Summary of the content on the page No. 1
BOTTOM FREEZER
REFRIGERATOR
User’s Guide
Please read this guide thoroughly
before operating and keep it handy for
reference at all times.
CONGÉLATEUR
INFÉRIEUR
RÉFRIGÉRATEUR
Guide d’Utilisation et
d’Entretien
Veuillez lire ce manuel en entier avant de mettre
en marche l'unité et conservez-le à portée de la
main pour le consulter à tout moment.
CONGELADOR
INFERIOR
REFRIGERADOR
Guía para el Uso y Cuidado
Lea detenidamente estas instrucciones antes
utilizar el frigorífico y guárdelas como referen
Summary of the content on the page No. 2
TABLE OF CONTENTS English Version 2 Removing Crisper 19 French Version 36 Crisper Cover with Lattice on inner Surface 20 Spanish Version 70 Glide N Serve 21 Warranty (U.S.A.) 3 Modular Door Bin 21 Warranty (CANADA) 4 Dairy Bin 22 Safety Instructions 5–6 Egg Box 22 Grounding Requirements 6 u u Freezer section Parts and Features 7 Tilting Door 22 Refrigerator Installation 8–14 Ice Bin 22 Unpacking Your Refrigerator 8 Freezer Wire Door Rack 23 Installation 8 Durabase 23 Removing and Replacing You
Summary of the content on the page No. 3
LG ELECTRONICS, INC. LG REFRIGERATOR LIMITED WARRANTY - USA Your LG Refrigerator will be will repaired or replaced, at LG’s option, if it proves to be defective in material or workmanship under normal use, during the warranty period ("Warranty Period") set forth below, effective from the date ("Date of Purchase") of original consumer purchase of the product. This warranty is good only to the original purchaser of the product and effective only when used in the United States, including Alaska, Ha
Summary of the content on the page No. 4
LIMITED WARRANTY (CANADA) LG REFRIGERATOR LG Electronics will repair or at its option replace, without charge, your product which proves to be defective in material or workmanship under normal use, during the warranty period listed below from the date of original purchase. This warranty is good only to the original purchaser of the product during the warranty period as long as it is in any Canadian Province. WARRANTY PERIOD MODEL# : LRFD21855**/LRFD25850** LABOR : 2 Years PARTS : 2 Years SEALED
Summary of the content on the page No. 5
IMPORTANT SAFETY INSTRUCTIONS This guide contains many important safety messages. Always read and obey all safety messages. This is the safety alert symbol. It alerts you to safety messages that inform you of hazards that can kill or hurt you or others, or cause damage to the product. All safety messages will be preceded by the safety alert symbol and the hazard signal word DANGER, WARNING, CAUTION. These words mean: You will be killed or seriously injured if you don’t follow instructions. DANGE
Summary of the content on the page No. 6
DANGER: RISK OF CHILD ENTRAPMENT Child entrapment and suffocation are not problems of BEFORE YOU THROW AWAY the past. Junked or abandoned refrigerators are still YOUR OLD REFRIGERATOR dangerous…even if they will sit for just a few days. If OR FREEZER you are getting rid of your old refrigerator, please follow the instructions at right to help prevent accidents. • Take off the doors. • Leave the shelves in place so that children may not easily climb inside. CFC DISPOSAL Your old refrigerator may
Summary of the content on the page No. 7
PARTS AND FEATURES A B M N O C C I D J E K F G L H Use this page to become more familiar with the parts and features. Page references are included for your convenience. NOTE: This guide covers several different models. The refrigerator you have purchased may have some or all of the items listed below. The locations of the features shown below may not match your model. H A Refrigerator Light (p.25) Ice Bin (p.22) B I Filter (Inside) (p.24) Pull out Drawer (p.23) C J Modular Door Bins (p.21) Dur
Summary of the content on the page No. 8
REFRIGERATOR INSTALLATION INSTALLATION WARNING 1. To avoid vibration, the unit must be level. If required, adjust the leveling screws to compensate for Excessive Weight Hazard unevenness of the floor. The front should be slightly Use two or more people to move and install higher than the rear to aid in door closing. Leveling refrigerator. screws can be turned easily by tipping the cabinet slightly. Turn the leveling screws clockwise ( ) to Failure to do so can result in back or other injur
Summary of the content on the page No. 9
REFRIGERATOR INSTALLATION HOW TO REMOVE DOOR HANDLES To move refrigerator through a house door, it maybe necessary to remove the refrigerator door handles. NOTE: Handle appearance may vary from illustrations on this page. 1. Removing Refrigerator Handle • Grasp the handle tightly with both hands and slide the handle up (1)(this may require some force). • The keyhole slots (2) on the back of the handle allow the handle to separate from 1 the mounting screws (3). w CAUTION: The handle could be dam
Summary of the content on the page No. 10
REFRIGERATOR INSTALLATION HOW TO REPLACE DOOR HANDLES NOTE: Handle appearance may vary from illustrations on this page. 1. Replacing Refrigerator Door Handle • Align keyhole slots (1) on the top and bottom of the back of the handle with the screws (2) mounted on the front of the door. 1 • Press the handle against the door 3 front, making sure that the screws (2) go into the keyhole slots (1). • Holding the handle with both hands, press it firmly against the front of the 2 door and slide the hand
Summary of the content on the page No. 11
REFRIGERATOR INSTALLATION REMOVING AND REPLACING REFRIGERATOR DOORS 1. Removing Refrigerator Door w CAUTION: Before you begin, unplug the refrigerator. Remove food and bins from doors. u u Left Door 1. Disconnect water supply tube by pushing back on the disconnect ring (4). 2. Open door. Loosen top hinge cover screw (1). Use flat tip screwdriver to pry back hooks on front underside of cover (3). Lift up cover. 3. Disconnect door switch wire harness (2). Remove cover. 4. Attach the tube on t
Summary of the content on the page No. 12
REFRIGERATOR INSTALLATION 2. Replacing Refrigerator Door u u Right Door 1. Lower the door onto middle hinge pin (10). 2. Fit top hinge (8) over hinge lever latch (9) and into place. Insert hinge lever (7) under lever latch. Rotate lever counterclockwise to secure hinge. 3. Install the grounding screw (6) and connect the three wire harnesses (5). 4. Connect door switch wire harness (2). 5. Hook tab on door switch side of cover under edge of wire opening in cabinet top. Position cover (3) into
Summary of the content on the page No. 13
REFRIGERATOR INSTALLATION HOW TO REMOVE AND INSTALL THE 2. Installing Pullout Drawer PULLOUT DRAWER • Pull both rails (1) out to full extension. IMPORTANT: To avoid possible injury, product or property damage, you will need two people to perform the following instructions. 1. Removing Pullout Drawer • Pull the drawer open to full extension. Remove the lower basket (1) by lifting basket from rail system. 1 • Hook the door supports (2) into the rail tabs (3), as illustrated, and lower the door int
Summary of the content on the page No. 14
REFRIGERATOR INSTALLATION 3. Open both doors again and check to make sure that LEVELING AND DOOR ALIGNMENT they close easily. If not, tilt the refrigerator slightly more Leveling to the rear by turning both leveling screws clockwise. It may take several more turns, and you should turn both Your refrigerator has two front leveling screws—one on leveling screws the same amount. the right and one on the left. Adjust screws to alter tilt from front-to-back or side-to-side. If your refrigerator 4. Re
Summary of the content on the page No. 15
USING YOUR REFRIGERATOR ENSURING PROPER AIR CIRCULATION SETTING THE CONTROLS In order to ensure proper temperatures, air must flow • Your refrigerator has a control pad on the dispenser that between the refrigerator and freezer sections. As shown lets you regulate the temperature in the freezer and in the illustration below, air enters at top of freezer and refrigerator compartments. circulates down. From bottom of freezer, air is forced up • Initially set the REFRIGERATOR CONTROL at 37°F to top
Summary of the content on the page No. 16
USING YOUR REFRIGERATOR ADJUSTING CONTROL SETTINGS FOOD STORAGE GUIDE Give the refrigerator time to cool down completely before Wrap or store food in the refrigerator in airtight and making final adjustments. It is best to wait 24 hours moisture-proof material unless otherwise noted. This before doing this. The mid-settings indicated in the prevents food odor and taste transfer throughout the previous section should be correct for normal household refrigerator. For dated products, check date cod
Summary of the content on the page No. 17
USING YOUR REFRIGERATOR STORING FROZEN FOOD REFRIGERATOR SECTION NOTE: For further information about preparing food for WATER DISPENSER freezing or food storage times, check a freezer guide or a reliable cookbook. Push up the dispenser switch with a glass until you hear click to get cold water. Packaging Successful freezing depends on correct packaging. When Dispenser you close and seal the package, it must not allow air or Switch moisture in or out. If it does, you could have food odor and tast
Summary of the content on the page No. 18
USING YOUR REFRIGERATOR REFRIGERATOR SHELVES w CAUTION: Make sure that shelves are level from one side to the other. Failure to do so may result in the The shelves in your refrigerator are adjustable to meet shelf falling or spilling food. your individual storage needs. Your model may have glass or wire shelves. Sliding Out Shelves Storing similar food items together in your refrigerator and adjusting the shelves to fit different heights of items will You can slide glass shelves in and out of yo
Summary of the content on the page No. 19
USING YOUR REFRIGERATOR OPTIBIN CRISPERS u Crispers with rails To remove crisper: 1. Pull drawer out to full extension. 2. Lift the front of basket up and pull straight out. 1 The Optibin Crispers provide fresher-tasting fruit and vegetables by letting you easily control humidity inside the crisper. The Optibin Crispers include: 1) a humidity control knob at the front of the crisper cover and 2) a large lattice on the inner surface of the cover to hold or release moisture. To replace crisper: 1
Summary of the content on the page No. 20
USING YOUR REFRIGERATOR To remove crisper door flap: CRISPER COVER WITH LATTICE ON INNER 1. Raise the door flap as high as it will open. SURFACE 2. Press the plastic hinge toward the center of the door flap with your finger. To remove the lattice on inner surface: 3. Lift the door out of its place. 4. To replace, reverse above procedure. 1. Remove crisper cover (as illustrated above). 2. Hold the glass cover and turn the crisper cover over. 3. For each lattice hold lattice and pull sides of the
