEVERAGE CENTERS
REFRIGERATORS, FREEZERS
WINE CAPTAIN®
BEVERAGE
MODELS REFRIGERATOR
FREEZER
CENTER
ULN-29RB-00 ULN-29RWH-02
U-1075WCS-00 U-1075BEVS-00 ULN-75FB-00
ULN-29RB-02 ULN-29RWH-06
U-1075WCS-02 U-1075BEVS-02 ULN-75FB-13
ULN-29RB-06 ULN-29RWH-09
U-1075WCS-13 U-1075BEVS-13 ULN-75FWH-00
ULN-29RB-09 ULN-29RWH-13
U-1075WCS-15 U-1075BEVS-15 ULN-75FWH-02
ULN-29RB-13 ULN-29RWH-15
ULN-75FWH-13
ULN-29RB-15 ULN-29RWH-23
ULN-29RWH-00 UL
Summary of the content on the page No. 2
Introduction Please Record Your Model Information You will need your product model and serial number when you request additional information or services. You can find this information on the serial plate located on the upper right or back Congratulations on your purchase of a U-Line refrigerator. wall in the interior of your product. This information also appears on the warranty registration card. Please complete and mail your For nearly five decades and three generations, U-Line continues
Summary of the content on the page No. 3
Table of Contents 1 - Safety Precautions .....................................................................................................................................................1 Safety Alert Definitions ........................................................................................................................................1 General Precautions .............................................................................................................................
Summary of the content on the page No. 4
1 Safety Precautions General Precautions Use this appliance for its intended purpose only. Follow these IMPO IMPOR RT TANT ANT general precautions with those listed throughout this guide: • PLEASE READ all instructions before installing, operating, or servicing the appliance. DANGER RISK OF CHILD ENTRAPMENT. Before you throw away your • Proper installation procedures must be followed when old refrigerator or freezer, take off the doors and leave shelves completing an installation or relocat
Summary of the content on the page No. 5
Wine Captain® Model Features: 2 1000 Series Product Features Capacity. 24" Wine Captain Model up to 48 Bottles. Triple temperature zones. Maintains wine at their proper serving temperature. Top Approximately 55°F (Red). Middle Approximately 50°F (White). Bottom Approximately 45°F (Sparkling). Safely stores one, two or three types of wine. All 1000 Series Models Feature: 3/4 extension slide-out coated wine racks. Allow for easy Mechanical Temperature Control. Provides ability to set the acce
Summary of the content on the page No. 6
3 Product Operation Initial Startup Air Flow All U-Line controls are preset at the factory. Initial startup requires no adjustments. IMPO IMPOR RT TANT ANT IMPO IMPOR RT TANT ANT The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at U-Line recommends allowing the unit to run overnight any time, or the unit will not perform as expected. Do not before loading refrigerator or freezer with product. install the unit behind a do
Summary of the content on the page No. 7
Checking Product Temperature Adjusting Air Temperature IMPO IMPOR RT TANT ANT • Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking. • Factory recommended set-point is MID setting on dial control. To adjust the set point temperature: Adjust the temperature by turning the numbered dial (1) in small increments. To check the actual product temperature in the unit. 1. Partially fill a plastic (nonbreakable) bottle with water
Summary of the content on the page No. 8
4 U-Line Wine Guide Matching Food and Wine Although there are no hard fast rules for matching wine to food, Looking Behind the Label observe some guidelines. Delicate dishes should be accompanied To most, wine is a delicious mystery. We purchase it, uncork it, and by lighter more delicate wines. Full-flavored foods should be savor its taste and beauty. But there is so much more to true wine matched with fuller-bodied wines. appreciation. Many secrets are simply too good to keep bottled up.
Summary of the content on the page No. 9
The Cork: A Mystery on Its Own. Ideal Wine Storage Considerations Cork Presentation. The ritual of the presentation of the cork Temperature: The most important element about storage has a rich and fascinating history dating back to the late 1800's. A temperature is stability. If wine is kept in a stable environment phylloxera (root louse) devastation to the vineyards severely between 40°F and 65°F, it will remain sound. A small 1-2 degree limited the supply of great wines. Restaurateurs w
Summary of the content on the page No. 10
Wine Stocking Recommendation Wine Rack Removal and Installation Specially designed horizontal wine racks properly positioned the To remove a rack from the cabinet: bottles so the wine remains in contact with the cork and assure 1. Remove any bottles stored on the rack. the cork does not become dry. 2. Grasp the end of the rack, and gently slide it out until it stops. Stock the unit as follows: 1. Stock the wine racks beginning with the lowest rack, at the back, and working forward. Stagger th
Summary of the content on the page No. 11
Wood Trim Finishing Staining and final finish application: WARNING IMPO IMPOR RT TANT ANT You MUST remove the wood trim from the unit for DO NOT use oil-based stains on wood trim. Vapors from staining or finishing to prevent permanent damage to the inner liner of the unit. Allow stain or finish to dry oil-based stains will permanently penetrate the liner and will not dissipate over time. thoroughly (at least 24 hours for each coat) following the product manufacturer’s instructions before 1
Summary of the content on the page No. 12
5 Maintenance For Models without adjustable leveling feet: Light bulb Replacement IMPO IMPOR RT TANT ANT To replace the light bulb in your U-Line unit: The unit must be located on a level surface, for proper 1. Find the light located at the top of the unit. Grasp the edges of door and ice maker (if equipped) operation. the light housing lens (1) opposite the exposed tab and gently push the lens toward the tab (2). 1. Use a level to check the levelness of the unit from front to back and from
Summary of the content on the page No. 13
Removing and Installing Grille WARNING Disconnect electric power to the unit before removing the grille. WARNING DO NOT touch the condenser fins(4). The condenser fins are SHARP and can be easily damaged. Removing the grille. 1. Disconnect power to the unit. 2. Remove control knob (6) if equipped. For models equipped with glass shelves having shelf supports, 3. Loosen the two screws (1). Some models may have only one remove the shelves as follows: screw in the center. 1. Open door completely
Summary of the content on the page No. 14
To reverse the door: 9 Standard Doors Remove grille: Remove the grille, see MAINTENANCE section of this guide. Door Alignment and Adjustment Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. IMPO IMPOR RT TANT ANT Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gaske
Summary of the content on the page No. 15
1 Install bottom hinge: Prepare door for reinstallation: 1. If you have a plate hinge, reorient the pivot screw so it protrudes the opposite direction form the hinge. Remove the For black or white doors: pivot screw from the hinge. Turn the plate over and reinstall 1. Remove plastic hole plug from top of door handle and reinstall the screw. on opposite side. 2. Align hinge outer edge with cabinet. For models with a plate 2. Remove plastic hinge bushing on bottom of door and reinstall on hi
Summary of the content on the page No. 16
. 7 Cleaning Defrosting Exterior Cleaning Automatic Defrost Models Vinyl Clad (Black or White) Models: Frost on the rear wall is normal and will melt during each defrost cycle. If there is excessive build-up of 1/4” or more, manually • Clean surfaces with a mild detergent and warm water solution. defrost the unit. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean • Ensure the door is closing and sealing properly. towel to p
Summary of the content on the page No. 17
Condensor Cleaning Storage, Vacation and Moving Interval - Every Three Months If not using the unit for an extended period, or otherwise stored, follow these steps completely: To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending WARNING on environmental conditions, more or less frequent cleaning may be necessary. Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels.
Summary of the content on the page No. 18
8Service Before Calling for Service Troubleshooting Guide If you think your U-Line product is malfunctioning, read the DANGER OPERATION section of this guide to clearly understand the function of the control. ELECTROCUTION HAZARD. Never attempt to repair or perform maintenance on the unit until disconnecting the If the problem persists, read the NORMAL OPERATING SOUNDS and TROUBLESHOOTING GUIDE section of this guide main electrical power. to help you quickly identify common problems, and p
Summary of the content on the page No. 19
USE AND CARE GUIDE ® PRODUCT INFORMATION Complete Installation Guides, Use and Care Guides, Specifications & Features and Benefits, CAD Drawings, Overlay Panel/Frame and Toe-Kick Specifications and Instructions, Compliance Documentation and Applicable Energy Guides are available for reference and download at u-line.com. SERVICE INFORMATION Please consult your Use and Care Guide for troubleshooting information. Answers to Customer Frequently Asked Questions are available at u-line.com under Cust
