Summary of the content on the page No. 1
Table of Contents
1. THE ENVIRONMENT - DISPOSAL INSTRUCTIONS ........................................................... 13
2. PRECAUTIONS FOR USE .................................................................................................... 14
3. SAFETY PRECAUTIONS ...................................................................................................... 15
4. INSTALLATION AND CONNECTION ................................................................................... 16
4.1
Summary of the content on the page No. 2
The environment - Disposal instructions 1. THE ENVIRONMENT - DISPOSAL INSTRUCTIONS OUR REFRIGERATORS ARE ONLY PACKAGED USING NON-POLLUTANT, ENVIRONMENT- FRIENDLY, RECYCLABLE MATERIALS. WE URGE YOU TO COOPERATE BY DISPOSING OF THE PACKAGING PROPERLY. CONTACT YOUR LOCAL DEALER OR THE COMPETENT LOCAL ORGANISATIONS FOR THE ADDRESSES OF COLLECTION, RECYCLING AND DISPOSAL FACILITIES. NEVER LEAVE ALL OR PART OF THE PACKAGING LYING AROUND: PACKAGING PARTS, AND ESPECIALLY PLASTIC BAGS, MAY REPRESENT A SU
Summary of the content on the page No. 3
Precautions for Use 2. PRECAUTIONS FOR USE ELECTRICAL CONNECTION: SEE INSTALLATION INSTRUCTIONS FOR SAFETY REGULATIONS FOR ELECTRIC OR GAS APPLIANCES AND FOR VENTILATION FUNCTIONS. IN YOUR INTEREST AND TO ENSURE YOUR SAFETY, BY LAW ALL ELECTRIC APPLIANCES MUST ONLY BE INSTALLED AND SERVICED BY QUALIFIED STAFF, IN ACCORDANCE WITH THE RELEVANT REGULATIONS. GAS OR ELECTRIC APPLIANCES MUST ALWAYS BE DISCONNECTED BY SUITABLY SKILLED PEOPLE. THIS MANUAL CONSTITUTES AN INTEGRAL PART OF THE APPLIANCE: T
Summary of the content on the page No. 4
Safety Precautions 3. SAFETY PRECAUTIONS INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED ENGINEER WHO IS TO INSTALL, COMMISSION AND TEST THE APPLIANCE. THE APPLIANCE MUST BE INSTALLED BY QUALIFIED STAFF TO PREVENT DAMAGE OR INJURY. THE REFRIGERANT IN THE APPLIANCE'S CIRCUIT CONTAINS NH3 (AMMONIUM) AND IS TOXIC AND FLAMMABLE: TAKE CARE NOT TO DAMAGE THE REFRIGERATION CIRCUIT. IF LEAKS OCCUR, VENTILATE THE PREMISES IMMEDIATELY. THE REFRIGERANT IS ALSO HARMFUL TO THE EYES. TAKE
Summary of the content on the page No. 5
Instructions for the Installer 4. INSTALLATION AND CONNECTION Regardless of the installation method (free-standing or built-in), always check that the appliance is per- fectly lev-el after installation. 4.1 Free-Standing Version After removing the packaging, tilt the appliance onto its back and fit the four wheels supplied onto the pins provided in the base. For efficient operation, meaning peak refrigeration with minimal electricity consumption, a few simple rules must be followed: 1 Install th
Summary of the content on the page No. 6
Instructions for the Installer 4.2 Fully Built-In Version Minibars can easily be built into any suitable cabinet. It is essential to comply with the following guidelines: 1 Make sure that sufficient ventilation can reach the refrigeration unit, on the rear of the minibar. 2 Sketches A, B and C (fig. 2) show various alternatives for building-in your minibar; 2 3 The ventilation gaps, for both incoming and outgoing air, must measure at least 200 cm and it is indispensable to take care that any ven
Summary of the content on the page No. 7
Instructions for the Installer Place the minibar and cabinet doors open at 90° and bring their ends together (fig. 5). In this position, fix the L-shaped bracket to the door of the minibar. Before screwing the L- shaped bracket into place, fit the linking bracket as shown in the diagram. 5) Now open the minibar and cabinet doors fully and fix the three screws which secure the linking bracket to the door of the cabinet, as shown in figure 6. 6) Once the two brackets have been fixed, the minibar
Summary of the content on the page No. 8
Instructions for the Installer 4.3 Built-In Version Without Added Door See below for the overall dimensions of the minibar (Fig. 8) and the relative dimensions required for the cabinet which is to house it (Fig. 9). 8) 9) 2 The area of both the air intakes and outlets must be at least 200 cm . 4.4 Electricity Supply The appliance must be connected, by means of its own power supply lead, to a regulation mains socket with earth connection. Our company declines all liability for any damage der
Summary of the content on the page No. 9
Instructions for the User 5. USING THE MINIBAR To switch the refrigerator on, turn the knob of the thermostat in the bottom left-hand corner inside the appliance. When the knob is turned to 0, the appliance is switched off. The operating settings are from MIN (highest inside temperature) to MAX (lowest inside temperature). Only use the highest setting (MAX) if absolutely necessary: in some conditions, the refrigeration unit might operate continuously, causing excessive ice formation, leading to
